Investigation of nu(N-H) and nu(C-N) stretching modes of propylamine (C3H7NH2) in a binary system C3H7NH2 + CH3OH via concentration dependent Raman study and ab initio calculations

Raman spectra of propylamine (C3H7NH2) and its binary mixtures, C3H7NH2 + CH3OH with varying mole fractions of the reference system, C3H7NH2, C were recorded in two widely apart wavenumber regions, 3100-3600 cm(-1) and 1225-1325 cm(-1). In the former region, the two Raman bands at approximately 3305 and approximately 3326 cm(-1), obtained after the line shape analysis, which were assigned to symmetric nu(N-H) and anti-symmetric nu(N-H) stretching modes, respectively, show a downshift upon dilution. However, whereas the nu(N-H) anti-symmetric mode shows a shift of 18.6 cm(-1), the nu(N-H) symmetric mode shows a much smaller shift (5.7 cm(-1)) between neat liquid and high dilution, C = 0.1. This aspect has been explained using the optimized geometries calculated employing ab initio theory (MP2 level) for the neat C3H7NH2 and its different hydrogen-bonded complexes. The linewidth versus concentration plot for the nu(N-H) anti-symmetric stretching mode, however exhibits a distinct maxima at C = 0.4, which has been explained as a slight departure from the concentration fluctuation model. In the latter region, a symmetric peak is observed, which corresponds to nu(C-N) stretching mode, which shows an upshift upon dilution and an almost linear concentration dependence. This has also been explained in terms of the parameters obtained from the optimized geometries of the different hydrogen-bonded complexes.     

Performances and limitations of the HRMS method for dioxins, furans and dioxin-like PCBs analysis in animal feedingstuffs: Part I: Results of an inter-laboratory study

The European strategy for dioxin monitoring of the food chain has defined high-resolution gas chromatography coupled to high-resolution mass spectrometry (HRGC/HRMS) method as the confirmatory method that can provide reliable and comparable results at sub-parts per trillion (ppt) level. This paper describes the first inter-laboratory study on dioxins, furans and dioxin-like PCBs by HRGC/HRMS method in animal feedingstuffs. Two different statistical approaches (ISO 5725 and Cofino’s statistics) were used for the statistical evaluation. For this particular study, the performances of the HRGC/HRMS method seem to be congener-independent in repeatability and reproducibility conditions over a concentration range covering more than four orders of magnitude. Results clearly show the effect of precision loss below 0.1 ppt level per congener in repeatability conditions and below 0.2 ppt level per congener in reproducibility conditions. LODs reported by the laboratories give median values of 0.02 ng/kg for most of the toxic congeners. Relative standard deviation between the laboratories’ mean values using upper-bound approach for TEQ calculation is 6.2%, more than twice the maximum level set at 0.75 ng TEQ/kg of product.     

Validated HPLC–MS–MS method for determination of azithromycin in human plasma

A validated, highly sensitive, and selective HPLC method with MS–MS detection has been developed for quantitative determination of azithromycin (AZI) in human Na₂EDTA plasma. Roxithromycin (ROX) was used as internal standard. Human plasma containing AZI and internal standard was ultrafiltered through Centrifree Micropartition devices and the concentration of AZI was determined by isocratic HPLC–MS–MS. Multiple reaction monitoring mode (MRM) was used for MS–MS detection. The calibration plot was linear in the concentration range 2.55–551.43 ng mL⁻¹. Inter-day and Intra-day precision and accuracy of the proposed method were characterized by R.S.D and percentage deviation, respectively; both were less than 8%. Limit of quantification was 2.55 ng mL⁻¹. The proposed method was used to determine the pharmacokinetic profile of AZI (250-mg tablets).     

