Superhydrophobic properties of cotton fabrics functionalized with ZnO by electroless deposition

Cotton fabrics were coated with arrays of ZnO hexagonal prisms using an electroless (catalytic/autocatalytic) deposition process. A typical three step method, similar to those used for electroless deposition of metals on insulating substrates, consisting of pre-activation, activation and deposition steps was employed. The low-dimensional ZnO particles were grown from an aqueous solution containing zinc nitrate as source of zinc ions and dimethylamineborane as reducing agent. The as-obtained ZnO-coated cotton fabrics were characterized from the point of view of structure by X-ray diffraction (XRD) and morphology by scanning electron microscopy (SEM). The XRD studies demonstrate that the ZnO particles have a hexagonal wurtzite crystalline structure. The SEM observations prove that the cotton fibers are homogeneously covered by hexagonal prisms which have uniform base size of approximately 500 nm and height of 1 μm. Optical spectroscopy measurements show that the functionalization with ZnO strongly decreases the transmittance in the UV–vis region of the cotton fabrics. An important characteristic is that the ZnO-functionalized cotton fabrics exhibit superhydrophobicity, with water contact angles exceeding 150°. The technique described is highly reproducible, easy scalable and cheap, allowing a wide range of applications.     

Validation of a Method for Analysis of Aroma Compounds in Red Wine using Liquid–Liquid Extraction and GC–MS

An analytical method for determination of volatile composition of wines using sample preparation by liquid–liquid extraction and gas chromatography coupled to mass spectrometry for separation and detection has been developed and validated. Extraction of volatile compounds was performed in dichloromethane, and 1-octanol was added as an internal standard. Kékfrankos red wine produced in Villány wine region in Hungary was used as a model wine for testing and validation of the method. The developed method allowed satisfactory determination of 33 volatile compounds in the wines. Compounds analyzed include alcohols, esters, lactones, fatty acids, furans, and nitrogen compounds. The calibration curves of the four reference compounds used (2-phenyl ethanol, ethyl nonanoate, butyrolactone, and tyrosol) were linear in all cases with correlation coefficients (R ²) ranging from 0.9951 to 0.9992. The accuracy of the method was checked with a standard addition method (recovery 92.2–103 %), showing good repeatability and reproducibility (RSD?<?10 %).     

Hawaiian and Azorean volcanic aggregates: a preliminary study of the potential alkali-silica reaction

Bulletin of Engineering Geology and the Environment - The alkali-silica reaction (ASR) is a chemical deterioration of concrete that involves reactive forms of silica. Volcanic glass is one of the...     

Synthesis of hybrid nanocomposites based on new triazeno copolymers and montmorillonite used for detecting metal ions

The modern synthesis of novel functional materials with improved properties includes that of hybrid nanocomposites composed of inorganic nanoparticles and organic derivatives, where controlling the molecular structure at atomic and macroscopic dimensions is a key factor, with a major effect on performance. An extension of this approach to the field of nanocomposites containing photopolymers with triazene groups attached on a methacrylic backbone could be of great interest in the future development of chemosensors and photoresists, among others. Photopolymer/clay nanocomposites were prepared by in situ free radical copolymerization of 1‐(phenyl)‐3‐(2‐methacryloyloxyethylcarbamoyloxyethyl)‐3‐methyltriazene‐1 or 1‐(p‐methoxyphenyl)‐3‐(2‐methacryloyloxyethylcarbamoyloxyethyl)‐3‐methyltriazene‐1 and vinyl acetate or styrene in solution and in the presence of 3 and 5 wt% of organically modified montmorillonite. The characterization of the nanocomposites and pure copolymers was achieved through ¹H NMR and Fourier transform infrared spectroscopy, gel permeation chromatography, thermogravimetric analysis, X‐ray diffraction, atomic force microscopy and fluorescence analysis. The morphologies and properties of the nanocomposites are dependent on the nature of the triazene, on the co‐monomer structure and on the organoclay content. Also, the fluorescence response of these nanocomposites towards certain metal ions (Fe³⁺, Cu²⁺, Hg²⁺, Ni²⁺) in dimethylformamide solution was investigated. The effect of uranyl ions on the fluorescence intensity of the nanocomposites in solution or as films could be exploited in the development of ‘turn‐off’ or ‘turn‐on’ chemosensors for this type of analyte. Triazeno copolymer/organophilic montmorillonite nanocomposites with exfoliated (not completely exfoliated) or exfoliated and intercalated structures exhibit distinct characteristics concerning their fluorescence behaviour, a higher sensing ability towards certain target compounds (Fe³⁺, UO₂²⁺) being evidenced for those incorporating 3 wt% organoclay in solution and as films. Copyright © 2010 Society of Chemical Industry     

