Hsp100 Molecular Chaperone ClpB and Its Role in Virulence of Bacterial Pathogens

This review focuses on the molecular chaperone ClpB that belongs to the Hsp100/Clp subfamily of the AAA+ ATPases and its biological function in selected bacterial pathogens, causing a variety of human infectious diseases, including zoonoses. It has been established that ClpB disaggregates and reactivates aggregated cellular proteins. It has been postulated that ClpB’s protein disaggregation activity supports the survival of pathogenic bacteria under host-induced stresses (e.g., high temperature and oxidative stress), which allows them to rapidly adapt to the human host and establish infection. Interestingly, ClpB may also perform other functions in pathogenic bacteria, which are required for their virulence. Since ClpB is not found in human cells, this chaperone emerges as an attractive target for novel antimicrobial therapies in combating bacterial infections.     

Heteroalleles in Common Wheat: Multiple Differences between Allelic Variants of the Gli-B1 Locus

The Gli-B1-encoded γ-gliadins and non-coding γ-gliadin DNA sequences for 15 different alleles of common wheat have been compared using seven tests: electrophoretic mobility (EM) and molecular weight (MW) of the encoded major γ-gliadin, restriction fragment length polymorphism patterns (RFLPs) (three different markers), Gli-B1-γ-gliadin-pseudogene known SNP markers (Single nucleotide polymorphisms) and sequencing the pseudogene GAG56B. It was discovered that encoded γ-gliadins, with contrasting EM, had similar MWs. However, seven allelic variants (designated from I to VII) differed among them in the other six tests: I (alleles Gli-B1i, k, m, o), II (Gli-B1n, q, s), III (Gli-B1b), IV (Gli-B1e, f, g), V (Gli-B1h), VI (Gli-B1d) and VII (Gli-B1a). Allele Gli-B1c (variant VIII) was identical to the alleles from group IV in four of the tests. Some tests might show a fine difference between alleles belonging to the same variant. Our results attest in favor of the independent origin of at least seven variants at the Gli-B1 locus that might originate from deeply diverged genotypes of the donor(s) of the B genome in hexaploid wheat and therefore might be called “heteroallelic”. The donor’s particularities at the Gli-B1 locus might be conserved since that time and decisively contribute to the current high genetic diversity of common wheat.     

Structural Basis for Antimicrobial Activity of Lasiocepsin

Lasiocepsin is a unique 27‐residue antimicrobial peptide, isolated from Lasioglossum laticeps (wild bee) venom, with substantial antibacterial and antifungal activity. It adopts a welldefined structure consisting of two α‐helices linked by a structured loop. Its basic residues form two distinct positively charged regions on the surface whereas aliphatic side chains contribute to solvent‐accessible hydrophobic areas, thus emphasising the amphipathic character of the molecule. Lasiocepsin structurally belongs to the ShK family and shows a strong preference for anionic phospholipids; this is further augmented by increasing concentrations of cardiolipin, such as those found at the poles of bacterial cells. The membrane‐permeabilising activity of the peptide is not limited to outer membranes of Gram‐negative bacteria. The peptide interacts with phospholipids initially through its N terminus, and its degree of penetration is strongly dependent on the presence of cardiolipin.     

VPI-FP: an integrative information system for factory planning

Nowadays, one of the main challenges in factory planning is the consistent and coherent information modelling along planning processes. Despite the current efforts in the fields of virtual production as well as digital and virtual factory, planning and simulation applications mostly support only the analysis and the optimisation of single planning aspects. However, to match nowadays challenges, planners require solutions that provide an integrated view to evaluate planning scenarios in advance and to achieve increasing production quality and efficiency. The concept of virtual production intelligence (VPI) provides a basic concept for such an integrative information system that enables planners to integrate, to aggregate and to analyse data gathered during one planning project as well as to compare different projects. In this study, we present such an information system for factory planning using the concept of the VPI. The focus lies in particular on the information modelling as well as the information integration and evaluation. Therefore, the study presents theoretical basics and implementations of the VPI platform within a precise application scenario in factory planning. This is to process and provide a consolidated information base along the whole planning process to support factory planning projects.     

