A Pattern Recognition Method of Personalized Adaptive Learning in Online Education

Mobile Networks and Applications - In order to effectively identify the pattern of personalized adaptive learning in online education and improve the recommendation satisfaction of personalized...     

Improving gelling properties of myofibrillar proteins incorporating with cellulose micro/nanofibres

The effects of cellulose microfibres (CMFs, Average size: 100 ± 5 μm) and cellulose nanofibres (CNFs, Average size: 60 ± 3 nm) on the properties of myofibrillar protein (MP) gels from duck breast meat were studied. The results demonstrated that CMFs and CNFs were mostly connected to MP by non-covalent bonds, the diffusion and cross-linking of MP molecules was promoted, and a denser and more complete gel network was formed. With the increases of CMFs and CNFs concentration (0–10%), the hardness was increased by 13.15% and 19.78% for CMFs10% and CNFs10% gels, respectively, and the elasticity was increased by 40% and 80%, respectively. At the same concentration (0–10%), the increase in gel hardness, viscoelasticity and immobilised water content was greater in the CNFs-MP group than in the CMFs-MP group. The CNFs-MP group had a tighter gel network, and CNFs had a better potential to improve the gelation performance of MP.     

Effects of structural parameters on water film properties of transpiring wall reactor

Corrosion and salt deposition problems severely restrict the industrialization of supercritical water oxidation. Transpiring wall reactor can effectively weaken these two problems by a protective water film. In this work, methanol was selected as organic matter, and the influences of vital structural parameters on water film properties and organic matter removal were studied via numerical simulation. The results indicate that higher than 99% of methanol conversion could be obtained and hardly affected by transpiration water layer, transpiring wall porosity and inner diameter. Increasing layer and porosity reduced reactor center temperature, but inner diameter's influence was lower relatively. Water film temperature reduced but coverage rate raised as layer, porosity, and inner diameter increased. Notably, the whole reactor was in supercritical state and coverage rate was only approximately 85% in the case of one layer. Increasing reactor length affected slightly the volume of the upper supercritical zone but enlarged the subcritical zone.     

放电参数变化对电感耦合等离子闭式等离子体空间分布特性研究

射频电感耦合等离子体（ICP）在实际放电过程中，线圈的构型、电源参数、气压等外部工质条件的变化均会对结果产生较大影响，依靠实验很难得到多外部条件对ICP参数分布的影响机理和规律，因此需要结合仿真和实验的方法进行分析。该文通过建立感性线圈的电磁学有限元模型，分析不同线圈构型下射频电磁场在等离子体内部的空间分布，研究放电参数（线圈构型、功率大小）对等离子体分布影响和E-H模型下放电形态的跳变过程，并观察进入稳定H模式后电源参数的变化规律，为等离子体源的小型化工程应用提供理论基础。实验和仿真计算结果表明：不同线圈匝数在不同功率条件下，电磁场强度变化对等离子功率吸收和功率耦合有较大影响；当工作气压在0～20Pa时，ICP的电子密度呈轴对称分布，随着放电功率、气压的增大，等离子体吸收的功率和电离度也随之增加，其电子密度相应地增大，放电功率的增加会使得环状的等离子体区域随之扩大，在轴向、径向上的分布呈先逐渐增大而后在靠近腔室壁面区域迅速下降。     

Enhanced thermal conductivity of PP hybrid films induced by filler orientation and laminated structure

Journal of Materials Science - Currently, polymeric composites with good thermal conductivity and simple preparation method are in the rapid increment of demand. In this work,...     

How scientific research incorporates policy: an examination using the case of China’s science and technology evaluation system

Scientometrics - Governments typically formulate sets of policies to guide the direction of scientific research. And the possible effects of these policies on scientific research have been...