Development of silicon wafer packaging technology for deep UV LED

This paper reports a deep‐ultraviolet LED (deep‐UV‐LED) package based on silicon MEMS process technology (Si‐PKG). The package consists of a cavity formed by silicon crystalline anisotropic etching, through‐silicon vias (TSVs) filled with electroplated Cu, bonding metals made of electroplated Ni/AuSn and a quartz lid for hermetic sealing. A deep‐UV LED die is directly mounted in the Si‐PKG by AuSn eutectic bonding without a submount. It has advantages in terms of size, heat dissipation, light utilization efficiency, productivity and cost over conventional AlN ceramic packages. We confirmed a light output of 30 mW and effective reflection on Si (111) cavity slopes in the Si‐PKG. Based on simulation, further improvement of the optical output is expected by optimizing DUV‐LED die mount condition.     

Chemical‐Free Approach for Z‐Isomerization of Lycopene in Tomato Powder: Hot Air and Superheated Steam Heating above the Melting Point of Lycopene

Z‐isomers of lycopene exhibit higher bioavailability and antioxidant capacity than those of the all‐E‐isomer. Therefore, it is important to develop an efficient and environmentally friendly procedure for Z‐isomerization. The current methods for Z‐isomerization of (all‐E)‐lycopene use toxic chemicals such as organic solvents and catalysts. This study is aimed to develop a chemical‐free method for Z‐isomerization of (all‐E)‐lycopene in tomato powder by hot air and superheated steam heating. The Z‐isomerization reaction is promoted by heating above the melting point of lycopene. When heated with superheated steam, the thermal decomposition of lycopene is suppressed compared to that when heated with hot air. When tomato powder is heated at 240 °C for 5 min by superheated steam, the total Z‐isomer content and remaining lycopene are 69.0% and 90.7%, respectively, while with hot air heating, the total Z‐isomer content and remaining lycopene are 69.9% and 68.0%, respectively. These results indicate that the thermal Z‐isomerization of lycopene occurs in the molten state and heating in a low oxygen atmosphere suppresses the thermal decomposition of lycopene. Practical Applications: Tomato powder rich in lycopene Z‐isomers is an important ingredient for the food and animal feed industries. Since Z‐isomers of lycopene are more soluble in solvents including ethanol which is a low‐toxicity and environmentally friendly solvent, the efficiency of lycopene extraction with ethanol can be improved by using the Z‐isomer‐rich tomato powder as a raw material. The obtained Z‐isomer‐rich extract has a high added value because the Z‐isomers have higher bioavailability and antioxidant capacity than those of the all‐E‐isomer. In addition, since lycopene Z‐isomers exhibit higher accumulation efficiency and better color improvement in hen egg yolks than those of the all‐E‐isomer, Z‐isomer‐rich tomato powder is an effective animal feed.     

Reduction of Ripple Current Loss by Electromagnetic Coupling of Air‐Core Reactors

To reduce the loss due to ripple current in a multiphase current‐reversible chopper, we investigated electromagnetic coupling of an air‐core reactor. We derived the relationship between the amplitude of the ripple current, the duty factor, and the electromagnetic coupling coefficient, and used the results to estimate the effects of electromagnetic coupling in the design of a train energy storage system. We built reactors with electromagnetic coupling coefficients of 0.93 and 0.60. These reactors employed a new winding structure that provides an optimal electromagnetic coupling coefficient. The mass of the former type of reactor was increased by 4.4% over the conventional design, and that of the latter type of reactor was decreased by 17%. Finally, we tested the new reactors. When the chopper employs the former type of reactor and operates with equal‐phase switching and cumulative coupling, the loss due to ripple current is decreased by 11%. When the chopper employs the latter type of reactor and operates with shift‐phase switching and differential coupling, the loss is decreased to 31%. The test showed that the calculated relationships agreed with the measured values.     

Probabilistic Strength at Serviceability Limit State for Normal and SBHS Slender Stiffened Plates Under Uniaxial Compression

International Journal of Steel Structures - Stiffened plates with high slenderness parameters show large out-of-plane deflections, due to elastic buckling, which may occur before the plates reach...     

