Measurements of thermal-neutron capture cross-section of Cesium-135 by applying mass spectrometry

ABSTRACT

The thermal-neutron capture cross-section (σ₀) and resonance integral (I₀) were measured for the ¹³⁵Cs(n,γ)¹³⁶Cs reaction by an activation method and mass spectrometry. Because of difficulty in the preparation of pure ¹³⁵Cs samples, we used ¹³⁵Cs contained as an impurity in a normally available ¹³⁷Cs standard solution. An isotope ratio of ¹³⁵Cs and ¹³⁷Cs in a standard ¹³⁷Cs solution was measured by mass spectrometry to quantify ¹³⁵Cs. Cesium-135 impurity along with the ¹³⁷Cs standard solution was irradiated at the hydraulic conveyer of the research reactor in the Institute for Integral Radiation and Nuclear Science, Kyoto University. Wires of Co/Al and Au/Al alloys were used as neutron monitors to measure thermal-neutron fluxes and epi-thermal Westcott’s indices at an irradiation position. A gadolinium filter was used to measure the σ₀, and a value of 0.133 eV was taken as the cut-off energy. Gamma-ray spectroscopy was used to measure induced activities of ¹³⁷Cs, ¹³⁶Cs and monitor wires. On the basis of Westcott’s convention, the σ₀ and I₀ values were derived as 8.57 ± 0.25 barn, and 45.3 ± 3.2 barn, respectively. The value of σ₀ obtained in the present study agreed within the limits of uncertainties with the past-reported value of 8.3 ± 0.3 barn.     

Fabrication of 0.24Pb(In1/2Nb1/2)O3-0.42Pb(Mg1/3Nb2/3)O3-0.34PbTiO3 transparent ceramics by conventional sintering technique

0.24Pb(In_1/2Nb_1/2)O₃-0.42Pb(Mg_1/3Nb_2/3)O₃-0.34PbTiO₃ transparent ceramics were fabricated by a conventional sintering technique. Through optimization of sintering conditions of calcination and sintering temperatures and time, the obtained ceramics showed high optical transmittance of 53% and 71% at light wavelengths of 1300 and 2000 nm, respectively. The ceramics showed a rhombohedral to tetragonal phase transition at ~120°C and a tetragonal to cubic phase transition at 222°C. These transition temperatures were higher than those of 0.67Pb(Mg_1/3Nb_2/3)-0.33PbTiO₃ ceramics. In addition, the ceramics had a ferroelectric hysteresis loop, a large piezoelectric constant d₃₃ of 407 pC/N, and a planar electromechanical coupling factor k_p of 52%. These results suggest that the transparent ceramics may be used as a temperature-stable, linear electro-optic material.     

Colour-odour correspondences in women during the menstrual cycle: Comparative analysis between the menstrual and ovulation phases

Women might experience modulation in their perception and cognition of colours and odours during the menstrual cycle, but how women's impressions of and correspondence between colours and odours differ according to the cycle changes remains unknown. Here, we experimentally examined women's performance of several tasks, including evaluation of impressions of colours and odours, matching/nonmatching of colours with odours, and identification of odours, comparing two phases: the beginning of menstruation and ovulation. The results showed that participants had similar impressions of colours and odours and made similar colour choices for odours in both the menstrual and ovulation phases, while “pleasant-unpleasant” impressions of colour and odour might vary according to the menstrual cycle. We found no significant differences in odour identification between the phases. The findings imply that hormonal changes during the menstrual cycle might affect “pleasant-unpleasant” impressions of colour and odour but not other features regarding impressions or crossmodal correspondence. In future studies, examination with a large number of participants is necessary.     

Frequency of Upward Lightning Hits to Wind Turbines in Winter

In recent years, frequent damage to wind turbines by winter lightning has been reported in the region along the Sea of Japan. It is a serious finding that lightning hits concentrate on wind turbines in this region. The authors investigated the increase rate of the frequency of lightning hits on wind turbines due to wind turbine construction by using LLS (lightning location system) data. As a result, an experimental formula to estimate the increase rate of the frequency of lightning hits on wind turbines as a function of parameters related to the construction conditions, namely the height of wind turbines, the height above sea level, and the latitude, is proposed.     

