Wire electrical discharge machinable SiC with GNPs and GO as the electrically conducting filler

SiC based composites filled with graphene nano-platelets (GNPs) or graphene oxide (GO) prepared by rapid hot-pressing exhibit sufficient electrical conductivity for their machinability by wire electro-discharge machining (WEDM). Composites microstructure anisotropy caused by graphene alignment as a consequence of rapid hot pressing was confirmed by measuring of electrical conductivity and thermal diffusivity. Electrical conductivity increased significantly with increased weight fraction of graphene in both measured directions. Highest value of 2031 S/m was obtained for composites with 15 wt. % of GNPs in parallel direction and only 1246 S/m in perpendicular direction to aligned GNPs. Thermal diffusivity is 63.3 mm²/s in parallel and only 23.3 mm²/s in perpendicular direction. The increase of the electrical conductivity has resulted in successful WEDM. The MRR was almost doubled when the filler concentration increased from 5 wt. % GNPs/GO to 15 wt. % GNPs. At the same time, the surface roughness decreased.     

Correction to: Optimization of Parameters for Maximum Tensile Strength of Friction Stir Welded AA6082/Si3N4 and AA6082/SiC Composite Joints

Silicon - The original version of this paper was unfortunately published with an error in the order of authors and their corresponding affiliations. The correct data is shown above.     

Sensitivity Optimization of MEMS Based Piezoresistive Pressure Sensor for Harsh Environment

Silicon - Silicon carbide piezoresistive pressure sensor is more suitable for harsh environment due to its wide bandgap, corrosion tolerance, excellent chemical inertness, high Young’s...     

Enhanced upconversion study of Er3+-Yb3+ codoped NaYF4 phosphors synthesized by the reverse microemulsion method

Herein, nanocrystals of Er³⁺ and Er³⁺, Yb³⁺ co-doped NaYF₄ upconversion (UC) phosphor were prepared via the reverse-microemulsion method. The impact of different concentrations of Er³⁺ ions on the UC emission intensity after 980?nm diode laser excitation is discussed. The structure, morphology and composition of the nanophosphors were confirmed by X-ray diffraction, transmission electron microscopy, scanning electron microscopy and the results showed the presence of NaYF₄ nanocrystals with hexagonal phases of NaYF₄. The UC spectra revealed two emission bands including a green and a red emission band and the CIE coordinate for the samples were estimated. The present research revealed that the reverse-microemulsion approach will be suitable for the synthesis of efficient upconversion nanophosphors.     

Sol- gel synthesis of Ga2O3 nanorods and effect of precursor chemistry on their structural and morphological properties

Synthesis of mono-crystalline Ga₂O₃ Nanorods was done by sol-gel transformation of gallium(III) isopropoxide (Ga(OPrⁱ)₃). XRD studies were done to determine the planes and crystal structure of synthesized nanorods that showed the synthesis of β-Ga₂O₃(a). TEM studies of synthesized Ga₂O₃ confirmed the synthesis of monocrystalline β-Ga₂O₃ nanorods. To study the effect of precursor chemistry and to determine role of precursor structures on the crystal structure, phase and morphology of the Ga₂O₃, a new modified precursor complex was synthesized. The reaction of Ga(OPrⁱ)₃ with N-phenylsalicylaldimine, [C₆H₄(OH)CH=N(C₆H₅)] in 1:1?M ratio yielded [{(H₅C₆)N?=?CH-C₆H₄O}Ga(OPrⁱ)₂]. The newly synthesized complex was characterized by elemental analyses, molecular weight measurement, FT-IR and NMR (¹H and ¹³C) spectral studies. Spectral studies of the modified complex suggest the presence of bi-dentate mode of attachment of Schiff's base in the solution state. Sol-gel transformations of [{(H₅C₆)N?=?CH-C₆H₄O}Ga(OPrⁱ)₂] in organic medium, yielded γ-Ga₂O₃(b), as found by XRD studies. TEM image of the sample (a) revealed the formation of nano-rods of oxide with average diameter of ~100?nm whereas the TEM image of sample (b) showed presence of nano-sized particles of oxide with average particle size of 10?nm. Morphological and compositional studies of synthesized samples (a) and (b) were carried out using SEM and EDX. The method provides a possibility of large scale synthesis of dissimilar shaped and pure Ga₂O₃ nanoparticles.     

Deep Learning based Early Prediction Scheme for Breast Cancer

Wireless Personal Communications - Breast cancer is one of the rapid spreading diseases resulting in the death of younger age group of women. Unfortunately, as the detection of cancer is at later...