Biochemical,microbiological and sensory changes in shrimp (Panaeus aztecus) dipped in different solutions using face‐centred central composite design

Biochemical, microbiological and sensory changes during shelf‐life at ?1 °C were determined in shrimp (Panaeus aztecus) previously dipped in ascorbic acid, citric acid, potassium sorbate and 4‐hexyl resorcinol solutions using face‐centred central composite design. Microbiological count, trimethylamine and hypoxantine production were measured. The lowest level of the total psychrotrophic bacteria, hypoxantine and trimethylamine were found in samples dipped in all containing chemicals solutions comparing to control treatment. Sensory studies showed that treatment A (ascorbic acid 4.50, citric acid 0.12, potassium sorbate 18.60 and 4‐hexyl resorcinol 0.25, all g L^?1) and B (ascorbic acid 4.37, citric acid 1.26, potassium sorbate 7.03 and 4‐hexyl resorcinol 0.25, all g L^?1) did not alter the typical sensory features of shrimp and were effective at delaying the bitter off‐flavour formation for 26 days. This study constitutes a promising alternative to extent shelf‐life of shrimp kept at ?1 °C without freezing.     

Effect of Sample Solubilized Aliquot Volume and Concentration on Hydroperoxide Detection in PUFA-Rich Fish Oil

The objective of this work was to study the effect of sample oil concentration and volume on hydroperoxide determination in n-3 PUFA-rich sardine-anchovy oil. Oil samples were stored at??20°C, 6 d, air-free (T1); and 20°C, 2 d in air (T2). Significant differences between storage conditions were observed on hydroperoxide concentration. High reproducibility was obtained even in sample concentrations as low as 5 mg oil/mL of propan-1-ol. A high correlation was observed between the modified ferrous oxidation-xylenol orange method (FOX2) and AOAC peroxide value analysis methods, although FOX2 was faster, more sensitive, and precise when analyzing small hydroperoxide concentrations.     

Dynamic load‐balancing mechanism for distributed Java applications

Program environments or operating systems generally leave the decision on the allocation of program entities to the developer, offering either placement directives, or tools available through the manipulation of a graphical interface. These approaches cannot always take into account the dynamic behavior of applications, dynamicity in the execution environment or the heterogeneity of the execution platform. Transparent deployment algorithms are necessary for automizing and optimizing application distribution. The Adaptive Distributed Applications in Java (ADAJ) project deals with placement and migration of Java objects. It automatically deploys parallel Java applications on a cluster of workstations using monitoring information about the application behavior. The transparency obtained through the integration of these tools in the middleware makes such an environment easy to use and improves efficiency. Copyright © 2005 John Wiley & Sons, Ltd.     

Synthesis and characterization of polyurethane cationomer/MMT hybrid composite

BACKGROUND: The development of polymeric nanocomposites incorporating intercalated or exfoliated layered silicate clays into the organic matrix has been substantially motivated by the significant improvements induced by the presence of the inorganic component. Moreover, understanding and controlling the dispersion of inorganic layers into segmented polyurethane matrices by means of ionic interactions, and exploiting these interactions to enhance physicomechanical behaviour, could be of great interest in the field of polymer nanocomposites. RESULTS: New cationic polyurethane elastomers were prepared starting from poly(butylene adipate)diol (M_n = 1000 g mol^?1), 4,4′‐diphenylmethane diisocyanate, 1,4‐butanediol and N‐methyldiethanolamine or N,N′‐β‐hydroxyethylpiperazine, used as potential quaternizable moieties. The characterization of the polymers was achieved using specific analyses employed for the macromolecular samples (Fourier transform infrared and ¹H NMR spectroscopy, thermogravimetric analysis (TGA), gel permeation chromatography). An extension of our research on polymers reinforced with organically modified montmorillonite (OM‐MMT) in order to prepare hybrid composites with improved properties was performed and the resulting materials were characterized using TGA, X‐ray diffraction, atomic force microscopy and scanning electron microscopy. Also, the mechanical properties of the cationic polyurethane/OM‐MMT composites were investigated in comparison with the pristine ionic/non‐ionic polymers and their composites containing non‐ionic polymer blended with OM‐MMT or ionic polymer and unmodified MMT. CONCLUSION: The insertion of the organically modified clay into the polymeric matrix gave an improvement of the mechanical properties of the polyurethane composites, especially the tensile strength and stiffness of the hybrid materials. Copyright © 2009 Society of Chemical Industry     

The lower and upper approximations in a hypergroup

This paper presents a relationship between rough sets and hypergroup theory. We analyze the lower and upper approximations of a subset, with respect to an invertible subhypergroup and we consider some particular situations. Moreover, the notion of a rough subhypergroup is introduced. Finally, fuzzy rough subhypergroups are introduced and characterized.