Novel aromatic carboxamides from dehydroabietylamine as potential fungicides: Design,synthesis and antifungal evaluation

The present study was carried out to design and synthesize a number of novel aromatic carboxamide derivatives of dehydroabietylamine. The preliminary antifungal assay indicated that most of title compounds displayed moderate to good antifungal activity toward the six fungal strains in vitro. Compounds 3i, 3q, 4b and 4d showed significant antifungal activity against Sclerotinia sclerotiorum, with EC₅₀ values ranging from 0.067 ～ 0.393 mg/L. Compounds 3i, 4b and 4d also showed pronounced mycelial growth inhibition activities against B. cinerea and A. solani. Furthermore, in the in vivo assay, compound 4b exhibited brilliant protective activity against S. sclerotiorum-infected rape leaves. Meanwhile, the in vivo bioassay on tomato plants infected by B. cinerea showed that compound 3i and 4d displayed excellent protective activity at 200 mg/L, which were near to boscalid. Primary mechanistic study revealed that 4b could inhibit sclerotia formation as well as reduce the exopolysaccharide level. SEM and TEM analysis indicated that 4b possessed a strong ability to destroy the surface morphology of mycelia, cell structure and seriously interfere with the growth of the fungal pathogen. In addition, 4b exhibited good inhibitory activity (IC₅₀ = 23.3 ± 1.6 μM) toward succinate dehydrogenase (SDH). Molecular modeling study confirmed the binding modes between compound 4b and SDH. The above antifungal results and fungicidal mechanism study revealed that this class of dehydroabietylamine derivatives could be potential SDH inhibitors and lead compounds for novel fungicides development.     

Toroid type high-pressure device: history and prospects

The Toroid type high-pressure device and its predecessor, the Chechevitsa (lentil) type high-pressure device, are known to be used efficiently for the synthesis of new materials in recent decades. It was through the Chechevitsa device the first ultradense modification of silica, ‘stishovite’, was obtained. Both devices were essential for the industrial production of superhard materials in the USSR and other socialist countries. In 1980s, almost half of the world synthetic diamond and c-BN products were manufactured by these devices. However, the application of the Toroid device for examining the structure and physical properties of highly compressed substances has been considerably less appreciated. Meanwhile, the device has some unique features that have made possible 35-years of an extensive investigation of physical properties of substances at pressures up to 150 kbar, including electron transport and thermodynamic properties, elastic characteristics, viscosity, thermo-conductivity and other physical properties. Also, the device has been widely employed for structural X-ray and neutron diffraction studies of many materials. But it is not until recently that the convenience of the Toroid device for physical studies has been fully recognized. Through this recognition, the Toroid type device is today becoming increasingly popular among the researchers in the field of high pressures around the world.     

Turbulence modelling and role of compressibility on oil spilling from a damaged double hull tank

The viscosity plays an important role, and a multiphase solver is necessary to numerically simulate the oil spilling from a damaged double hull tank (DHT). However, it is uncertain whether turbulence modelling is necessary, which turbulence model is suitable; and what the role of compressibility of the fluids is. This paper presents experimental and numerical investigations to address these issues for various cases representing different scenarios of the oil spilling, including grounding and collision. In the numerical investigations, various approaches to model the turbulence, including the large eddy simulation (LES), direct numerical simulation and the Reynolds average Navier–Stokes equation (RANS) with different turbulence models, are employed. Based on the investigations, it is suggested that the effective Reynolds numbers corresponding to both oil outflow and water inflow shall be considered when classifying the significance of the turbulence and selecting the appropriate turbulence models. This is confirmed by new lab tests considering the axial offset between the internal and the external holes on two hulls of the DHT. The investigations conclude for numerically simulating oil spilling from a damaged DHT that when the effective Re is smaller the RANS approaches should not be used and LES modelling should be employed; while when the effective Reynolds numbers is large, the RANS models may be used as they can give similar results to LES in terms of the height of the mixture in the ballast tank and discharge but costing much less CPU time. The investigation on the role of the compressibility of the fluid reveals that the compressibility of the fluid may be considerable in a small temporal‐spatial scale but plays an insignificant role on macroscopic process of the oil spilling. Copyright © 2016 John Wiley & Sons, Ltd.     

