Evaluation of Transport Phenomena for Removing Vanadium from Petrochemical Industry Solid Waste

Transport phenomena are investigated which are involved in the electrokinetic remediation process used for removing vanadium from deactivated catalysts from oil catalytic cracking that are currently allotted to cement plants and class-I landfills. Variables such as the concentration of electrolyte, electric potential, and applied electric current were evaluated in order to determine the effects produced by electroosmosis, diffusion, hydraulic gradient, and electromigration on the removal of vanadium from the catalyst. It was observed that migration is the most relevant phenomenon in the remediation tests, and for the best remediation condition, the migratory flow accounted for about 87 % of the vanadium removal.     

Lab-Scale Microreactor Plant for the Study of Methylations with Liquid Chloromethane

Chloromethane is an important reagent for methylations in the process industry. However, as a gas suspected of causing cancer, it is rarely used at laboratory scale. Therefore, a setup is presented here for studies in a laboratory under safe and reproducible conditions. The use of a microreactor guarantees high heat transfer rates and a low holdup of the reagent. As a proof-of-concept, the reaction of chloromethane with the secondary amine morpholine in aqueous solution is investigated. By applying elevated pressures, a liquid-liquid system with enhanced solubility of chloromethane in the aqueous phase is accessible.     

Identification of vivianite,an unusual blue pigment,in a sixteenth century painting and its implications

Vivianite, a blue pigment employed in the past practically only in Northern and Central Europe, but with very limited use, was identified in an early sixteenth century painting, stylistically with Flemish features, from a church in Portugal. The identification of this iron phosphate mineral was made by SEM‐EDS based on the atomic ratio between phosphorus and iron in layers of blue paint (area analysis) and in particles of these same layers (spot analysis). This painting, about which there is no document to prove its authorship, becomes the first case, known in detail, of a sixteenth century painting containing vivianite. Moreover, this find and the presence of a chalk ground, also identified, strongly support the hypothesis of being a Flemish painting.     

Biodegradability Study of the Biosurfactant Contained in a Crude Extract from Corn Steep Water

Over the last few years, the global biosurfactant market has raised due to the increasing awareness among consumers, for the use of biological or bio-based products. Because of their composition, it can be speculated that these are more biocompatible and more biodegradable than their chemical homologous. However, at the moment, no studies exist in the literature about the biodegradability of biosurfactants. In this work, a biosurfactant contained in a crude extract, obtained from a corn wet-milling industry stream that ferments spontaneously in the presence of lactic acid bacteria, was subjected to a biodegradation study, without addition of external microbial biomass, under different conditions of temperature (5–45 °C), biodegradation time (15–55 days), and pH (5–7). For that, a Box–Behnken factorial design was applied, which allowed to predict the percentage of biodegradation for the biosurfactant contained in the crude extract, between the range of the independent variables selected in the study, obtaining biodegradation values between 3 and 80%. The percentage of biodegradation for the biosurfactant was calculated based on the increase in the surface tension of samples of the crude extract. Furthermore, it was also possible to predict the variation in t_1/2 for the biosurfactant (time to achieve the 50% of biodegradation) under different conditions.     

Solidification microstructure-dependent hydrogen generation behavior of Al–Sn and Al–Fe alloys in alkaline medium

This work deals with the development of quantitative correlations of hydrogen evolution performance with solidification microstructural and thermal parameters in Al–1Sn, Al–2Sn, Al–1Fe, and Al-1.5Fe [wt.%] alloys. The cellular growth as a function of growth and cooling rates is evaluated using power type experimental laws, which allow determining representative intervals of microstructure length scale for comparison purposes with the results of immersion tests in 5 wt%NaOH solution. For both Al alloys systems, hydrogen evolution becomes slower as the alloy solute content increased. However, for a given alloy composition, whereas a more homogeneous distribution of Sn-rich particles promotes faster hydrogen generation using Al–Sn alloys, coarsening of Al₆Fe IMCs (intermetallic compounds) fibers favors hydrogen production using Al–Fe alloys. When solidification conditions that result in a range of cellular spacings within 16 and 19 μm are considered, the specific hydrogen production of the Al-1wt.%Fe alloy is higher than that of the other studied alloys.     

