水平磁系高梯度磁选机精矿管堵塞原因分析与改造

南京梅山选矿厂针对水平磁系高梯度磁选机在现场使用中暴露出的精矿管堵塞的问题，通过测量水平磁系高梯度磁选机不同位置的漏磁场强度，对磁系的漏磁场分布特性进行研究。研究得出，精矿管堵塞为漏磁场导致，从力场计算结果得出，磁系漏磁产生的最大磁场力可使粒度大于0.3 mm的磁铁矿颗粒在精矿管中发生沉积。     

Cyclic thermal shock resistance of h-BN composite ceramics with La2O3–Al2O3–SiO2 addition

The effects of La₂O₃–Al₂O₃–SiO₂ addition on the thermal conductivity, coefficient of thermal expansion (CTE), Young's modulus and cyclic thermal shock resistance of hot-pressed h-BN composite ceramics were investigated. The samples were heated to 1000 °C and then quenched to room temperature with 1–50 cycles, and the residual flexural strength was used to evaluate cyclic thermal shock resistance. h-BN composite ceramics containing 10 vol% La₂O₃–Al₂O₃ and 20 vol% SiO₂ addition exhibited the highest flexural strength, thermal conductivity and relatively low CTE, which were beneficial to the excellent thermal shock resistance. In addition, the viscous amorphous phase of ternary La₂O₃–Al₂O₃–SiO₂ system could accommodate and relax thermal stress contributing to the high thermal shock resistance. Therefore, the residual flexural strength still maintained the value of 234.3 MPa (86.9% of initial strength) after 50 cycles of thermal shock.     

Interfacial Crystallization of Diacylglycerols Rich in Medium‐ and Long‐Chain Fatty Acids in Water‐in‐Oil Emulsions

The effects of diacylglycerols rich in medium‐ and long‐chain fatty acids (MLCD) on the crystallization of hydrogenated palm oil (HPO) and formation of 10% water‐in‐oil (W/O) emulsion are studied, and compared with the common surfactants monostearoylglycerol (MSG) and polyglycerol polyricinoleate (PGPR). Polarized light microscopy reveals that emulsions made with MLCD form crystals around dispersed water droplets and promotes HPO crystallization at the oil‐water interface. Similar behavior is also observed in MSG‐stabilized emulsions, but is absent from emulsions made with PGPR. The large deformation yield value of the test W/O emulsion is increased four‐fold versus those stabilized via PGPR due to interfacial crystallization of HPO. However, there are no large differences in droplet size, solid fat content (SFC), thermal behavior or polymorphism to account for these substantial changes, implying that the spatial distribution of the HPO crystals within the crystal network is the driving factor responsible for the observed textural differences. MLCD‐covered water droplets act as active fillers and interact with surrounding fat crystals to enhance the rigidity of emulsion. This study provides new insights regarding the use of MLCD in W/O emulsions as template for interfacial crystallization and the possibility of tailoring their large deformation behavior. Practical Applications: MLCD is applied in preparing W/O emulsion. It is found that MLCD forms unique interfacial Pickering crystals around water droplets, which promote the surface‐inactive HPO nucleation at the oil‐water interface. Thus MLCD‐covered water droplets act as active fillers and interact with surrounding fat crystals, which can greatly enhance the rigidity of emulsion. This observation would provide a theoretical reference and practical basis for the application of the MLCD with appreciable nutritional properties in lipid‐rich products such as whipped cream, shortenings margarine, butter and ice cream, so as to substitute hydrogenated oil. MLCD‐stabilized emulsions can also be explored for the development of novel confectionery products, lipsticks, or controlled release matrices.     

Association of solid fuel use with risk of stunting in children living in China

Stunting adversely affects physical and mental outcomes of children. It has not been examined whether household air pollution from solid fuel combustion is a risk factor for stunting in children. In a total of 41,439 children aged 6-17 across China, height was measured using a unified protocol. Multivariable linear regression models and logistic regression models were used to assess the associations of solid fuel use for cooking/heating with stunting in children. Adjusted for covariates, cooking/heating with solid fuel was significantly associated with a lower z-score for height for age and sex (β = −0.21 [−0.32 to −0.09] and −0.17 [−0.31 to −0.03], respectively) and an increased risk of stunting with an estimated ORs of 1.34 [1.07~1.68] and 1.37 [1.02~1.83], respectively. The risk of stunting associated with solid fuel use was statistically significant in high-age children. And the effect was greater on girls than on boys, though the difference was not statistically significant. Our study suggested that Chinese children living in households using solid fuel had a significantly higher risk of stunting than those living in households using cleaner fuel.     

裂缝性孔隙介质频变AVAZ反演方法研究进展

由于尺度的限制,利用地震方法进行裂缝参数定量表征一直是地球科学的难题。基于裂缝性孔隙介质动态等效理论的频变AVAZ反演方法给出了研究思路。首先介绍了裂缝性孔隙介质的等效介质理论研究进展,分析比较了各种裂缝性储层岩石静态等效介质模型和动态等效介质模型;然后给出了基于Chapman模型的裂缝参数和渗透率定量表征的正问题数学模型以及反演问题求解的方法和策略,以及基于模型数据的数值计算结果;最后讨论了频变AVAZ反演方法目前存在的问题和进一步研究方向。     

