Antenna design and implementation for the future space Ultra-Long wavelength radio telescope

In radio astronomy, the Ultra-Long Wavelengths (ULW) regime of longer than 10 m (frequencies below 30 MHz), remains the last virtually unexplored window of the celestial electromagnetic spectrum. The strength of the science case for extending radio astronomy into the ULW window is growing. However, the opaqueness of the Earth’s ionosphere makes ULW observations by ground-based facilities practically impossible. Furthermore, the ULW spectrum is full of anthropogenic radio frequency interference (RFI). The only radical solution for both problems is in placing an ULW astronomy facility in space. We present a concept of a key element of a space-borne ULW array facility, an antenna that addresses radio astronomical specifications. A tripole–type antenna and amplifier are analysed as a solution for ULW implementation. A receiver system with a low power dissipation is discussed as well. The active antenna is optimized to operate at the noise level defined by the celestial emission in the frequency band 1 ? 30 MHz. Field experiments with a prototype tripole antenna enabled estimates of the system noise temperature. They indicated that the proposed concept meets the requirements of a space-borne ULW array facility.     

Impact of Reservoir Permeability,Permeability Anisotropy and Designed Injection Rate on CO2 Gas Behavior in the Shallow Saline Aquifer at the CaMI Field Research Station,Brooks, Alberta

Natural Resources Research - Carbon capture and storage is part of Canada’s climate change action plan to reduce greenhouse gas emissions. The Containment and Monitoring Institute Field...     

Geotechnical Hazards Associated with Desert Environment

The aridity of the Arabian Peninsula's deserts ranges between arid to hyperarid with hot dry climate, scarce precipitation and sparse vegetation. These harsh environmental conditions enhance some geomorphologic processes more than others, cause specific geotechnical problems, and increase desertification.From west to east, the general physiography of Saudi Arabia shows the Red Sea coastal plains and the escarpment foothills called Tihama followed by the Arabian Shield mountains, the Arabian Shelf plateau and finally the Arabian Gulf coastal plains. Sand moves by wind either as drifting sand or migrating dunes in four major sand seas, over the Arabian Shelf, and in the inter-mountain valleys, in the Arabian Shield causing problems of erosion and deposition. Human activities in the deserts may cause more instability to the sand bodies, enlarging the magnitude of the problem. Fine silty soil particles also move by wind, depositing loess mainly in selected areas downwind in the Tihama. These loess deposits subside and may form earth fissures by the process of hydrocompaction upon wetting. The addition of water can be either natural through storms or man-made through human agricultural or civil activities. Extensive sabkhas exist along the coastal plains of both the Red Sea and Arabian Gulf. The sabkha soil may also heave by salt re-crystallization or collapse by wetting. The shallow groundwater brines present in sabkhas also attack and corrode civil structures. Urbanization and excessive groundwater pumping may also deplete the fresh groundwater resources and may cause subsidence, ground fissuring and surface faulting as observed in some locations in the Arabian Shield. Although the average annual precipitation is very low, rain usually falls in the form of torrential storms, collected by dry valley basins and causing floods to unprotected downstream areas on the coastal plains of the Red Sea.The desert environment, being a fragile echo system, needs to be treated with care. Intercommunications between different national and international agencies and education of the layman should help to keep the system balanced and reduce the resulting environmental hazards. In addition, any suggested remedial measures should be planned with nature and engineered with natural materials.     

Causes of Land Subsidence in the Kingdom of Saudi Arabia

The occurrence of land subsidence in the Kingdom Saudi Arabia is either natural or man-made. Natural land subsidence occurs due to the development of subterranean voids by a solution of host rocks in carbonate and evaporite terrains, over many areas of Saudi Arabia. Man-induced land subsidence is either due to the removal of groundwater in the agricultural areas or to wetting of unstable soils. Therefore, earth fissures and a lowering of the ground surface in unconsolidated sediments took place in alluvial plains and volcanic vent terrains. Unstable soils include Sabkha soils and loess sediments. These types of soils occur in coastal plains, desert areas and volcanic terrains. When this soil is wetted either during agricultural activities, waste disposal or even during a rain storm, subsidence takes place due to either the removal of salts from the Sabkha soil or the rearrangement of soil particles in loess sediments.     

Karst Hazard Assessment of Eastern Saudi Arabia

Karst phenomena exist in areas in the eastern part of Saudi Arabia, forming solution features such as sinkholes, collapsed dolines and solution caverns, as a result of the chemical leaching of the carbonate and evaporite formations by percolating water. The instability of these karst phenomena could produce land subsidence problems. This paper reviews the geology of documented karstic rock units in Saudi Arabia and proposes a simple engineering classification of the solution features characteristic of limestone. Two case histories in the Dhahran area, eastern Saudi Arabia, will be used as examples for the application of a modified engineering classification.     

