Synthesis,characterization and charge transport properties of Pr–Ni Co-doped SrFe2O4 spinel for high frequency devices applications

Ferrites are materials of interest due to their broad applications in high technological devices and a lot of research has been focused to synthesize new ferrites. In this regard, an effort has been devoted to synthesize spinel Pr–Ni co-substituted strontium ferrites with a nominal formula of Sr_1-xPr_xFe_2-yNi_yO₄ (0.0 ≤ x ≤ 0.1, 0.0 ≤ y ≤ 1.0). The cubic structure of pure and Pr–Ni co-substituted strontium ferrite samples calcinated at 1073 K for 3 h has been confirmed through X-ray diffraction (XRD). Average sizes of crystallites (18–25 nm) have been estimated from XRD analysis and nanometer particle sizes of synthesized ferrites have been further verified by scanning electron microscopy (SEM). SEM results have also shown that particles are mostly agglomerated and all the samples possess porosity. It has been observed that at 298 K, the values of resistivity (ρ) increase, while that of AC conductivity, dielectric loss, and dielectric constants decrease with increasing amounts of Pr³⁺ and Ni²⁺ ions. The values of dielectric parameters initially decrease with frequency and later become constant and can be explained on the basis of dielectric polarization. Electrochemical impedance spectroscopy (EIS) studies show that the charge transport phenomenon in ferrite materials is mainly controlled via grain boundaries. Overall, synthesized ferrite materials own enhanced resistivity values in the range of 1.38 × 10⁹–1.94 × 10⁹ Ω cm and minimum dielectric losses, which makes them suitable candidates for high frequency devices applications.     

Boosting the activity of FeOOH via integration of ZIF-12 and graphene to efficiently catalyze the oxygen evolution reaction

Transition metal oxyhydroxides have been used as promising electrocatalysts for water splitting however, their catalytic activity is restricted due to low surface area and poor conductivity. Herein, we report novel composite FeOOH@ZIF-12/graphene composite as electrocatalyst for water oxidation, whereby ZIF-12 provide extra surface for the FeOOH dispersion whilst graphene act as excellent electron mediator. The composite shows a low overpotential value of 291 mV to attain a current density of 10 mA cm^?2 and a low Tafel slope value of 78 mV dec^?1. The catalyst offers a maximum current density of 101 mA cm^?2, while it gives a turnover frequency (TOF) value of 0.031 s^?1 at an overpotential of 291 mV only. The excellent activity and remarkable stability of composite is attributed to highly conductive and porous support.     

Biomathematical study of time-dependent flow of a Carreau nanofluid through inclined catheterized arteries with overlapping stenosis

Journal of Central South University - This work is concerned with the analysis of blood flow through inclined catheterized arteries having a balloon (angioplasty) with time-variant overlapping...     

Boosting the performance of visible light‐driven WO3/g‐C3N4 anchored with BiVO4 nanoparticles for photocatalytic hydrogen evolution

In this article, a ternary WO₃/g‐C₃N₄@ BiVO₄ composites were prepared using eco‐friendly hydrothermal method to produce efficient hydrogen energy through water in the presence of sacrificial agents. The prepared samples were characterized by scanning electron microscopy (SEM), scanning transmission electron microscopy (STEM), transmission electron microscopy (TEM), X‐ray diffraction (XRD), ultraviolet‐visible (UV‐vis), Brunauer‐Emmett‐Teller (BET) surface area, and photoluminescence spectroscopy (PL) emission spectroscopy. The experimental study envisages the formation of 2‐D nanostructures and observed that such kinds of nanostructures could provide more active sites for photocatalytic reduction of water and their inherent reactive‐species mechanism. The results showed the excellent photocatalytic performance (432 μmol h^?1 g^?1) for 1.5% BiVO₄ nanoparticles in WO₃/g‐C₃N₄ composite when compared with pure WO₃ and BiVO₄. The optical properties and photocatalytic activity measurement confirmed that BiVO₄ nanoparticles in WO₃/g‐C₃N₄ photocatalyst inhibited the recombination of photogenerated electron and holes and enhanced the reduction reactions for H₂ production. The enhanced photocatalytic efficiency of the composite nanostructures may be attributed to wide absorption region of visible light, large surface area, and efficient separation of electrons/holes pairs owing to synergistic effects between BiVO₄ and WO₃/g‐C₃N₄. The prepared samples would be a precise optimal photocatalyst to increase their suppliers for worldwide applications especially in energy harvesting.     

Momentum in nonlinear optics

Abstract

Although it is well known that light carries momentum and exerts a pressure on objects, a conservation of momentum principle is apparently rarely used in optics. In nonlinear optics light waves interact and may exchange both energy and momentum. We demonstrate that a conservation of momentum principle holds in these cases and in fact its use is widespread but generally unrecognized in the standard mathematical methods. In both the cases of linear basis waves interacting nonlinearly, e.g. coupled-wave theory and frequency mixing, and fully nonlinear waves, we demonstrate that a governing Hamiltonian is related to momentum. Action principles are used to discuss the generality of these results.     

