The effects of R-75,317 on antiglomerular basement membrane glomerulonephritis in rats

Platelet-activating factor (PAF) is a potent inflammatory mediator which is released by various inflammatory cells and produced by certain tissues, including the kidney. PAF has been shown to increase glomerular permeability to protein and to decrease glomerular filtration rate (GFR) by contracting mesangium. On the basis of these observations, it has been suspected that PAF may play a role as mediator of glomerular damage in glomerular nephritis. To examine this possibility, we studied the effects of a specific PAF antagonist, R-75,317, on the development of an experimental model of anti-glomerular basement membrane (anti-GBM) glomerulonephritis. Glomerulonephritis was initiated by injecting rabbit anti-rat GBM serum into rats. Proteinuria gradually developed after serum injection, plateaued at week 2, and remained at the high level of week 2 throughout the experimental period (6 wk). Chronic treatment with R-75,317 (10 mg/kg/day i.p.) tended to delay the onset of proteinuria and significantly accelerated the recovery phase. Creatinine clearance (Ccr) fell to 40% at week 3. R-75,317 treatment completely prevented this decline of Ccr. Histological changes in this model (glomerular hypertrophy, proliferation of mesangial matrix and interstitial fibrosis) were also ameliorated by the R-75,317 treatment. The results suggest that PAF may play a role in the development of glomerulonephritis and that PAF antagonists could be used in the treatment of human renal disease. Based on a paper presented at the Third International Conference on Platelet-Activating Factor and Structurally Related Alkyl Ether Lipids, May 1989.     

Pulsed NMR study in nuclear ordered solid3He

The nuclear spin dynamics in nuclear spin ordered solid³He in low magnetic fields on the melting curve has been studied by pulsed NMR down to 0.6 mK. The free induction decay signals (FID) were measured in single crystals of solid³He at three operating frequencies of 920, 1380, and 1840 kHz. The FIDs were nonexponential and dependent on the rf pulse strength _p H ₁ t _w , where is the gyromagnetic ratio,H ₁ is the rf field strength, andt _w is the pulse width. At small _p they decayed almost linearly in time with a small exponential tail at the end. When _p was further increased they became shorter and neither exponential nor linear in time. At large _p they decayed very rapidly and sometimes could not be observed at all because of the dead time of the NMR detection system. Such behavior of the FID was observed in many different single crystals in the given temperature range at 920 kHz. Tsubota and Tsuneto have shown by solving the nonlinear equations of motion numerically that the motion of the nuclear spin becomes chaotic when the tipping angle exceeds a critical value. Comparing their result with our experimental results, we concluded that some of the results of the rapid decay of the FID at large _p might be attributed to the onset of the chaotic motion. At 1840 kHz it is expected that the nonlinear effects in the equations of motion become less effective than that at 920 kHz. In fact, at this operating frequency the FIDs even at large _p and the tipping angle-dependent frequency shift could be observed. These frequency shifts were in rather good agreement with Namaizawa's theory provided an effective tipping angle was taken into account.     

Experimental analyses for electronic structure of barium zirconate-strontium zirconate proton-conducting solid solution

In proton-conducting oxides, analyses for their electronic structure contribute to the understanding of interactions between defects in them. In this study, electronic band alignment of (1−x)BaZr_0.8Y_0.2O_3−δ(BZY)–xSrZr_0.95Y_0.05O_3−δ(SZY) proton-conducting solid-solution system (BSZY) which has high defect concentration and the deep valence band is experimentally investigated. By using thin-film specimens for optical absorption measurements, absorption edges derived from electron transition from the valence band to the conduction band which was insensitive to the proton incorporation were clearly observed in spite of the high defect concentration. The obtained optical band gap energy increased from 5.61 to 5.89 eV with increasing x, which was consistent with a composition dependence of Zr(Y)O₆ octahedral tilting. Ultraviolet photon-yield spectroscopy (UV-PYS) measurements under vacuum condition revealed that BZY and SZY had ionization energy of 6.98 and 7.31 eV, respectively, and thus the absolute energy levels of the valence band maximum and the conduction band minimum of BSZY were experimentally clarified. We propose that the combination of the optical absorption measurements using thin-film specimens and the UV-PYS measurements under vacuum condition is effective in evaluating fundamental electronic structures of proton-conducting oxides.     

Negative emotion recognition using multimodal physiological signals for advanced driver assistance systems

Artificial Life and Robotics - Recent advanced driver assistance systems’ (ADASs) control cars to avoid accidents, but few of them consider driver’s comfort. To realize comfortable...     

Effects of 4He impurities on 3He nuclear spin-lattice relaxation in hcp solid 3He

Nuclear spin-lattice relaxation properties of hcp solid ³He with ⁴He impurities have been studied. At temperatures below the exchange plateau region, three kinds of relaxation time were observed. To analyze the data, a phenomenological four-bath model was developed, the four baths being the Zeeman bath, the phonon bath, an X-bath, and a Y-bath. The X-bath consists of the exchange bath and a part of the ⁴He-⁴He elastic interaction bath. The Y-bath is the main part of the elastic interaction bath. We measured the concentration dependence of the energy constants of all the baths, as well as the temperature and concentration dependences of the three kinds of relaxation time. The relaxation behavior corresponding to the process between the X-bath and the Y-bath could not be expressed by a single exponential function of time and the relaxation rate was strongly dependent on the concentration. This process may be related to the internal thermal equilibrium process within the elastic interaction bath. The impurity-dependent relaxation time between the X-bath and the phonon bath had a temperature dependence of T ^–n with n = 7.4±0.3.     

