Densities and Viscosities of Oleic Acid at Atmospheric Pressure

The densities of oleic acid were measured over the temperature range from (293 to 459) K at atmospheric pressure using a densimeter based on the modified hydrostatic weighing method. The dynamic viscosities of the same oleic acid sample were measured using a capillary viscometer (VPZ-2 m) in the range from (293 to 363) K at atmospheric pressure. The combined expanded uncertainty of the density, atmospheric pressure, viscosity, and temperature measurements at the 95% confidence level with a coverage factor of k = 2 is estimated to be 0.15%, 1.0%, 3.5%, and 15 mK, respectively. The values of uncertainty for density and viscosity include the effects of purity and calibration (total expanded uncertainty). These experimental data were used to develop wide-range correlations for the density and viscosity based on theoretically confirmed Arrhenius–Andrade and Vogel-Tamman-Fulcher (VTF) models. The value of the glass temperature ( T _g= 179.78 K.) for the oleic acid was estimated using the VTF parameters derived from the present viscosity measurements. To additionally validate the reliability of the measured density data, the same oleic acid samples were measured using the pycnometric method. The present study showed that the densities measured using the modified hydrostatic weighing densimeter (HWD) agree with the values obtained using the pycnometric method within 0.09% for Sample 1 and 0.25% for Sample 2.     

Structural Changes Induced in Nonstoichiometric Titanium Carbide by High-Temperature Deformation

The microstructure evolution in nonstoichiometric titanium carbide is studied during high-temperature deformation at high strain rates and low strains (shock compression) and at slow strain rates and high strains (superplastic regime). The results demonstrate that high-temperature deformation in a broad range of strain rates offers a means of controlling the microstructure of titanium carbide. By varying deformation conditions, one can obtain materials differing in microstructure and chemical composition, in particular, with equilibrium and nonequilibrium microstructures. Accordingly, the physicochemical properties of such materials also differ.     

An Experimental Investigation of the Coagulation of Aerosol in a Tube in the Vicinity of Subharmonic Resonance

Nonlinear oscillation of aerosol in the vicinity of a resonance frequency that is twice lower than the first eigenfrequency (subharmonic resonance) is experimentally investigated in tubes with different conditions at the ends. The time dependence of the number density of aerosol droplets is determined, and the effect of the frequency and intensity of oscillation on the process of coagulation of droplets is studied. The nonmonotonic pattern of the dependence of the time of coagulation of aerosol droplets on the frequency of excitation with a minimal value at resonance is found. Ordered space-time structures (alternation of denser and looser regions of aerosol) are revealed in the visible region in the vicinity of the middle of a closed tube.     

Effect of ionizing radiation on the extraction of Am(III) with <Emphasis Type="Italic">p-tert</Emphasis>-butylthiacalix[4]arene from alkaline carbonate solutions

The effect of γ-irradiation of tert-butylthiacalix[4]arene (TCA) solutions in m-nitrobenzotrifluoride (NBTF) and tetrachloroethylene (TCE) on the extraction of ²⁴¹Am from alkaline carbonate solutions was studied. TCA itself remains stable upon γ-irradiation of its solutions in NBTF to a dose of 200 kGy, but the diluent undergoes strong degradation. The radiation resistance of TCA in TCE is considerably lower: A dose of 70 kGy causes complete degradation of TCA. In the TCA–TCE–aqueous phase system, sulfate ions appear upon γ-irradiation as the final product of the extractant radiolysis. A large number of γ-radiolysis products of TCE and TCA were detected by HPLC and GCMS. The products of radiolysis of TCA in TCE, compared to the initial extractant, have lower molecular mass and higher polarity. The results show that chlorinated diluents are not promising diluents for thiacalixarene in extraction processing of alkaline high-level waste.     

Experimental study of aerosol oscillations in an open tube in the shock-free wave mode

Forced longitudinal oscillations of a finely dispersed aerosol in an open tube in the shock-free wave mode near the first fundamental frequency have been studied experimentally. The time dependences of the numerical concentration of the aerosol droplets have been obtained. The effect of the frequency and amplitudes of the excitation on the aerosol clearing, which consists of coagulation, sedimentation on the tube walls, and partial ejection of the aerosol droplets from the open end of the tube, has been studied. It has been shown that the process of aerosol clearing occurs 6–12 times more efficiently than natural sedimentation.     

Supercritical fluid CO<Subscript>2</Subscript>-extraction regeneration of nickel–molybdenum catalyst for hydrotreatment

Results from studying the supercritical fluid СО₂-extraction regeneration of DN-3531 industrial nickel–molybdenum hydrotreatment catalyst in the temperature range of 323.15–383.15 K, at pressures of up to 30 MPa, and with modification of the basic extragent with such polar compounds as chloroform, methanol, ethanol, acetone, and dimethylsulfoxide (DMSO), are presented. The order of modifiers corresponds to the increase in the solubilizing ability of modified supercritical carbon dioxide (SC-СО₂) with respect to catalyst- deactivating deposits. With DMSO as the most efficient modifier, however, not only are deactivating compounds removed but nickel and molybdenum as well, considerably reducing the final activity of a regenerated sample. During extraction regeneration, the content of coke in the catalyst is reduced by two-thirds, while the specific surface area and the pore volume grow. The activity of the deactivated catalyst in dibenzothiophene hydrodesulfurization (HDS) and naphthalene hydrogenation grows by several hundred per cent after one-time SC-CO₂ treatment and is 2.5 times higher than for a sample regenerated using the traditional oxidative method.     

Flexible water-cooled inductor for local heating

Translated from Khimicheskoe i Neftyanoe Mashinostroenie, No. 7, pp. 30–31, July, 1990.     

Thermal Properties of n-Hexane at Temperatures of 298.15–363.5 K and Pressures of 0.098–147 MPa

The thermal-expansion coefficient and isobaric heat capacity c _p of n-hexane at 298.15–363.5 K and 0.098–147 MPa are measured by flux calorimetry. Observed and calculated c _p data are compared, and a general equation for determining c _p is suggested.