Rapid LC‐MS/MS determination and pharmacokinetic application of linarin in rat plasma

A sensitive, selective and robust liquid chromatography tandem mass spectrometry (LC‐MS/MS) method was developed for the rapid determination of linarin in rat plasma. Separation of the analyte and warfarin as internal standard (IS) from 100 μL rat plasma was carried out by simple protein precipitation treatment. Chromatographic separation of the analyte was performed on a Diamonsil® C₁₈ column (150 × 4.6 mm, 5 µm) using isocratic mobile phase consisting of methanol–0.5% formic acid (80:20, v/v). The flow rate was 0.6 mL/min and the total run time was not more than 4.0 min. The method was validated over a wide dynamic concentration range of 1.00–1000 ng/mL for linarin. The precision and accuracy values for linarin met the acceptance criteria according to US Food and Drug Administration guidelines. Linarin was stable in the stability studies including a long‐term test (?80°C for 43 days), a short‐term test (ambient for 2 h and autosampler for 8 h) and three freeze–thaw cycles (?80–25°C). The developed assay method was applied to the pharmacokinetic study in rats after a single intramuscular administration of 713 µg/kg linarin. Copyright © 2012 John Wiley & Sons, Ltd.     

Importance of verifying queue model assumptions before planning with simulation software

This case study uses empirical data gathered at an Australian refinery to verify the assumptions for queue distributions before using special-purpose software to plan the off-road-truck hauling of titanium dioxide to a refinery (n = 773). Easy-to-use spreadsheet software is utilized to verify assumptions for queue models. Managers are able to make decisions based on economic implications of queue models to avoid making costly planning mistakes. Analysts can use nonparametric hypothesis-testing techniques to verify distribution assumptions for optimization without having to write hard-to-maintain and complex algebraic linear equations or nonlinear search routines.     

Bioanalytical method development,validation and quantification of dorsomorphin in rat plasma by LC‐MS/MS

The present investigation describes the development and validation of a sensitive liquid chromatography–mass spectrometry/mass spectrometry (LC‐MS/MS) method for the estimation of dorsomorphin in rat plasma. A sensitive LC‐MS/MS method was developed using multiple reaction monitoring mode, with the transition of m/z (Q1/Q3) 400.2/289.3 for dorsomorphin and m/z (Q1/Q3) 306.2/236.3 for zaleplon. Chromatographic separation was achieved on a reverse phase Agilent XDB C₁₈ column (100 × 4.6 mm, 5 µm). The mobile phase consisted of acetonitrile and 5 mm ammonium acetate buffer (pH 6.0) 90:10 v/v, at a flow rate of 0.8 mL/min. The effluence was ionized in positive ion mode by electrospray ionization (ESI) and quantitated by mass spectrometry. The retention times of dorsomorphin and internal standard were found to be 2.13 and 1.13 min, respectively. Mean extraction recovery of dorsomorphin and internal standard in rat plasma was above 80%. Dorsomorphin calibration curve in rat plasma was linear (r² ≥ 0.99) ranging from 0.005 to 10 µg/mL. Inter‐day and intra‐day precision and accuracy were found to be within 85–115% (coefficient of variation). This method was successfully applied for evaluation of the oral pharmacokinetic profile of dorsomorphin in male Wistar rats. Copyright © 2013 John Wiley & Sons, Ltd.     

Identification,characterization and evolution of non-local quasi-Lagrangian structures in turbulence

The recent progress on non-local Lagrangian and quasi-Lagrangian structures in turbulence is reviewed. The quasi-Lagrangian structures, e.g., vortex surfaces in vis-cous flow, gas-liquid interfaces in multi-phase flow, and flame fronts in premixed combustion, can show essential Lagrangian following properties, but they are able to have topological changes in the temporal evolution. In addition, they can represent or influence the turbulent flow field. The challenges for the investigation of the non-local structures include their identification, characterization, and evolution. The improving understanding of the quasi-Lagrangian struc-tures is expected to be helpful to elucidate crucial dynamics and develop structure-based predictive models in turbulence.