Modeling thermal behaviors of window flame ejected from a fire compartment

A series of reduced-scale experiments were carried out in order to investigate thermal behaviors of window flame, which exposes the upper floors as well as the adjacent buildings to potential risks of fire spread. A stainless pan filled with alcohol was used as the fire source and was placed inside a cubic compartment of 900 mm side. Temperatures and velocities at various points inside and outside of the compartment were measured. The compartment was pressurized during the experiment by mechanically supplying air at several mass inflow rates through an inlet duct set at the bottom part of the compartment. This was for simulating fire conditions under the effect of external wind pressure. On the basis of the experimental observation, line (i.e., two-dimensional) heat source assumption was adopted for developing a model of window flame behavior. A dimensionless parameter Q^′*${Q^{\prime }}^{*}$ was derived from the governing differential equations in order to generalize the measurement results. Expressions for temperature rise along the trajectory ΔT_m and characteristic flame width b_T were developed incorporating the parameter Q^′*${Q^{\prime }}^{*}$.     

Spring bloom in a hypereutrophic lake, lake Kasumigaura, Japan—II Succession of phytoplankton species

Numerous phytoplankton species in Lake Kasumigaura were shown to comprise the Spring bloom in 1980. The predominant phytoplankton species that appeared during the Spring bloom belonged to 28 genera. A few species among them increased at any time to form a phytoplankton pulse, but the few species of phytoplankters that comprised a phytoplankton pulse did not exclude completely other phytoplankters. During the Spring bloom, one pulse was replaced by another pulse composed of a new grouping of different species. Throughout these replacements by natural selection in the bloom were numerous other species by phytoplankters at levels of abundance somewhat less than those which formed phytoplankton pulse.     

Prediction of brittle fracture initiating at ends of CJP groove welded joints with defects: study into applicability of failure assessment diagram approach

A series of tests, which reproduced brittle fracture starting from the region around the terminations of complete joint penetration groove welded joints, was conducted. The joint models under study represented a portion of welded beam flange-to-through diaphragm joints in beam-to-column connections. Various artificial weld defects were installed in the welded joints prior to testing. Test results were evaluated based on the failure assessment diagram approach specified in BS 7910. The conventional failure assessment diagrams predicted occurrences of brittle fracture erring on the very conservative side as expected, especially when applied to surface defects. The failure assessment diagram approach was modified by considering the effect of enhanced apparent toughness of material due to the loss of crack tip constraint. The modified failure assessment approach was found to predict the test results well.     

Identification and Characterization of D‐Succinylase,and a Proposed Enzymatic Method for D‐Amino Acid Synthesis

Chiral amino acids are important intermediates for the pharmaceutical industry. We have developed a novel one‐pot enzymatic method for D ‐amino acid synthesis by the dynamic kinetic resolution of N‐succinyl‐dl ‐amino acids using D ‐succinylase (DSA) and N‐succinylamino acid racemase (NSAR, EC 4.2.1.113). The DSA from Cupriavidus sp. P4‐10‐C, which hydrolyzes N‐succinyl‐D ‐amino acids enantioselectively to their corresponding D ‐amino acids, was identified for the first time by screening soil microorganisms. Subsequently, the DSA gene was cloned and overexpressed in Escherichia coli. DSA was shown to comprise two subunits with molecular masses of 26 kDa and 60 kDa. Additionally, the NSAR gene from Geobacillus stearothermphilus NCA1503, which racemizes N‐succinylamino acids, was also cloned and overexpressed in E. coli. The highly purified DSA and NSAR prepared from each recombinant E. coli were characterized and used for D ‐amino acid synthesis. A one‐pot enzymatic method converted 100 mM N‐succinyl‐dl ‐phenylalanine to D ‐phenylalanine in 91.1% conversion with 86.7% ee. This novel enzymatic method may be useful for the industrial production of many D ‐amino acids.