Ressi experimental catchment: Ecohydrological research in the Italian pre-Alps

Ressi is a small (2.4 ha) forested catchment located in the Italian pre-Alps. The site became an experimental catchment to investigate the water fluxes in the soil–plant–atmosphere continuum and the impact of vegetation on runoff generation in 2012. The elevation of the catchment ranges from 598 to 721 m a.s.l. and the climate is humid temperate. The bedrock consists of rhyolites and dacites; the soil is a Cambisol. The catchment is covered by a dense forest, dominated by beech, chestnut, maple, and hazel trees. The field set up includes measurements of the rainfall in an open area, streamflow at the outlet, soil moisture at various depths and locations, and depth to water table in six piezometers at a 5- or 10-min interval. Samples of precipitation, stream water, shallow groundwater and soil water are collected monthly for tracer analysis (stable isotopes (²H and ¹⁸O), electrical conductivity and major ions), and during selected rainfall–runoff events to determine the contribution of the various sources to runoff. Since 2017, soil and plant water samples have been collected to determine the sources of tree transpiration. Data collected in the period 2012–2016 are publicly available. Data collection is ongoing, and the data set is expected to be updated on an annual basis to include the most recent measurements.     

Integrating cellular automata,artificial neural network,and fuzzy set theory to simulate threatened orchards: application to Maragheh,Iran

Urbanization processes challenge the growth of orchards in many cities in Iran. In Maragheh, orchards are crucial ecological, economical, and tourist sources. To explore orchards threatened by urban expansion, this study first aims to develop a new model by coupling cellular automata (CA) and artificial neural network with fuzzy set theory (CA–ANN–Fuzzy). While fuzzy set theory captures the uncertainty associated with transition rules, the ANN considers spatial and temporal nonlinearities of the driving forces underlying the urban growth processes. Second, the CA–ANN–Fuzzy model is compared with two existing approaches, namely a basic CA and a CA coupled with an ANN (CA–ANN). Third, we quantify the amount of orchard loss during the last three decades as well as for the upcoming years up to 2025. Results show that CA–ANN–Fuzzy with 83% kappa coefficient performs significantly better than conventional CA (with 51% kappa coefficient) and CA–ANN (with 79% kappa coefficient) models in simulating orchard loss. The historical data shows a considerable loss of 26% during the last three decades, while the CA–ANN–Fuzzy simulation reveals a considerable future loss of 7% of Maragheh’s orchards in 2025 due to urbanization. These areas require special attention and must be protected by the local government and decision-makers.     

Experimental Evaluation of Construction Waste and Ground Granulated Blast Furnace Slag as Alternative Soil Stabilisers

In this study, the effect of ground granulated blast furnace slag (GGBFS) and recycled construction waste (CW) on bentonite clay stabilisation were investigated. The unconfined compressive strength (UCS) of specimens was evaluated with different combinations of GGBFS and CW over various curing periods. A series of micro analysis tests consisting of scanning electron microscope, energy dispersive spectrometer and X-ray diffraction were also conducted to determine the microstructural arrangement and mineralogical effect of the stabilisation treatment. The UCS results showed an increment in strength after introduction of GGBFS and CW and the longer curing period produced more pronounced results. The optimum additive ratio was calculated as 5 % of slag and 20 % of construction waste under all curing conditions. The micro analytical results also indicated formation of structural bonds between admixtures and bentonite in stabilised specimens, as slag crystals and bentonite particles were observed to occupy the cavities and vesicles on the construction waste grains. However, the experimental data shows that the strength improvement is not significant with the addition of only construction waste.     

The effect of specimen diameter size on uniaxial compressive strength,P-wave velocity and the correlation between them

Estimation of uniaxial compressive strength (UCS) by P-wave velocity (V_P) is of great interest to geotechnical engineers in various design projects. The specimen diameter size is one of the main factors that influence rock parameters such as UCS and V_P. In this study, the diameter size of specimens that effect UCS and V_P is investigated. Moreover, the correlation between UCS and V_P are examined via empirical analysis. For this purpose, 15 travertine samples were collected and core specimens with a diameters size of 38, 44, 54, 64 and 74 mm were prepared. Then, uniaxial compressive strength and P-wave velocity tests were conducted according to the procedure suggested by ISRM (1981). It is concluded that the diameter size of the specimen has a significant effect on UCS and V_P. Moreover, it was found that the best correlation between relevant parameters obtained for the specimen diameter of 38 mm.