MOF衍生的高选择性加氢芳香硝基化合物的石墨碳包覆镍催化剂

针对芳香硝基化合物的催化选择性加氢反应，开发可替代贵金属催化剂的低成本、高效非贵金属催化剂，对于芳香胺类化合物的绿色生产具有重要意义。利用简易、可规模化的制备方法，以镍—2,5-吡啶二羧酸金属有机框架为前驱体，热解制备了氮掺杂石墨碳包覆镍纳米催化材料（Ni@CN）。采用X射线衍射、扫描电镜、透射电镜、元素分析、N2吸脱附等检测手段对Ni@CN的物化性质进行了表征，并对其催化性能进行了评价。结果表明，Ni@CN可在温和条件下（85℃，1.0 MPa H2)高效加氢含取代官能团的芳香硝基化合物生成对应的芳香胺类化合物。对比试验表明，镍纳米颗粒是Ni@CN的加氢活性中心，而石墨碳壳的存在有利于优先吸附硝基官能团。此外，进一步考察了Ni@CN的循环使用性能以及抗硫化物中毒的特性。     

Magnetic and Electrical Properties of Glass and Glass-Ceramics Based on Weathered Basalt

Silicon - A total of six glass batches (WB100-WB50) based primarily on weathered basalt with successive addition of bypass cement dust (with the weight content 0–50%) were melted at...     

Combination of heat treatment and chitosan coating to improve postharvest quality of wolfberry (Lycium barbarum)

The synergistic application of hot water dip at 42 °C for 30 min and 1% chitosan coating on differentiation in postharvest quality traits, microstructure as well as microbiological evolution of wolfberry fruits was investigated. Fresh wolfberry fruits were stored at 2 ± 0.5 °C and 90% relative humidity (RH) for 28 days. Results indicated the combination of prestorage heat treatment and chitosan coating maintained higher levels of ascorbic acid, total phenolic contents and antioxidant capacity as well as lower decay, compared with untreated wolfberry fruits. The possible mechanism was that the heat treatment almost sealed open stomata to limit the sites of pathogen penetration into fruits independently, followed by the biofilm formed by chitosan which controlled secondary infections as well as slowed changes in fruit respiration and metabolic activity in wolfberries. The synergistically treated fruit also exhibited a higher acceptability obtained by sensory analysis after cold storage. In this sense, the integrated application of heat treatment and chitosan coating could be regarded as an effective strategy to extend storage life and maintain the postharvest quality of wolfberry fruits.     

餐饮废油生物柴油低温流动性的改进研究

使用气-质联用仪测定餐饮废油生物柴油(WCME)和-10号柴油(-10PD)的组成,使用冷滤点试验器和运动黏度试验器测定WCME的低温流动性,同时使用调合、添加低温流动性改进剂的方法改进WCME的低温流动性。实验结果表明,WCME主要由饱和脂肪酸甲酯和不饱和脂肪酸甲酯组成,质量分数分别为27.63%和71.81%;WCME冷滤点为0℃,运动黏度(40℃)为4.41mm2/s;WCME与-10PD调合后,冷滤点降低,其中B20的冷滤点最低,为-13℃,运动黏度随着WCME的体积分数的减少,逐渐接近-10PD的运动黏度。通过添加低温流动性改进剂,WCME,B10,B20的冷滤点分别从0,-8,-13℃降至-4,-26,-25℃。     

原子吸收光谱法测定保护渣中锰含量

采用原子吸收光谱法测定保护渣中锰含量,进行了酸度对测定的影响、试样分解、共存离子干扰、加标回收、精密度分析等试验。结果表明,锰可完全溶解于混合酸溶液中;加入氯化锶,可以消除钠、钙对锰测定的干扰;锰质量浓度在0~12.0μg/mL的范围,工作曲线线性关系良好;加标回收率较高,在97%~102%;测定结果准确度较高,与高碘酸钠光度法分析结果一致性较好。     

A new perspective of co-doping and Nd segregation effect on proton stability and transportation in Y and Nd co-doped BaCeO3

Bulk and surface properties of proton stability and transportation in Y and Nd co-doped BaCeO₃ (BCYN), especially the effect of Nd segregation, were investigated by first-principles calculations. Since the structure of doped BaCeO₃ at the operating temperature of proton-conducting has been unclear for a long time, we have summarized the latest experimental results and calculated the structure of the asymmetric BCYN for the first time. The results show that compared with Y, Nd doping promotes oxygen vacancy formation, however reduces proton stability. Our calculation can also provide a possible explanation for the formation of space charge layer at the grain boundary of doped BaCeO₃ in experiment. Unlike the stable Y in BCYN, Nd is calculated to be easily segregated, which can facilitate both proton hydration and proton transportation near the surface. Moreover, Nd segregation at the grain boundary is predicted to be beneficial for proton transportation between grains.     

电石冷却车间厂房通风模型的研究及应用

介绍了厂房通风模型在电石冷却车间改造中的应用,对比分析了改造前后冷却车间内的通风状态.模拟结果表明,冷却车间厂房内的总通风量增加了99.4％,通风温度降低了20.5 ℃,厂房结构和设备表面温度降低了50℃,能有效解决冷却车间内通风温度偏高的问题,提高电石转运率.根据通风模型进行改造后,电石冷却时间缩短25％,证明厂房通风模型准确可靠.     

基于分段加权的反向稀疏跟踪算法研究

为提高稀疏表示跟踪模型性能，提出一种分段加权的反向稀疏跟踪算法，将跟踪问题转化为在贝叶斯框架下寻找概率最高的候选对象问题，构造不同的分段权重函数来分别度量候选目标与正负模板的判别特征系数。通过池化来降低跟踪结果的不确定性干扰，选择正负模板加权系数差值最大的候选表示作为跟踪结果。实验表明，在光照变化、遮挡、快速运动、运动模糊情况下，所提出的算法可以确保跟踪结果的准确性和鲁棒性。