水-油连续螺旋折流板换热器热力性能研究

利用计算流体力学(Computational Fluid Dynamic, CFD)方法,针对连续螺旋折流板换热器建立物理模型和数学模型,在管侧介质为水和壳侧介质为原油条件下,研究不同原油流量及螺旋角对螺旋折流板换热器内部流场、换热性能及阻力性能的影响,并拟合了水油换热时螺旋折流板换热器的Nu、f与Re的关联式。结果表明：22°螺旋角的螺旋折流板换热器与其它较小螺旋角换热器对比,壳侧压降和换热系数逐渐减小,综合换热性能最佳。通过对壳侧原油为层流状态下的阻力系数和对流换热系数关系式进行拟合,更好地指导水-油连续螺旋折流板换热器的热力设计。     

Strength and interfacial microstructure of Si3N4 joint brazed with amorphous Ti-Zr-Ni-Cu filler metal

In this paper, the vacuum brazing of Si3N4 ceramic was carried oat with Ti40Zr25Ni15Cu20 amorphous filler metal. The interfacial microstructure was investigated by scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS) etc. According to the analysis, the interface reaction layer was made up of TiN abut on the ceramic and the Ti-Si, Zr-Si compounds. The influence of brazing temperature and holding time on the joint strength was also studied. The results shows that the joint strength first increased and then decreased with the increasing of halding time and brazing temperature. The joint strength was significantly affected by the thickness of the reaction layer. Under the same experimental conditions, the joint brazed with amorphous filler metal exhibits much higher strength compared with the one brazed with crystalline filler metal with the same composition. To achieve higher joint strength at relatively low temperature, it is favorable to use the amorphous filler metal than the crystalline filler metal.     

Al-Si-Cu-Zn急冷钎料钎焊铝及铝合金的界面结构及强度

采用Al70Si7.5Cu20Zn2.5和Al65Si10Cu20Zn5两种急冷钎料钎焊L2纯铝和6063铝合金,研究钎焊接头的界面微观结构和力学性能.结果表明,急冷钎料钎焊接头由母材、界面区和钎缝中心组成.界面区为αAl固溶体,钎缝中心组织为αAl固溶体 θ(Al2Cu)相 Si相.采用Al65Si10Cu20Zn5急冷钎料钎焊的接头抗剪强度均高于Al70Si-7.5Cu20Zn2.5急冷钎料钎焊的接头强度;匹配氯化物钎剂钎焊的接头强度均高于氟化物钎剂.在相同的工艺条件下,采用急冷钎料钎焊的L2纯铝接头,其抗剪强度都明显高于相应的常规钎料,其增加值在40%左右.