Infrared absorption spectroscopy and fluctuations induced conductivity (FIC) analysis of Be-doped TlBa2Ca2Cu3O10−δ superconductor

Be-doped TlBa₂(Ca_2−yBe_y)Cu₃O_10−δ (y=0, 0.25, 0.5, 0.75, and 1.0) superconductor bulk samples were synthesized by solid state reaction and characterized by X-ray diffraction (XRD), dc-resistivity {ρ (Ω cm)}, and Fourier Transform Infrared (FTIR) absorption spectroscopy. Fluctuations induced conductivity (FIC) analysis is carried out on temperature dependent dc-resistivity data of as-prepared and oxygen post-annealed TlBa₂(Ca_2−yBe_y)Cu₃O_10−δ superconductor samples by using Aslamazov–Larkin (AL) and Lawrence–Doniach (LD) models for excess conductivity. Different microscopic parameters such as zero temperature coherence length along c-axis {ξ_c(0)}, inter-layer coupling (J), inter-grain coupling (α), critical exponent (λ_D) and dimensionality of fluctuations are calculated for understanding the role of Be-doping on superconducting properties of TlBa₂(Ca_2−yBe_y)Cu₃O_10−δ samples. The cross-over temperature (T_o) is shifted towards higher temperature values with the increase of Be contents in TlBa₂(Ca_2−yBe_y)Cu₃O_10−δ samples. The increase in ξ_c(0) and J after Be-doping at Ca sites shows the improvement of inter-plane coupling in TlBa₂(Ca_2−yBe_y)Cu₃O_10−δ samples. The increase in zero resistivity critical temperature {T_c(R=0) (K)} up to y=0.5 and then decrease for y=0.75, 1.00 fixed the Be-doping level for optimum increase of superconducting properties of TlBa₂(Ca_2−yBe_y)Cu₃O_10−δ samples. The appreciable changes in all the microscopic parameters extracted from the FIC analysis and the increase in relative intensity of almost all the oxygen phonon modes indicate the oxygen diffusion in the unit cell after oxygen post-annealing the samples. The oxygen diffusion can take place at both inter-granular and intra-granular sites, which increase the superconducting volume fraction by improving the grains size, inter-grain connectivity and carrier density.     

Structural,viscoelastic, and vulcanization study of sponge ethylene–propylene–diene monomer composites with various carbon black loadings

In this article, we report the effect of various carbon nanoparticle concentrations on the structural, curing, tan δ, viscosity variation during vulcanization, thermal, and mechanical characteristics of ethylene–propylene–diene monomer polymer sponge composites. The purpose of this study was to develop high‐strength, foamy‐structure polymer composites with an optimum filler to matrix ratio for advanced engineering applications. We observed that the structural, vulcanization, viscoelastic, and mechanical properties of the fabricated composites were efficiently influenced with the progressive addition of carbon content in the rubber matrix. © 2013 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2014 , 131, 39423.     

Multi‐agent‐based sharing power economy for a smart community

In this paper, a multi‐agent‐based locally administrated power distribution hub (PDH) for social welfare is proposed that optimizes energy consumption, allocation, and management of battery energy storage systems (ESSs) for a smart community. Initially, formulation regarding optimum selection of a power storage system for a home (in terms of storage capacity) is presented. Afterwards, the concept of sharing economy is inducted in the community by demonstrating PDH. PDH is composed of multiple small‐scale battery ESSs (each owned by community users), which are connected together to form a unified‐ESS. Proposed PDH offers a localized switching mechanism that takes decision of whether to buy electricity from utility or use unified‐ESS. This decision is based on the price of electricity at ‘time of use’ and ‘state of charge’ of unified‐ESS. In response to power use or share, electricity bills are created for individual smart homes by incrementing or decrementing respective submeters. There is no buying or selling of power from PDH; there is power sharing with the concept of ‘no profit, no loss’. The objective of the proposed PDH is to limit the purchase of electricity on ‘high priced’ hours from the utility. This not only benefits the utility at crucial hours but also provides effective use of power at the demand side. The proposed multi‐agent system depicts the concept of sharing power economy within a community. Finally, the proposed model is analyzed analytically, considering on‐peak, off‐peak, and mid‐level (mid‐peak) prices of a real‐time price signal during 24 h of a day. Results clearly show vital financial benefits of ‘sharing power economy’ for end users and efficient use of power within the smart community. Copyright © 2017 John Wiley & Sons, Ltd.     

Exchange Bias, Memory and Freezing Effects in NiFe2O4 Nanoparticles

Single-phase NiFe₂O₄ nanoparticles embedded in SiO₂ matrix have been synthesized by sol-gel method. Average particle size lies in the range 8?C12 nm. Magnetic measurements are taken by SQUID-magnetometer with a maximum applied field of ??7 T and temperature down to 4.2 K. An exchange bias effect in nanoparticles is due to the existence of strong core-shell interactions and it vanishes as the particle size decreases (<4?nm). Spin disorder and frustration appear at the core-shell interface due to broken bonds on the surface. We have observed the exchange bias effect via hysteresis loop shift, when the sample is cooled in an applied field of 5?T. In both AC and DC fields, our system exhibit memory effects at the halted temperatures. Furthermore, a sharp increase of coercivity at low temperatures (<50 K) is observed, which is attributed to increased surface anisotropy at low temperatures. For saturation magnetization vs. temperature data, Bloch??s T ^3/2 law (M(T)=M(0)?(1?BT ^b )) is fitted well and yields: B=4??10^?05 K^?3/2 and b=1.53. All these measurements prove the presence of exchange bias (core-shell interactions), memory effects, validation of Bloch??s T ^3/2 law and freezing effects in nickel ferrite nanoparticles dispersed in SiO₂ matrix.