变压吸附(PSA)空分制氧技术进展

论述了 PSA法空分制氧分子筛的开发现状和制氧工艺的进展 ,为 PSA法空分制氧今后的发展提出了研究方向     

Measurement of longitudinal distribution of solids holdup in a three-phase fluidized bed by ultrasonic technique

A method of measurement of solids holdup in a three-phase reactor by analyzing the shape and the phase lag or lead of an ultrasonic wave has been proposed. The solids holdup in a solids-dilute three-phase fluidized bed could be measured without being affected by the presence of gas bubbles. The experimental values of solids axial dispersivity measured by the ultrasonic technique are in reasonable agreement with an empirical correlation of previous data obtained by other methods. The possibility of the application of the ultrasonic technique to the measurement of solids holdup in a three-phase fluidized bed has been suggested.     

逆凝聚包覆法制备硫黄调节型粉末氯丁橡胶 Ⅰ.粒径分布

采用逆凝聚包覆法制备硫黄调节型粉末氯丁橡胶(PCR)并考察加料方式、搅拌转速和胶乳加人流速对产物粒径分布的影响。建立氯丁胶乳的逆凝聚粉末化模型并采用均匀试验设计的方法对该模型进行了验证。验证结果表明，该模型可以有效地模拟PCR的逆凝聚包覆氯丁胶乳的粉末化过程。PCR产物中粒径1～3mm的中等粒子的质量分数仅与搅拌转速有关，表明湍流爆裂是产生中等粒子的主要原因，而带状拉伸则是产生较粗颗粒和细小粒子的主要原因。扫描电子显微镜观察发现，采用逆凝聚包覆法制备的PCR粒子为单颗连续粒子，即产物粒子由单颗胶乳液滴凝聚而成。     

Assessing the predictive capability of two‐phase models for the mechanical behavior of alumina/epoxy nanocomposites

A review of analytical modeling of particulate reinforcement is made as a prelude to the problem of microstructural inhomogeneity in nanocomposite materials. Noting the inevitability of dispersion nonuniformity, and variations in agglomerate morphology and filler‐matrix interaction, the need to question the application of such models to novel materials arises. Employing the mechanical properties of alumina/epoxy nanocomposites, with known dispersion characteristics, an evaluation of the predictive capability of various models for Young's modulus, strength, and failure strain is made. Comparison between models is accompanied by a discussion of the parameters used in the fitting of macroscopic behavior to microstructural features. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 98: 869–879, 2005     

某抽水蓄能电站下库进出水口水沙运动特性试验研究

利用河工模型对某抽水蓄能电站下库区进行了特征洪水过程及电站运行的联合模拟试验。试验表明在输沙槽与拦沙潜堰共同作用下,电站进出水口的含沙量得到有效控制。在来水含沙量低于3kg/m3时,进出水口含沙量都满足电站运行要求,但是在含沙量较高的洪水期,底部浑水会逆行至电站进出水口附近,导致过机含沙量较高,因此提出了增设非封闭式拦沙潜坝的修改方案。修改方案改善了进出水口前的水流结构,起到了良好的拦沙截淤作用,进出水口前含沙量及泥沙淤积大幅减少,蓄能期过机含沙量降低13%~22%。在含沙量较大的洪水期,电站不宜抽水运用,但适时采用发电运行有助于减轻下库进出水口前的泥沙淤积。     

云南蒋家沟黏性泥石流输沙的涨落特征

间歇性阵流是山区小流域发生的黏性泥石流活动的基本形式,其输沙特性表现出一定的间歇性和涨落特性,其涨落可达均值的2~4个数量级。利用Hurst指数分析了蒋家沟近50年的数千阵泥石流观测资料,发现间歇性阵流的流量、径流量、输沙量序列的Hurst指数均大于0.5,说明序列具有一定程度的长程关联性。同时,对比阵流序列与洪峰序列,发现泥石流阵流的长程关联性强于洪峰序列。另一方面,输沙量的累积百分比均满足统一的指数分布形式:P(S)=CS~(-μ)exp(-S/S_c),其中μ越大意味着序列中输沙量较小的阵次越多;S_c表示的是阵流输沙的涨落情况,即S_c越大,阵流输沙的涨落越大。     

聚氨酯弹性体材料现状与展望

简介2002年国内外聚氨酯弹性体材料消费状况,着重介绍近几年发展迅速的几种聚氨酯弹性体材料如氨纶、铺面材料、防水涂料、密封胶及嵌缝材料、CPU、TPU和MPU。     

Regeneration of zinc particles for zinc–air fuel cells in a spouted-bed electrode

Fuel cells wherein zinc particles form a negative electrode and a gas-diffusion electrode (air electrode) is the positive electrode, are under development. Such cells are dependent on the regeneration of the zinc particles (and electrolyte). This paper describes experiments on electrolytic cells equipped with spouted bed cathodes for use in this application. Experiments have been carried out on laboratory scale cells to determine the operability of cells for growing 'seed particles in the range from 0.4 to 1 mm to measure cell voltage and current efficiency (and thereby energy consumption rate), and to identify a suitable material that could be used as a diaphragm (separating the spouted bed from the oxygen evolving anode). A larger cell, capable of producing up to 10 kg Zn per day, was designed and built. The larger cell was run successfully fifteen times and showed cell voltages and energy consumption rates comparable with those of smaller cells.     

含油废水处理技术的研究进展

根据油类物质在水中的存在形式及特征,介绍了含油废水的各种处理方法,如气浮、絮凝、吸附等,同时指出各种方法的优势和存在的问题,并介绍了最新的发展状况,提出对含油废水处理的一些建议和展望.     

水煤浆黏度的几种影响因素分析

研究了矿物质、粒度分布和搅拌强度对水煤浆黏度的影响.结果表明,实验使用的3种矿物质——高岭土、氧化铝和碳酸钙在降低水煤浆的黏度方面效果都比较明显,其中高岭土最显著,可以使黄陵水煤浆的黏度降低59.5%左右.适当的粒度级能有效改善浆体黏度,剪切率为116.5s-1时,枣庄煤级配制备的水煤浆的黏度值在820mPa·s~900mPa·s之间,而神准混煤级配制备的煤浆黏度值更低,处于500mPa·s~670mPa·s之间.同时搅拌强度的增加在一定范围内可以有效降低煤浆的黏度.