Beam test of the CsI(Tl) calorimeter for the BELLE detector at the KEK-B factory

We studied the performance of a prototype electromagnetic calorimeter for the BELLE detector at the KEK proton synchrotron for an energy range of 0.25–3.5 GeV. The prototype consisted of an array of 6 × 5 CsI(Tl) crystals with 30 cm length (16.2 radiation lengths) and about 6 cm × 6 cm cross section. The scintillation light of each CsI(Tl) crystal was read out by two large-area PIN photodiodes and charge-sensitive preamplifiers attached at the rear face of the crystal. We measured the energy and position resolution for electrons and the e/π separation for two sets of matrix configurations: one corresponded to the center and the other to the edge of the barrel calorimeter. The overall performance measured by the test proves that the prototype calorimeter is satisfactory for the use in the BELLE detector.     

Mesa-isolated GaAs Schottky-barrier photodiodes

The design, fabrication and characterisation of GaAs Schottky-barrier photodiodes with evaporated, free-standing-metal airbridges is reported. The photodiodes were fabricated using all dry-etching techniques. Anisotropic chemically assisted ion beam etching was used to etch vertical sidewall mesas, and isotropic reactive ion etching was used to etch a lateral tunnel. A free-standing-metal airbridge created by the lateral tunnel etch results in isolation of the active area at the same time providing free-standing-metal interconnection to the contact pad.<>     

Cross-specialty linkage and extrapolation of resource-based relative value scales

We used the fluorescent labelled dopamine D1-receptor antagonist Bodipy-SCH 23390 for the cellular localization of D1-ligand binding sites in the retinae of different vertebrates (teleosts, Xenopus, turtle, rat and rabbit). Competition experiments with unfixed cryosections of fish retina were performed to characterize the binding conditions of Bodipy-labelled SCH 23390. Tissue bound [3H]SCH 23390 was displaceable with increased amounts of bodipy-SCH 23390. The pharmacological specificity of the D1 fluorescent antagonist was determined by competition experiments with an excess of unlabelled SCH 23390. This treatment significantly reduced the level of fluorescence of the retina confirming the specificity of the binding. We observed a homogeneously distributed fluorescence signal in both plexiform layers in unfixed cryosections of fish, frog, turtle, rat and rabbit. Similar staining intensities of both plexiform layers were found in frog, turtle, rat and rabbit retina. In teleosts, the label of the outer plexiform layer was markedly more intense. Non-specific label was associated with photoreceptor outer and inner segments. The specific labelling of both plexiform layers indicates a mismatch of dopamine releasing and D1-binding sites, and suggests a possible extrasynaptic localization of the D1-receptor. The physiological significance of the observed distribution of D1-ligand binding sites is discussed with respect to the role of dopamine in controlling adaptational processes in the retina.     

Activation of Nrf2/HO-1 by Peptide YD1 Attenuates Inflammatory Symptoms through Suppression of TLR4/MYyD88/NF-κB Signaling Cascade

In this study, we investigate the immunomodulatory effects of a novel antimicrobial peptide, YD1, isolated from Kimchi, in both in vitro and in vivo models. We establish that YD1 exerts its anti-inflammatory effects via up-regulation of the Nrf2 pathway, resulting in the production of HO-1, which suppresses activation of the NF-κB pathway, including the subsequent proinflammatory cytokines IL-1β, IL-6, and TNF-α. We also found that YD1 robustly suppresses nitric oxide (NO) and prostaglandin E2 (PGE₂) production by down-regulating the expression of the upstream genes, iNOS and COX-2, acting as a strong antioxidant. Collectively, YD1 exhibits vigorous anti-inflammatory and antioxidant activity, presenting it as an interesting potential therapeutic agent.     

