厌氧发酵处理味精废水中氯离子的影响

在3L 的CSTR 型厌氧反应器中研究了味精废水厌氧处理中氯离子毒性的反应。试验证明,已中毒的厌氧过程只要Cl~-浓度降至抑制限以下,厌氧过程就可在15～20d 内恢复,在恢复期间加入新污泥有利于恢复过程。保持足够大的SRT 和污泥浓度对于处理含有毒物的废水很有效。对本研究,SRT 得大于20d,污泥浓度在15～24g/L 左右就可达到较好的处理效率。Cl~-的抑制浓度对污泥浓度分别为24.28g/L,15.18g/L 和6.07g/L 时,Cl~-的抑制浓度分别是7750mg/L,7250mg/L和6300mg/L。此外,本文提出以I=S_(Cl)/X_v~n作为判断Cl~-抑制的指标。当COD 去除率大于80%时,n=0.1519。因此,要使过程的COD 去除率分别大于80%,85%和90%时,I 就得分别小于4.7,4.1和3.6。并且污泥浓度必须大于6.07g/L。     

抛秧稻田杂草发生与化除技术研究初报

抛秧田杂草不但种类多，危害重，而且化除难度大，技术要求高，据１９９３－１９９５年的试验、示范结果证明，一般草害田，掌握在抛栽后１０－１５天，每公顷用５０％二氯喹啉酸３７５－４５０克加１０％苄嘧黄隆１５０－２２５克，采用喷雾或毒土法防治一次，对稗草和多种阔叶草的防效一般可稳定在９０－９３％左右，并且可使亩产增加２成左右，但多草田和漏水田，则应通过二次用药或提高药剂用量的方法加以解决。     

复合材料夹层结构产品固化变形分析

本文讨论产生复合材料产品固化变形的主要原因是树脂收缩引起的各方向上不同的线膨胀系数具体分析了复合材料夹层结构的的固化变形，经技术上的改进解决了固化变形，以满足产品的设计要求。     

碱土金属在萃取剂与树脂间反应平衡常数的测定

研究了碱土金属离子在Ｄ００１树脂与８－羟基喹啉三氯甲烷溶液间的平衡常数Ｏ－ｔＫ的测定。其值依Ｍｇ、Ｃａ、Ｓｒ、Ｂａ次序减小。并得出萃取剂浓度［ＨＡ］。与金属离子在两相分配的关系。     

A Flood Forecasting Model that Considers the Impact of Hydraulic Projects by the Simulations of the Aggregate reservoir’s Retaining and Discharging

The hydraulic projects, such as reservoirs, ponds, and paddy fields, have a marked influence on the generation of floods, causing a number of difficulties where hydrological forecasting is concerned. To consider the influence of the hydraulic projects in hydrological forecasting, a modified TOPMODEL is presented in the paper, based on the simulation rules of the aggregate reservoir’s retaining and discharging (ARRD). In the new purposed model, termed as ARRD-TOPMODEL, the hydraulic projects are first aggregated as an equivalent reservoir, then the simulation rules of the aggregate reservoir’s retaining and discharging are determined, finally, the simulation rules are combined with an original TOPMODEL model calibrated using the floods not influenced by the hydraulic projects for flood forecasting. The ARRD-TOPMODEL was tested on the upstream of Wudaogou station basin in Northeast China. The results show that compared to the original model, the qualified rate (i.e., the ratio of the number of floods that meet acceptable criteria and the total number of floods) of runoff forecasting was increased from 73% to 100%. The problems that the overestimation of the runoff at beginning of flood season and after a long drought, as well as that the underestimation of the large flood in middle flood season are both solved, and the flood processes predicted by the new model are more consistent with the observed ones. All of these demonstrate that the newly developed model is superior to the original one and the simulation rules of the aggregate reservoir’s retaining and discharging are capable of accurately accounting for the influence of the hydraulic projects on the floods.     

