CO<Subscript>2</Subscript> Flux Measurements over the Sea Surface by Eddy Correlation and Aerodynamic Techniques

The measurements of the vertical transport of CO₂ were carried out over the Sea of Japan using the specially designed pier of Kyoto University on September 20 to 22, 2000. CO₂ fluxes were measured by the eddy correlation and aerodynamic techniques. Both techniques showed comparable CO₂ fluxes during sea breeze conditions: −0.001 to −0.08 mg m⁻²s⁻¹ with the mean of −0.05 mg m⁻²s⁻¹. This means that the measuring site satisfies the fetch requirement for meteorological observations under sea breeze conditions. Moreover, the eddy diffusivity coefficient used in the aerodynamic technique is found to be consistent with the coefficient used in the eddy correlation technique. The present result leads us to conclude that the aerodynamic technique may be applicable to underway CO₂ flux measurements over the ocean and may be used in place of the bulk technique. The important point is the need to maintain a measuring accuracy of CO₂ concentration difference of the order of 0.1 ppmv on the research vessels or the buoys.     

The role of Nuta (large amorphous particles) as a nutrient regenerator in Osaka Bay

Large amorphous particles (Nuta) observed in coastal areas after phytoplankton blooms and red tide outbreaks were collected by Nuta traps. These particles are always thickly attached to mooring ropes and/or fishing nets. From the decomposition experiments of Nuta and the sinking particles, dissolved inorganic nitrogen (DIN) and dissolved inorganic phosphorus (DIP) regenerations were active in Nuta, but were not active in sinking particles. In Nuta, regeneration abundances during 10 days were 567 g-N/mg of initial particulate organic nitrogen (PON), and 583 -P/mg of initial particulate phosphorus (PP), respectively. Thus DIP was more regenerated from Nuta than DIN. Ten days integral regeneration abundances of DIN and DIP from Nuta were estimated to be 36% and 79% of in situ DIN and DIP standing stocks, respectively. Nuta contributes an important role of nutrient regeneration particularly DIN, in coastal water. Carbon and nitrogen stable isotope ratios of suspended particles, sinking particles and Nuta indicated that these three different type of particles were almost the same origin, and thus Nuta in the coastal water should be made from phytoplankton debris.     

Seasonal and Spatial Variations of Iceberg Drift off Dronning Maud Land, Antarctica, Detected by Satellite Scatterometers

Seasonal and spatial variations of iceberg drift were studied using continuous satellite scatterometer images off Dronning Maud Land, East Antarctica. Generally, iceberg drift speed showed a westward increase to the Greenwich Meridian. Seasonal variations of the drift speed were high in autumn—early winter and low in spring, and their magnitudes also increased westward. Seasonal variations of the drift speed were significantly correlated with variations of sea levels at Syowa and Mawson Stations, and hence qualitatively consistent with geostrophic current variations. Thus, the scatterometer data are demonstrated to be useful in monitoring iceberg trajectory and oceanic current variations. This revised version was published online in July 2006 with corrections to the Cover Date.     

Semidiurnal Dynamics of Salinity, Nutrients and Suspended Particulate Matter in an Estuary in the Seto Inland Sea, Japan, during a Spring Tide Cycle

The physical and chemical variability of the water column at subtidal station of an estuary in the Seto Inland Sea, Japan, was studied over a 24-hour period during a spring tide (tidal range ca. 2 m) in May 1995. Surface water and several depths through the water column were monitored every one and two hours, respectively. At each occasion, water temperature, salinity and dissolved oxygen concentration were measured and water samples were collected for the determination of nutrients and suspended particulate matter (SPM). Disruptive changes in the physical and chemical characteristics of the water was produced by the tidal cycle and the mixing of water masses of different origin. These changes were highly significant both spatially and temporally, yet with varying effects on physical parameters, nutrients and the different components of SPM. Significant differences in nutrient concentrations were also observed when the data-set was divided into ebb and flood components, irrespective of the depth. Nitrate and nitrite rose to 1.8 times higher during the flood. Spatial differences of SPM were less marked than those of nutrients, only particulate organic carbon (POC) being significantly higher at the surface than in the intermediate and the lower layer. Both POC and pheopigment concentrations increased markedly through the water column, being highest shortly before the lower low tide. In contrast, suspended solid (SS) content increased sharply after the lower low tide (>40 mg l⁻¹) and this coincided with a marked decrease of the C/SS content (<20 mg g⁻¹). The lagtime between POC and SS tidal transport was caused by particle resuspension from the exposed intertidal sediments as the tidal level rose, and particle transport selection in relation to the tidal state. This revised version was published online in August 2006 with corrections to the Cover Date.     

Preparation of a New Geological Survey of Japan Geochemical Reference Material: Coral JCp-1

A new geochemical reference material, coral Porites sp. JCp-1 has been prepared by the Geological Survey of Japan (GSJ). Provisional values for twenty one major, minor and trace elements are presented. The homogeneity tests showed that all elements studied are considered to be homogeneously distributed.     

The use of microstructures for discriminating turbiditic and hemipelagic muds and mudstones

The microstructures of turbiditic and hemipelagic muds and mudstones were investigated using a scanning electron microscope to determine whether there are microstructural features that can differentiate turbiditic from hemipelagic sedimentary processes. Both types of muddy deposits are, in general, characterized by randomly‐oriented clay particles. However, turbiditic muds and mudstones also characteristically contain aggregates of ‘edge‐to‐face’ contacts between clay particles with long‐axis lengths of up to 30 μm. Based on observations of the clay fabric of the experimentally‐formed muds settled from previously agitated muddy fluids, these types of aggregates, hereafter referred to as ‘aggregates of clay particles’, are interpreted as having been formed by the collision of component flocs in turbulent fluids. Furthermore, some aggregates of clay particles have ‘face‐to‐face’ contacts between clay particles; this is similar to face‐to‐face aggregates characteristically developed in fluid‐mud deposits that are commonly recognized only in turbiditic mudstones, indicating the possibility of a final stage of deposition under highly‐dense conditions, such as temporary fluid muds. In conjunction with earlier proposed lithofacies‐based and ichnofacies‐based criteria, aggregates of clay particles should be useful for the differentiation of turbiditic and hemipelagic muddy deposits, particularly with limited volumes of non‐oriented samples from deep‐water successions.     

Determination of Cadmium and Lead in Seventy-seven Geological Reference Samples by Atomic Absorption Spectrometry

The cadmium and lead contents of seventy-seven geological reference samples have been determined by atomic absorption spectrometry using an air-acetylene flame or a carbon tube atomizer, after extraction of cadmium and lead as iodides with methylisobutylketone (MIBK). The agreement between the present results and published data is generally good.     

Determination of Arsenic and Antimony in Eighty-Five Geochemical Reference Samples by Automated Hydride Generation and Electrothermal Atomic Absorption Spectrometry

The arsenic and antimony contents of 85 geochemical reference samples have been determined by atomic absorption spectrometry with hydride generation and heated quartz cell atomizer. The sample is decomposed with a mixture of perchloric, nitric and hydrofluoric acids and potassium permanganate solution; interferences are eliminated by addition of potassium iodide, aluminium chloride and ascorbic acid. The agreement between the present results and published data is fairly good.     

Determination of Beryllium in Eighty Geological Reference Samples by Atomic Absorption Spectrometry

The beryllium content of eighty geological reference samples has been determined by atomic absorption spectrometry using a nitrous oxide-acetylene flame or a carbon tube atomizer, after extraction of beryllium as acetylacetonate with methylisobutylketone (MIBK). The agreement between the present results and published data is generally good.