济阳坳陷下古生界潜山油气藏特征及成藏模式

济阳坳陷下古生界潜山具有多样性、复杂性的特点，潜山差异性的形成演化、油气成藏主控因素和控藏模式不明确，严重制约了该区潜山油气勘探。在潜山分类的基础上，综合利用系统恢复、分类对比和典型解剖等方法，揭示了济阳坳陷下古生界不同类型潜山的形成演化过程和油气成藏主控因素差异性，分类建立了油气成藏模式。研究表明，济阳坳陷下古生界主要发育高位新盖侵蚀残丘潜山、中位古盖拉张断块潜山、中位新古盖拉张剪切断块潜山、中位中古盖挤压拉张断块潜山和低位古盖拉张滑脱断块潜山5种潜山类型。不同类型潜山的形成演化和油气成藏各具特色，其中，高位新盖侵蚀残丘潜山的发育受隆升、侵蚀作用控制，油气成藏主要受控于油源和盖层条件，表现为"单向供烃、砂体-不整合岩溶体联合输导、残丘控藏"的成藏模式；中位古盖拉张断块潜山的发育受掀斜、断裂作用控制，油气成藏主要受控于储集条件，表现为"单向供烃、顺向断层输导、反向断层控藏"的成藏模式；中位新古盖拉张剪切断块潜山的发育受反转、翘倾和走滑切割作用控制，油气成藏主要受控于输导条件，表现为"多源供烃、断溶体立体输导、断裂控藏"的成藏模式；中位中古盖挤压拉张断块潜山的形成受强烈挤压、拉张滑脱作用控制，油气成藏主要受控于储集条件，表现为"多源供烃、断缝体输导、断褶控藏"的成藏模式；低位古盖拉张滑脱断块潜山的形成受强烈拉张滑脱作用控制，油气成藏主要受控于输导条件，表现为"顶部供烃、断缝体输导、断裂控藏"的成藏模式。     

高速率通信网络下时变系统的有限时域H∞控制

针对高速率通信网络和Round-Robin（RR）协议影响下网络化时变系统的有限时域[H∞]控制问题，考虑到系统中存在乘性噪声、随机时滞和量化效应，提出了一种基于观测器的有限时域[H∞]控制器的设计方法。利用李雅普诺夫稳定性理论和线性矩阵不等式（Linear Matrix Inequality，LMI）技术得到有限时域[H∞]控制器存在的充分条件。基于锥补线性化（Cone Complementarity Linearization，CCL）方法通过求解一组递归矩阵不等式得到观测器和控制器参数。所设计的控制器保证闭环网络化时变系统在给定的时域内稳定，且满足预定的[H∞]性能指标。数值仿真验证了所提方法的有效性。     

A numerical study on the performance of PEMFC with wedge-shaped fins in the cathode channel

The gas flow field design has a significant influence on the overall performance of a proton exchange membrane fuel cell (PEMFC). A single-channel PEMFC with wedge-shaped fins in the cathode channel was proposed, and the effects of fin parameters such as volume (0.5 mm³, 1.0 mm³, and 1.5 mm³), number (3, 5, and 9), and porosity of the gas diffusion layer (GDL) (0.2, 0.4, 0.6, and 0.8) on the performance of PEMFC were numerically examined based on the growth rate of power density (GRPD) and polarization curve. It was shown that wedge-shaped fins could effectively improve the PEMFC performance. With an increase in fin volume, the distributions of oxygen mass fraction in the outlet area of the cathode channel were lower, the drainage effect of the PEMFC improved, and GRPD also increased accordingly. Similar results were obtained as the number of fins increased. The GDL porosity had a greater effect than the wedge-shaped fins on the improvement in PEMFC performance, but the influence of GDL porosity weakened and the GRPD of porosity decreased as the porosity increased. This study provides an effective guideline for the optimization of the cathode channel in a PEMFC.     

锤击法在消除熔丝积材残余应力中的研究进展

锤击法在熔丝积材残余应力消除中具有非常重要的研究价值和学术意义。近年来该方法日趋完善,现已成为消除熔丝积材残余应力的重要方法之一。本文概括综述了消除残余应力的方法,并着重分析了锤击法消除残余应力的国内外研究现状和最新进展。希望能给相关工作者提供参考。     

掺铒单模光纤飞秒脉冲激光器和放大器

为了获得一种被动锁模掺铒光纤振荡器及功率放大器，数值模拟出超短脉冲在光纤中的传输和演化过程，并基于此搭建了一种被动锁模掺铒光纤飞秒振荡器及功率放大器。实验获得了中心波长1560 nm、重复频率100 MHz、输出功率30 mW、脉冲宽度85 fs超短脉冲。通过采用PPLN晶体进行倍频，进一步获得了输出功率5 mW，中心波长780 nm的飞秒脉冲。该光纤激光器为全保偏光纤结构，具有体积小巧、可靠性高、稳定性好的特点。     

A Restart Control Method for Position Sensorless PMSM Drive Systems Without Potential Transformer for Railway Vehicle Traction

This paper proposes a restart control method for position sensorless PMSM drive systems without a potential transformer for railway vehicle traction. This method can estimate the initial rotor speed and position under coasting conditions over the entire speed range. The method can also be used when the back‐EMF voltage is higher than the inverter DC link voltage. The proposed method is verified by experiments using a 200‐kW PMSM.