Adsorption of amino acids by fullerenes and fullerene nanowhiskers

We have investigated the adsorption of some amino acids and an oligopeptide by fullerene (C₆₀) and fullerene nanowhiskers (FNWs). C₆₀ and FNWs hardly adsorbed amino acids. Most of the amino acids used have a hydrophobic side chain. Ala and Val, with an alkyl chain, were not adsorbed by the C₆₀ or FNWs. Trp, Phe and Pro, with a cyclic structure, were not adsorbed by them either. The aromatic group of C₆₀ did not interact with the side chain. The carboxyl or amino group, with the frame structure of an amino acid, has a positive or negative charge in solution. It is likely that the C₆₀ and FNWs would not prefer the charged carboxyl or amino group. Tri-Ala was adsorbed slightly by the C₆₀ and FNWs. The carboxyl or amino group is not close to the center of the methyl group of Tri-Ala. One of the methyl groups in Tri-Ala would interact with the aromatic structure of the C₆₀ and FNWs. We compared our results with the theoretical interaction of 20 bio-amino acids with C₆₀. The theoretical simulations showed the bonding distance between C₆₀ and an amino acid and the dissociation energy. The dissociation energy was shown to increase in the order, Val < Phe < Pro < Asp < Ala < Trp < Tyr < Arg < Leu. However, the simulation was not consistent with our experimental results. The adsorption of albumin (a protein) by C₆₀ showed the effect on the side chains of Try and Trp. The structure of albumin was changed a little by C₆₀. In our study Try and Tyr were hardly adsorbed by C₆₀ and FNWs. These amino acids did not show a different adsorption behavior compared with other amino acids. The adsorptive behavior of mono-amino acids might be different from that of polypeptides.     

Fabrication and piezoelectric properties of BaTiO3/BaTiO3-Bi(Mg1/2Ti1/2)O3-BiFeO3 composites

We fabricated xBaTiO₃ (BT)/(1-x)[BaTiO₃-Bi(Mg_1/2Ti_1/2)O₃-BiFeO₃] (BT-BMT-BF)?+?0.1?wt%MnCO₃ composites by spark plasma sintering and investigated the effect of BT content x, BT powder size, and BT-BMT-BF composition on piezoelectric properties. For xBT/(1-x)(0.3BT-0.1BMT-0.6BF) +?0.1?wt%MnCO₃ (x?=?0–0.75) composites with a 0.5-µm BT powder, the dielectric constant was increased with x, and the relative density was decreased at x?=?0.67 and 0.75, creating optimum BT content of x?=?0.50 with a piezoelectric constant d₃₃ of 107?pC/N. When a larger 1.5-µm BT powder was utilized for the composite with x?=?0.50, the d₃₃ value increased to 150?pC/N due to the grain size effect of the BT grains. To compensate for a compositional change from the optimum 0.3BT-0.1BMT-0.6BF due to partial diffusion between the BT and 0.3BT-0.1BMT-0.6BF grains, a 0.5BT/0.5(0.275BT-0.1BMT-0.625BF)?+?0.1?wt%MnCO₃ composite with the 1.5-µm BT powder was fabricated. We obtained an increased d₃₃ value of 166?pC/N. These results provided a useful composite design to enhance the piezoelectric properties.     

Adaptation to climate change and conservation of biodiversity using green infrastructure