Highly translucent nanostructured glass-ceramic

Transparent and translucent glass-ceramics (GCs) are found in an increasing number of domestic and high-technology applications. In this paper, we evaluated and optimized the effects of two-stage heat treatments on the resulting crystalline phases and microstructure of a glass of the SiO₂–Li₂O–P₂O₅–TiO₂–CaO–ZnO–Al₂O₃ system. The objective was to develop a transparent nanostructured glass-ceramic (GC). After numerous heat treatment trials, we found that a long nucleation period of 72 h at 455 °C followed by a crystal growth treatment at 660 °C for 2 h resulted in a highly translucent GC having homogenously distributed nanocrystals. The relatively high amount of P₂O₅ (2.5 mol%) induced the formation of lithium disilicate as the main crystal phase. We thus developed a GC having crystals under 50 nm, with a high crystallized fraction (52%vol. Li₂Si₂O₅ and 26% vol Li₂SiO₃), transmittance of approximately 80% in the visible spectrum for 1.2 mm thick specimens, nano hardness of 8.7 ± 0.1 GPa (load of 400 mN), a high elastic modulus of 138 ± 3 GPa as measured by nanoindentation, and good flexural strength (350 ± 40 MPa) as measured by ball-on-3 balls tests. Due to its high content of Li⁺, this GC has the potential to be chemically strengthened and can be further developed to be used in a number of applications, such as on displays of electronic devices.     

An approach to mechanistic event recognition applied on monitoring organic matter depletion in SBRs

A fundamental practice in process engineering is monitoring the state dynamics of a system. Unfortunately, observability of some states is related to high costs, time, and efforts. The mechanistic event recognition (MER) aims to detect an event (defined as a change of the system with specific significance to the operation of the process) that cannot be directly observed but has some predictable effect on the dynamics of the systems. MER attempts to apply fault diagnosis techniques using mechanistic “recognition” models to describe the process. A systematic method for building recognition models using optimal experimental design tools is presented. As proof of concept, the MER approach to detect organic matter depletion in sequencing batch reactors, measuring only ammonia, dissolved oxygen, and nitroxides is applied. The event, that is, consumption of organic matter to a level below 50 gCOD/m³, was successfully detected even though microbial activity is known to continue after organic matter depletion. © 2014 American Institute of Chemical Engineers AIChE J, 60: 3460–3472, 2014     

Biosurfactant-and-Bioemulsifier Produced by a Promising Cunninghamella echinulata Isolated from Caatinga Soil in the Northeast of Brazil

A Mucoralean fungus was isolated from Caatinga soil of Pernambuco, Northeast of Brazil, and was identified as Cunninghamella echinulata by morphological, physiological, and biochemical tests. This strain was evaluated for biosurfactant/bioemulsifier production using soybean oil waste (SOW) and corn steep liquor (CSL) as substrates, added to basic saline solution, by measuring surface tension and emulsifier index and activity. The best results showed the surface water tension was reduced from 72 to 36 mN/m, and an emulsification index (E₂₄) of 80% was obtained using engine oil and burnt engine oil, respectively. A new molecule of biosurfactant showed an anionic charge and a polymeric chemical composition consisting of lipids (40.0% w/w), carbohydrates (35.2% w/w) and protein (20.3% w/w). In addition, the biosurfactant solution (1%) demonstrated its ability for an oil displacement area (ODA) of 37.36 cm², which is quite similar to that for Triton X-100 (38.46 cm²). The stability of the reduction in the surface water tension as well as of the emulsifier index proved to be stable over a wide range of temperatures, in pH, and in salt concentration (4%–6% w/v). The biosurfactant showed an ability to reduce and increase the viscosity of hydrophobic substrates and their molecules, suggesting that it is a suitable candidate for mediated enhanced oil recovery. At the same time, these studies indicate that renewable, relatively inexpensive and easily available resources can be used for important biotechnological processes.     

Biochemical,Structural, and Genetic Characterization of Tridecaptin A1, an Antagonist of Campylobacter jejuni

Bacillus circulans NRRL B‐30644 (now Paenibacillus terrae) was previously reported to produce SRCAM 1580, a bacteriocin active against the food pathogen Campylobacter jejuni. We have been unable to isolate SRCAM 1580, and did not find any genetic determinants in the genome of this strain. We now report the reassignment of this activity to the lipopeptide tridecaptin A₁. Structural characterization of tridecaptin A₁ was achieved through NMR, MS/MS and GC‐MS studies. The structure was confirmed through the first chemical synthesis of tridecaptin A₁, which also revealed the stereochemistry of the lipid chain. The impact of this stereochemistry on antimicrobial activity was examined. The biosynthetic machinery responsible for tridecaptin production was identified through bioinformatic analyses. P. terrae NRRL B‐30644 also produces paenicidin B, a novel lantibiotic active against Gram‐positive bacteria. MS/MS analyses indicate that this lantibiotic is structurally similar to paenicidin A.