Optimization of gallium nitride-based laser diode through transverse modes analysis

We investigate the transverse mode pattern in GaN quantum-well (QW) laser diode (LD) by numerical calculation.We optimize the current GaN LD structure by varying the n-GaN layer thickness.The n-type GaN layer is an important factor to determine the optical mode.Finally,we discuss the lasing performance of the GaN LD based on the transverse optical modes.     

高亮度白光LED用外延片的新进展

文章首先介绍了发光二极管（LED）的内量子效率、外量子效率的基本概念和提高量子效率的基本方法，接着对LED外延的结构和方法做了简要介绍．文章的第三和第四部分则着重介绍了提高内、外量子效率的外延方法，这些方法包括外延结构的优化，侧向外延生长，SiC和GaN衬底的生长，AIInGaN四元系有源区生长，非极性面、半极性面的外延，表面粗化结构生长，图形化二次外延结构．图形化蓝宝石衬底上的外延，提高载流子注入效率的结构和组分设计．文章的第五部分则介绍了基于可靠性和成本考虑的其他新型外延结构，第六部分介绍了提高LED可靠性的外延方法．最后得出结论：采用非极性面的GaN衬底，生长优化的LED结构，并结合光子晶体技术，可望取得突破性进展．     

Comparative Characterization of InGaN/GaN Multiple Quantum Wells by Transmission Electron Microscopy, X-Ray Diffraction and Rutherford Backscattering

The composition, elastic strain and structural defects of InCaN/CaN multiple quantum wells （MQWs） are comparatively investigated by using x-ray diffraction （XRD）, transmission electron microscopy and Rutherford backscattering/channelling. The InGaN well layers are fully strained on CaN, i.e. the degree of relaxation is zero. The multilayered structure has a clear defined periodic thickness and abrupt interfaces. The In composition is deduced by XRD simulation. We show how the periodic structure, the In composition, the strain status and the crystalline quality of the InGaN/GaN MQ, Ws can be determined and cross-checked by various techniques.     

GaN基p-i-n型雪崩探测器的制备与表征

制备和表征了p-i-n型的GaN基雪崩探测器.器件在-5V下的暗电流约为0.05 nA,-20 V下的暗电流小于0.5 nA.响应增益-偏压曲线显示,可重复的雪崩增益起始于80 V附近,在85 V左右增益达到最大为120,表明所制备的器件具有较好的质量.C-V测量用来确定载流子的分布和耗尽信息,结果显示,P型层在15 ...     

Nonpolar a-plane light-emitting diode with an in-situ SiNx interlayer on r-plane sapphire grown by metal-organic chemical vapour deposition

We report on the growth and fabrication of nonpolar a-plane light emitting diodes with an in-situ SiN_x interlayer grown between the undoped a-plane GaN buffer and Si-doped GaN layer. X-ray diffraction shows that the crystalline quality of the GaN buffer layer is greatly improved with the introduction of the SiN_x interlayer. The electrical properties are also improved. For example, electron mobility and sheet resistance are reduced from high resistance to 31.6 cm²/(V·s) and 460 Ω/口 respectively. Owing to the significant effect of the SiN_x interlayer, a-plane LEDs are realized. Electroluminescence of a nonpolar a-plane light-emitting diode with a wavelength of 488nm is demonstrated. The emission peak remains constant when the injection current increases to over 20 mA.     

Optical and Electronic Properties of InGaN／GaN Multi—Quantum—Wells Near—Ultraviolet Lighting—Emitting—Diodes Grown by Low—Pressure Metalorganic Vapour Phase Epitaxy

The near-ultraviolet lighting-emitting-diodes (UV-LEDs) with the InGaN/GaN multi-quantum-well (MQW) structure were grown by low-pressure metalorganic vapour phase epitaxy. The double crystal x-ray diffraction revealed a distinct second-order satellite peak. The near-ultraviolet InGaN/GaN MQW LEDs have been successfully fabricated to emit at 401.2nm with narrow FWHM of 14.3nm and the forward voltage of 3.6 V at 20 mA injection current at room temperature. With increasing forward current from l 0 mA to 50 mA, the redshift of the peak wavelength was observed due to the band-gap narrowing caused by heat generation.     

采用N2-RF等离子体氮化GaAs(001)

研究了在MBE系统中,GaAs(001)表面的氮化过程。GaAs(001)表面直接和间接地暴露在等离子体激发的N₂气流下。两种氮化过程显示了完全不同的表面氮化结果。在打开N₂发生器挡板的情况下,氮化导致GaAs(001)表面损伤,并且形成多晶结构。当增加N₂气压时,损伤变得更严重。但是,在关闭N₂发生器挡板的情况下,在500℃下,经过氮化将观察到(3×3)再构的RHEED花样,表面仍保持原子级的平整度。上述结果表明,不开N₂发生器挡板,低温(500℃下)氮化将在GaN外延生长之前形成平整的薄层c-GaN。     

金属有机化学气相沉积外延技术生长GaN基半导体发光二极管和激光二极管(Ⅰ)

文章评论性地介绍了金属有机化学气相外延技术（MOCVD）生长氮化物半导体GaN和InGaN以及激子局域化效应、量子束缚斯塔克效应对它们的光学性能的影响，详细比较了这两种效应对GaN基半导体发光二极管和激光二极管特性的影响，特别是量子束缚斯塔克效应以显著不同的方式影响着发光二极管和激光二极管的性能；文章还讨论了在A面蓝宝石衬底上生长GaN的情况．     

纳米MgO催化发光检测硫化氢

研究了硫化氢在纳米Mg O表面的催化发光现象,发现纳米Mg O对硫化氢具有较好的特异性,据此设计了硫化氢催化发光传感器。通过优化设计建立了一种快速检测硫化氢的新方法,线性范围为2.00~200ppm(r=0.999 3),检出限为0.8 ppm(信噪比S/N=3)。采用此传感器进行人工合成样品中硫化氢的加标回收分析,回收率为88.4%~97.2%。此传感器具有灵敏、快速、操作简便等优点,在硫化氢快速检测领域具有潜在应用前景。该文还探讨了硫化氢的催化发光反应机理。     

基于{PMo_(12)O_(40)(VO)_(0.5)}的Cu(Ⅰ)配合物的合成及荧光性质研究

利用磷钼十二酸、偏钒酸铵、CuCl_2·2H_2O和3,3′,5,5′-四甲基-4,4′-联邻二氮杂茂(H_2X)在水热条件下反应,合成出了1个新的多酸基杂化化合物Cu_4(H_2X)_4[(PMo_(12)O_(40)(VO)_(0.5))].通过X射线单晶衍射、红外光谱和热重分析等测试手段对该化合物进行了结构表征.单晶结构解析表明该化合物为2D层状化合物,属于单斜晶系,C2/c空间群,晶胞参数a=2.637 6(5)nm,b=1.542 2(5)nm,c=2.057 0(5)nm,α=90.000(5)°,β=112.677(5)°,γ=90.000(5)°,V=7.720(3)nm~3,Z=4,R_1=0.061 5,wR_2=0.164 6.