In recent years, we have experienced mega‐flood disasters in Japan due to climate change. In the last century, we have been building disaster prevention infrastructure (artificial levees and dams, referred to as “grey infrastructure”) to protect human lives and assets from floods, but these hard protective measures will not function against mega‐floods. Moreover, in a drastically depopulating society such as that in Japan, farmland abandonment prevails, and it will be more difficult to maintain grey infrastructure with a limited tax income. In this study, we propose the introduction of green infrastructure (GI) as an adaptation strategy for climate change. If we can use abandoned farmlands as GI, they may function to reduce disaster risks and provide habitats for various organisms that are adapted to wetland environments. First, we present a conceptual framework for disaster prevention using a hybrid of GI and conventional grey infrastructure. In this combination, the fundamental GI, composed of forests and wetlands in the catchment (GI‐1) and additional multilevel GIs such as flood control basins that function when floodwater exceeds the planning level (GI‐2) are introduced. We evaluated the flood attenuation function (GI‐1) of the Kushiro Wetland using a hydrological model and developed a methodology for selecting suitable locations of GI‐2, considering flood risk, biodiversity and the distribution of abandoned farmlands, which represent social and economic costs. The results indicated that the Kushiro Wetland acts as a large natural reservoir that attenuates the hydrological peak discharge during floods and suitable locations for introducing GI‐2 are concentrated in floodplain areas developing in the downstream reaches of large rivers. Finally, we discussed the network structure of GI‐1 as a hub and GI‐2 as a dispersal site for conservation of the Red‐crowned Crane, one of the symbolic species of Japan.     

Graded evolution of anisotropic microstructure during sintering from crystal-oriented powder compact

Anisotropic sintering, including shrinkage and grain growth, was examined for c-axis-oriented (Sr,Ca)₂NaNb₅O₁₅ (SCNN) ceramics, which were prepared by colloidal processing under a magnetic field. In the c-axis-oriented SCNN powder compact, shrinkage and grain growth along the c-axis were higher than those along the a-axis. The anisotropic microstructural development was clearly associated with anisotropic sintering shrinkage. X-ray diffraction, scanning electron microscopy, and energy back scattering diffraction showed that the grain growth of oriented particles by including random grains contribute to the development of the oriented microstructure. Finally, the highly crystal-oriented SCNN ceramics with a densified microstructure were obtained through anisotropic sintering. These results clearly showed the potential to develop a well-defined anisotropic microstructure during sintering by designing and controlling the particle packing structure in a powder compact.     

Asian dust event observed in Seoul, Korea, during 29-31 May 2008: Analysis of transport and vertical distribution of dust particles from lidar and surface measurements

In this study, we investigate the transport of dust particles, its vertical distribution, and the associated meteorological conditions during an Asian dust event that was observed in Seoul, Korea on May 29-31, 2008. This study analyzes data from ground-based and space-borne 2-wavelength polarization lidars, particulate mass concentrations, and synoptic weather data. Surface meteorological station observations of dust phenomena, dust transport model, and weather maps consistently show that the dust particles were transported from the source regions (Inner Mongolia, Man-Ju, and Ordos areas) to Korea via the northeastern part of China. Network observations of the PM₁₀ concentrations in Korea revealed that a majority of the heavy dust particles traveled across South Korea from the northwest to the southeast direction with a horizontal scale of 250-300 km and a traveling speed of approximately 40 km h^− 1. This extraordinary dust event, in terms of its intensity and timing during the year, occurred due to the blockage of an unusually intensified low-pressure system in the northeastern part of China as well as high-pressure system centered over the Sea of Okhotsk and the Kuril Islands. The low values of the particle depolarization ratio (δ₅₃₂) (≤0.05) and color ratio (CR) during the pre-dust period indicate the presence of spherical, non-dust, and relatively small particles. The mean δ₅₃₂ value was approximately 0.123 ± 0.069 between altitudes of ground ~ 2.8 km, and 0.161 ± 0.049 for near-surface dust layer (ground ~ 1.2 km). This value is quite similar to that obtained during the 3-year SNU-Lidar measurements in Seoul (δ₅₃₂ ~0.136 ± 0.027). The value of δ₅₃₂ during the 2nd multilayered dust episode ranged between 0.081 and 0.120 for near-surface dust layers, and between 0.076 and 0.114 for elevated dust layers. The CALIPSO measurements of β₅₃₂, δ₅₃₂, and CR also revealed the presence of dense dust aerosols along the transport route.     

天津以及周边近代化遗产的思考

小序2006年9月我们从日本来到天津大学任教,我们在天津工作的主要目标是:(1)成立文化遗产的保护研究中心;(2)参与中国的文化遗产保护研究和规划设计;(3)从事文化遗产学的教学。我们关注传统建筑的保护研究,同时也深感近代遗产研究是一个薄弱环节。