A Pattern Recognition Method of Personalized Adaptive Learning in Online Education

Mobile Networks and Applications - In order to effectively identify the pattern of personalized adaptive learning in online education and improve the recommendation satisfaction of personalized...     

火麻仁油微乳凝胶面膜的制备及初步评价

目的:制备火麻仁油微乳凝胶补水面膜并对其理化性质、保湿性和抗氧化活性进行评价.方法:通过伪三元相图确定火麻仁油微乳最佳处方,采用单因素及正交试验优化火麻仁油微乳凝胶处方,载入保湿活性物质制得火麻仁油微乳凝胶面膜并对其质量、稳定性、保湿性和抗氧化活性进行评价.结果:火麻仁油微乳最佳处方:火麻仁油0.2％、PEG-20氢化蓖麻油0.53％、1,3丙二醇0.27％.火麻仁油微乳凝胶最佳处方为卡波姆-940含量1％,丙三醇含量5％,稀释倍数30倍.制得的微乳凝胶澄清透明、涂展性较好、易清洗、不油腻;平均粒径为(30.91±0.31)nm,PDI为0.299±0.017,电位为(-3.54±0.43)mV;黏度为494725.15 mPa·s;pH值为5.50±0.01;保湿效果优于市售某凝胶面膜;火麻仁油微乳凝胶面膜对DPPH自由基清除率高于火麻仁油毛油,质量浓度为6 mg·mL-1时可达62.39％,IC50为3.71 mg·mL-1.结论:火麻仁油微乳凝胶面膜安全、稳定,制备工艺简单,对皮肤具有良好的补水和抗氧化效果,具备开发和推广的价值.     

Surface Modification of Co3O4 Nanosheets to Promote Peroxymonosulfate Activation for Degradation of Atrazine

Catalysis Letters - This study proposed a new facile route to rational creating oxygen-vacancy (Vo)-rich surface of Co3O4 nanosheets by acetic acid leaching. The acid leached Co3O4 nanosheets was...     

Improving gelling properties of myofibrillar proteins incorporating with cellulose micro/nanofibres

The effects of cellulose microfibres (CMFs, Average size: 100 ± 5 μm) and cellulose nanofibres (CNFs, Average size: 60 ± 3 nm) on the properties of myofibrillar protein (MP) gels from duck breast meat were studied. The results demonstrated that CMFs and CNFs were mostly connected to MP by non-covalent bonds, the diffusion and cross-linking of MP molecules was promoted, and a denser and more complete gel network was formed. With the increases of CMFs and CNFs concentration (0–10%), the hardness was increased by 13.15% and 19.78% for CMFs10% and CNFs10% gels, respectively, and the elasticity was increased by 40% and 80%, respectively. At the same concentration (0–10%), the increase in gel hardness, viscoelasticity and immobilised water content was greater in the CNFs-MP group than in the CMFs-MP group. The CNFs-MP group had a tighter gel network, and CNFs had a better potential to improve the gelation performance of MP.     

Effects of structural parameters on water film properties of transpiring wall reactor

Corrosion and salt deposition problems severely restrict the industrialization of supercritical water oxidation. Transpiring wall reactor can effectively weaken these two problems by a protective water film. In this work, methanol was selected as organic matter, and the influences of vital structural parameters on water film properties and organic matter removal were studied via numerical simulation. The results indicate that higher than 99% of methanol conversion could be obtained and hardly affected by transpiration water layer, transpiring wall porosity and inner diameter. Increasing layer and porosity reduced reactor center temperature, but inner diameter's influence was lower relatively. Water film temperature reduced but coverage rate raised as layer, porosity, and inner diameter increased. Notably, the whole reactor was in supercritical state and coverage rate was only approximately 85% in the case of one layer. Increasing reactor length affected slightly the volume of the upper supercritical zone but enlarged the subcritical zone.