Exploring the Relationship Between Green Consumption Value,Satisfaction, and Loyalty to Hybrid Car in Elderly Consumers

The study aimed to examine the relationship between green consumption value, satisfaction, and loyalty of driving hybrid cars among elderly consumers. Data were collected from a cross‐sectional survey of 314 elderly consumers who purchased hybrid cars in the United States. A partial least squares analysis revealed that elderly consumers’ social, price, and quality values positively influenced the satisfaction of their hybrid car experience, and their satisfaction significantly influenced their loyalty of hybrid car. The relationship between green consumption value, satisfaction, and loyalty toward driving hybrid cars among elderly consumers revealed insight into their value orientations toward the hybrid car. Special efforts are suggested in promoting hybrid car use to elderly consumer groups. Marketers should pay attention to changing beliefs and increasing perceived values of driving a hybrid car for consumers to encourage them to use green products.     

Central Aggregator Intrusion Detection System for Denial of Service Attacks

Vehicle-to-grid technology is an emerging field that allows unused power from Electric Vehicles (EVs) to be used by the smart grid through the central aggregator. Since the central aggregator is connected to the smart grid through a wireless network, it is prone to cyber-attacks that can be detected and mitigated using an intrusion detection system. However, existing intrusion detection systems cannot be used in the vehicle-to-grid network because of the special requirements and characteristics of the vehicle-to-grid network. In this paper, the effect of denial-of-service attacks of malicious electric vehicles on the central aggregator of the vehicle-to-grid network is investigated and an intrusion detection system for the vehicle-to-grid network is proposed. The proposed system, central aggregator–intrusion detection system (CA-IDS), works as a security gateway for EVs to analyze and monitor incoming traffic for possible DoS attacks. EVs are registered with a Central Aggregator (CAG) to exchange authenticated messages, and malicious EVs are added to a blacklist for violating a set of predefined policies to limit their interaction with the CAG. A denial of service (DoS) attack is simulated at CAG in a vehicle-to-grid (V2G) network manipulating various network parameters such as transmission overhead, receiving capacity of destination, average packet size, and channel availability. The proposed system is compared with existing intrusion detection systems using different parameters such as throughput, jitter, and accuracy. The analysis shows that the proposed system has a higher throughput, lower jitter, and higher accuracy as compared to the existing schemes.     

A 2‐in. a‐Si:H TFT‐LCD with embedded backlight control TFT sensors with various channel widths

Abstract— A 2.0‐in. a‐Si:H TFT‐LCD with embedded TFT sensors for the control of the backlight intensity according to the ambient light intensity has been developed. Two types of a‐Si:H TFT sensors with various channel widths were embedded into a TFT backplane with bottom‐ and top‐gate structures for measuring the ambient light and backlight illumination, respectively. The output signal, measured by a readout IC, increased with backlight intensity until 20,000 lux.     

The relationship between thermal decomposition properties of titanium hydride and the Al alloy melt foaming process

Using a new temperature programmed decomposition (TPD) theory and related experimental technique, a set of thermal decomposition kinetics equations of titanium hydride can be acquired by separating and simulating its TPD spectrum. According to these equations, the relation curve of decomposition quantity and time for titanium hydride at temperature of 940 K is obtained and the result coincides well with the Al alloy melt foaming process, which provides a scientific basis for controlling the Al alloy melt foam and then the Al alloy foams with different pore structure are successfully prepared.     

H.264/AVC baseline profile to MPEG‐4 visual simple profile transcoding to reduce the spatial resolution

In this study, we propose a heterogeneous transcoding method of converting an H.264/Advanced video coding (AVC) Baseline profile (BP) video bitstream into an MPEG‐4 Visual simple profile (VSP) video bitstream. The proposed method reduces the spatial resolution for mobile terminals, which support only low resolution video bitstreams. When the H.264/AVC BP video bitstream is transformed into the MPEG‐4 VSP video bitstream, the conversions between the H.264/AVC BP block types and the MPEG‐4 VSP block types are performed by analyzing the macroblocks (MBs) conversion probability and calculating the difference values of motion vector. The proposed transcoding method runs on average 5.5 times faster than the cascaded transcoding methods, for a degradation of the PSNR (peak‐signal‐to ratio) of less than 0.5 dB. © 2006 Wiley Periodicals, Inc. Int J Imaging Syst Technol, 16, 24–33, 2006