NSGA-Ⅱ和NSGA-Ⅲ应用于换热网络多目标优化的对比

针对换热网络多目标优化问题，采用目前应用较广泛的两种多目标遗传算法，即NSGA-Ⅱ和NSGA-Ⅲ，对两种算法的性能进行对比研究。案例研究结果表明，NSGA-Ⅱ算法比NSGA-Ⅲ算法运行效率更高，NSGA-Ⅲ的运行时间是NSGA-Ⅱ的2倍以上；NSGA-Ⅱ算法的应用并不严格地受限于3个目标的最大目标数量，NSGA-Ⅱ在求解大于3个目标的多目标优化问题时也可能具有良好的性能，目标数量并非选择NSGA-Ⅱ和NSGA-Ⅲ算法的严格标准。对10×5换热网络案例进行4个相关目标改造优化时，从换热网络的单一性能指标来看，NSGA-Ⅱ算法更容易获得各目标的极值。从最小年度总费用的评价指标来看，两种算法的最优方案效果相近。对7×3换热网络案例进行6个目标的优化时，NSGA-Ⅲ算法得到各目标的极值较优。从最小年度总费用的评价指标来看，NSGA-Ⅲ算法获得的投资费用和年度总费用更小。对于目标函数数量不超过3个，或者3个以上具有一定相关性的多目标优化问题，推荐优先使用NSGA-Ⅱ算法实现快速寻优；而NSGA-Ⅲ算法由于其基于参考点的选择机制，运行效率较慢，更适合用于收敛困难的高维多目标优化问题。     

Single copper sites dispersed on hierarchically porous carbon for improving oxygen reduction reaction towards zinc-air battery

The demand for high-performance non-precious-metal electrocatalysts to replace the noble metal-based catalysts for oxygen reduction reaction(ORR)is intensively increasing.Herein,single-atomic copper sites supported on N-doped three-dimensional hierarchically porous carbon catalyst(Cu₁/NC)was prepared by coordination pyrolysis strategy.Remarkably,the Cu₁/NC-900 catalyst not only exhibits excellent ORR performance with a half-wave potential of 0.894 V(vs.RHE)in alkaline media,outperforming those of commercial Pt/C(0.851 V)and Cu nanoparticles anchored on N-doped porous carbon(CuNPs/NC-900),but also demonstrates high stability and methanol tolerance.Moreover,the Cu₁/NC-900 based Zn-air battery exhibits higher power density,rechargeability and cyclic stability than the one based on Pt/C.Both experimental and theoretical investigations demonstrated that the excellent performance of the as-obtained Cu₁/NC-900 could be attributed to the synergistic effect between copper coordinated by three N atoms active sites and the neighbouring carbon defect,resulting in elevated Cu d-band centers of Cu atoms and facilitating intermediate desorption for ORR process.This study may lead towards the development of highly efficient non-noble metal catalysts for applications in electrochemical energy conversion.     

Microenvironment and related genes predict outcomes of patients with cervical cancer: evidence from TCGA and bioinformatic analysis

Cervical cancer (CESC) is one of the most common cancers and affects the female genital tract. Consistent HPV infection status has been determined to be a vital cause of tumorigenesis. HPV infection may induce changes to the immune system and limit the host’s immune response. Immunotherapy is therefore essential to improving the overall survival of both locally advanced and recurrent CESC patients. Using 304 relevant samples from TCGA, we assessed immune cell function in CESC patients to better understand the status of both tumor micro-environment cells and immune cells in CESC. Functional enrichment analysis, pathway enrichment analysis, and PPI network construction were performed to explore the differentially expressed genes (DEGs). The analysis identified 425 DEGs, which included 295 up-regulated genes and 130 down-regulated genes. We established that upregulation of CCL5 was correlated with significantly better survival, meaning that CCL5 expression could serve as a novel prognostic biomarker for CESC patients. We further focused on CCL5 as a hub gene in CESC, as it had significant correlations with increased numbers of several types of immune cells. Cell-type fractions of M1 macrophages were significantly higher in the high-immune-scores group, which was associated with better overall survival. Finally, we concluded that CCL5 is a promising prognostic biomarker for CESC, as well as a novel chemotherapeutic target.     

喷雾干燥法制备材料论文的指导方案

喷雾干燥技术的突出特点是将液态物料瞬时干燥成固体粉末或者颗粒。我们课题组在指导本科生毕业论文中采用了喷雾干燥法制备碳包覆铌酸钛材料的实验,在实验过程中我们发现了一些问题,如喷雾干燥机需要适当预热、喷头容易堵赛和收集原料不干等问题。我们就以上问题进提出了相应的对策,这加深了本科生对喷雾干燥实验的体会和认识,培养了学生在独自实验时面对问题解决问题的能力。     

7050铝合金单峰时效热处理工艺及性能研究

利用材料相图及性能模拟软件JMatPro对7050铝合金进行模拟计算，得到7050铝合金的TTT和CCT曲线。合金的TTT曲线整体呈“C”形，GP区、亚稳相和稳定相鼻尖温度分别为140、330、380 ℃，对应的孕育时间为0.002、0.007、0.200 h，η′相无析出的临界冷却速率为2 ℃/s。采用力学性能和电镜组织观察的方法，研究7050铝合金单峰时效热处理工艺。结果表明:当温度达到485 ℃时，在DSC曲线上出现吸热峰；在120 ℃下进行时效处理，随着时效时间的延长，合金的强度硬度持续增加，合金断后伸长率先增加后减小，时效70 h未见过时效特征，当时效8 h时，合金强度和韧性有较好配合，抗拉强度为593 MPa，屈服强度为516 MPa，断后伸长率为12.6%，试样拉伸断口均呈现穿晶韧窝型断裂与沿晶断裂的混合式断口形貌。