A sorption rate hypothesis for the increase in H2 permeability of palladium-silver (Pd-Ag) membranes caused by air oxidation

Hydrogen permeation measurements were performed at 300 °C for 25-μm cold-rolled Pd-Ag 25 wt% membranes before and after air oxidation at the same temperature as permeation. The air oxidation resulted in enhanced H₂ permeation through the membrane, as well as a roughening of the surface with the formation of surface grains and defects. The protruding grains can be leveled off by exposure to H₂ but the surface defects cannot. These microstructure changes are only on the membrane surfaces and do not create transmembrane defects that would allow permeation for gas species other than H₂. The H₂ permeability of the oxidized membrane increased by 25-90% compared to that of the as-received film at the same permeation condition, and the membranes retained perfect H₂ selectivity over N₂. The percent improvement of H₂ permeability decreases with increasing H₂ feed pressure. A new sorption kinetics hypothesis is proposed to elucidate the increase in H₂ permeability of Pd-Ag membranes caused by oxidation. H₂ solubility and sorption rate results were presented to test the new hypothesis. It is found that air oxidation does not change the H₂ solubility in Pd-Ag membranes, but enhances the H₂ sorption kinetics significantly. The extent of kinetics enhancement also decreases with increasing H₂ pressures. The much faster sorption equilibrium implies higher effective H₂ diffusivity at the Pd-Ag membrane surface for the oxidized sample and a higher transfer rate of atomic hydrogen from surface/sub-surface to the membrane bulk that contributes to the increase of H₂ permeability observed in experiments.     

A noble silver nanoflower on nitrogen doped carbon nanotube for enhanced oxygen reduction reaction

An electrodeposition-approach for the synthesis of silver nanoflowers (AgNFs) on nitrogen doped carbon nanotubes (NCNTs) for the oxygen reduction reaction (ORR) in alkaline media has been developed. The as prepared material (NCNTs-AgNFs) has been characterized by various instrumental methods. The morphological analysis shows the unique rose-like AgNFs are placed onto the NCNTs with better dispersion. The higher population of AgNFs has also been observed onto NCNTs coated glassy carbon (GC) rather than bare GC plate. The X-ray photoelectron spectroscopy shows chemical reduction and N-doping has done successfully with the restoring sp² domain in carbon network. The electrocatalytic activities have been verified using cyclic voltammetry (CV) and hydrodynamic voltammetry techniques in 0.1 M KOH electrolyte. The resulting catalyst system, NCNT-AgNFs, surpasses the performance of Pt/C, in terms of a kinetic current density, better fuel selectivity and durability. It is also noteworthy that the NCNT-AgNFs exhibits a four-electron reduction pathway for ORR with lowering H₂O₂ yield. The admirable performance of NCNT-AgNFs catalyst along with higher durability holds great potential for application in various fuel cells as cathode catalyst.     

Effect of Cerium Doping on Microstructure and Dielectric Properties of BaTiO3 Ceramics

A solid state reaction method was used to synthesize barium titanate (BT) and barium cerium titanate (BCT) ceramics at sintering temperature of 1473 K for 4 h. The effect of cerium (Ce) on the structure, microstructure and dielectric properties of BCT was investigated. The scanning electron microscopy (SEM) investigations revealed that the grain size increases with increasing Ce content. The X-ray diffraction (XRD) patterns showed mostly the BT phase, where the lattice parameter decreased with the addition of Ce. The temperature dependence of dielectric constant showed decrease in the phase transition temperature with higher Ce content. The dielectric constant decreased slightly with increasing frequency. The direct current (dc) density-voltage characteristics of the ceramics showed ohmic behavior for both the BT and BCT. As the temperature increased, the dc resistivity of the ceramics decreased. The activation energy increased with increasing Ce content.     

Affirmation, acknowledgment of in-group responsibility, group-based guilt, and support for reparative measures.

Three studies, 2 conducted in Israel and 1 conducted in Bosnia and Herzegovina, demonstrated that affirming a positive aspect of the self can increase one's willingness to acknowledge in-group responsibility for wrongdoing against others, express feelings of group-based guilt, and consequently provide greater support for reparation policies. By contrast, affirming one's group, although similarly boosting feelings of pride, failed to increase willingness to acknowledge and redress in-group wrongdoing. Studies 2 and 3 demonstrated the mediating role of group-based guilt. That is, increased acknowledgment of in-group responsibility for out-group victimization produced increased feelings of guilt, which in turn increased support for reparation policies to the victimized group. Theoretical and applied implications are discussed. (PsycINFO Database Record (c) 2011 APA, all rights reserved)