Construction of ULT-MRI cryostat for ultra low temperature physics

No Heading We have constructed an Ultra Low Temperature cryostat for Magnetic Resonance Imaging (ULT-MRI) applicable for various condensed phases of ³He at ultra low temperature, such as Nuclear Ordered Solid ³He or superfluid ³He. In contrast to conventional MRI for general use, where a pulsed-field gradient method is commonly used, we used a steady-field gradient method to avoid eddy current heating to metal parts at ultra low temperature. To avoid nonlinear response from the nuclear ordered spin system, which contradicts a principle of conventional MRI, we employed Free Induction Decay (FID) after a small tipping angle RF pulse to obtain the spectrum.PACS numbers: 07.20Mc, 67.57.Lm, 67.80.Jd, 76.60.Pc, 83.85.Fg     

Development of smart composite structures with small-diameter fiber Bragg grating sensors for damage detection: Quantitative evaluation of delamination length in CFRP laminates using Lamb wave sensing

The authors and Hitachi Cable, Ltd. have recently developed small-diameter optical fiber and its fiber Bragg grating (FBG) sensor for embedment inside a lamina of composite laminates without strength reduction. The outside diameters of the cladding and polyimide coating are 40 and 52 μm, respectively. First, a brief summary is presented for applications of small-diameter FBG sensors to damage monitoring in composite structures. Then, we propose a new damage detection system for quantitative evaluation of delamination length in CFRP laminates using Lamb wave sensing. In this system, a piezo-ceramic actuator generates Lamb waves in a CFRP laminate. After the waves propagate in the laminate, transmitted waves are received by an FBG sensor attached on or embedded in the laminate using a newly developed high-speed optical wavelength interrogation system. This system was applied to detect interlaminar delamination in CFRP cross-ply laminates. When the Lamb waves passed through the delamination, the amplitude decreased and a new wave mode appeared. These phenomena could be well simulated using a finite element analysis. From the changes in the amplitude ratio and the arrival time of the new mode depending on the delamination length, it was found that this system could evaluate the delamination length quantitatively. Furthermore, small-diameter FBG sensors were embedded in a double-lap type coupon specimen, and the debonding progress could be evaluated using the wavelet transform.     

High Temperature Schottky Barrier on n-Type SrTiO3 and Its Sensitivity to Ambient Gases

Metal or oxide electrodes (Pt, Au, Ag, (La, Sr)CoO₃) were deposited on single crystals of 0.02 mol% Nb doped SrTiO₃ by pulsed laser deposition. Current-voltage and capacitance-voltage responses were measured using three-terminal electrode configuration. Under high oxygen partial pressures, clear rectification behaviors were observed. Diffusion model well explained the current vs. voltage relationship with ideality factors close to unity. The barrier height varied reversibly with oxygen partial pressure, and was almost independent of the electrode materials, which suggested that the Fermi level at the interface was pinned by the surface states. The origin of the surface states was discussed in terms of oxygen adsorption or oxidative formation of metal vacancies around the surface. Chemical interaction between the surface and oxygen and resulting cation rearrangement was concluded to play an important role from the long stabilization time on oxygen partial pressure change. The water vapor pressure dependence of the barrier height was also explained by competitive adsorption of oxygen and water.     

Thermal behaviour and particle size evaluation of primary clusters in a water-based magnetic fluid

This paper reports the experimental research on thermal behaviour and particle size evaluation of primary clusters of ferromagnetic nano-particles in a water-based magnetic fluid. The magnetic fluids are suspensions of ultra fine particles coated with a molecular layer of dispersant in a liquid carrier such as water or kerosene. The particles are coated with single- or double-layer of surfactant to achieve stable dispersion. Numerous experimental studies have indicated the existence of the primary cluster of ferromagnetic nano-particles in a water-based magnetic fluid. The purpose of this research is to evaluate the particle size of the primary clusters by applying the Einstein's equation for Brownian motion assuming that the primary cluster has a spherical-shape. The thermal behaviour of ferromagnetic nano-particles in magnetic fluids is investigated through the micro visualization using the optical darkfield microscope system and particle tracking velocimetry data processing system. Real-time visualization of the Brownian motion of primary clusters in a water-based magnetic fluid was carried out. The experimental results clarified that the primary cluster size depends upon the concentration of the ferromagnetic nano-particle in the magnetic fluid.     

Detection method of emerging leading papers using time transition

To survive worldwide competitions of research and development in the current rapid increase of information, decision-makers and researchers need to be supported to find promising research fields and papers. But finding those fields from an available data in too much heavy flood of information becomes difficult. We aim to develop a methodology supporting to find emerging leading papers with a bibliometric approach. The analyses in this work are about four academic domains using our time transition analysis. In the time transition analysis, after citation networks are constructed, centralities of each paper are calculated and their changes are tracked. Then, the centralities are plotted, and the features of the leading papers are extracted. Based on the features, we proposed ways to detect the leading papers by focusing on in-degree centrality and its transition. This work will contribute to finding the leading paper, and it is useful for decision-makers and researchers to decide the worthy research topic to invest their resources.