Water Bloom Precursor Analysis Based on Two Direction S-Rough Set

In the field of water quality management, it is vital to determine the main precursory anomalies from the precursor of intricate water bloom in the context of a given area. In this paper, a water bloom precursor analysis method, based on two direction singular rough set, was proposed. This approach was produced on the basis of the different sections and pre-water bloom of water bloom precursor anomalies and characteristic of elements transferred in singular rough set. For testing the validity of two direction singular rough set application in water bloom precursor analysis, Xiangxi River, which is one of the typical tributaries of Three Gorges Reservoir in China, was selected as study area. The result showed that compared with other indexes, pH and dissolved oxygen (DO) are the most valuable indicators of water bloom in the precursory anomalies. Furthermore, regarding with water bloom precursory anomalies in Xiangxi River, most of the nutrient loading and biological community are the key indicators. Hence, this method can determine the main precursory anomaly for water bloom in the study area, which provides powerful knowledge support to water quality specialists for them to comprehensively analyze precursory anomaly so as to find out its relationship with occurrence law of water bloom.     

Analysis of the Spatial Characteristics of the Water Usage Patterns Based on ESDA-GIS: An Example of Hubei Province,China

The spatial characteristics and the high-duty water regions of the Water Usage Patterns (WUP) are very important for the allocation and management of water resources. Taken Hubei province, China as an example, we adopted the exploratory spatial data analysis (ESDA) method to investigate the spatial dependence and local patterns of the WUP from 2003 to 2012. Subsequently, the spatial variation mechanisms were analyzed through the gravity center model. The results indicated that the overall spatial dependence of the agricultural WUP was detected (more significant after 2008). Moreover, the global spatial autocorrelation analysis results on the domestic WUP showed statistical significance (Moran’s I?>?0.1, P?<?0.05). These indicated that the local patterns were presented. The high values clustering areas of the agricultural and domestic WUP were mainly distributed in the central province and in the western province respectively. However, the approximate random distribution was identified for the industrial WUP because the industrial development had been conducted widely in the whole province during these years. Furthermore, the governmental policies and natural environment contributed to the spatial evolution tendency of the WUP. An increasing trend of the spatial association of the agricultural WUP and a significant decreasing trend of that of the domestic WUP, which suggested that the natural circumstance superiority and the industrial structure adjustment related to water utilization has been utilized and implemented effectively. This study can provide a useful reference and guidance for scientific planning of water resource systems.     

Medium-Term Hydro Generation Scheduling (MTHGS) with Chance Constrained Model (CCM) and Dynamic Control Model (DCM)

Medium-Term Hydro Generation Scheduling (MTHGS) plays an important role in the operation of hydropower systems. In the first place, this paper presents a Chance Constrained Model for solving the optimal MTHGS problem. The model recognizes the impact of inflow uncertainty and the constraints involving hydrologic parameters subjected to uncertainty are described as probabilistic statements. It aims at providing a more practical technique compared to the traditional deterministic approaches used for MTHGS. The stochastic inflow is expressed as a simple discrete-time Markov chain and Stochastic Dynamic Programming is adopted to solve the model. Then in order to use the information of long-term inflow forecast to improve dispatching decisions, a Dynamic Control Model is developed. Short-term forecast results of the current period and long-term forecast results of the remaining period are treated as inputs of the model. Finally, the two methods are applied to MTHGS of Xiluodu hydro plant in China. The results are compared to those obtained from Deterministic Dynamic Programming with hindsight and advantages and disadvantages of the two methods are analyzed.     

从煤炭、天然气制取石油石化产品工艺技术

在阐述煤炭、天然气通过吹氧气化制取CO +H2 合成气联产石油石化产品的基础上 ,详细介绍了甲醇、二甲醚、乙烯生产工艺技术的应用与开发 ,对各种工艺路线进行了论证和技术经济评估     

仿人智能比例控制器与PID FUZZY控制算法的仿真分析

对于具有二阶惯性加纯滞后的不同对象，分别运用常规ＰＩＤ控制、Ｆｕｚｚｙ控制以及仿人智能控制算法进行仿真研究，并对各种控制算法的控制效果进行分析比较。结果表明：仿人智能控制的调节品质明显优于常规ＰＩＤ及Ｆｕｚｚｙ控制，具有响应速度快、超调小（甚至无超调）、过渡过程时间短、控制精度高、系统适应性强等优点。