首页 | 官方网站   微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   4392篇
  免费   175篇
  国内免费   20篇
工业技术   4587篇
  2023年   30篇
  2022年   12篇
  2021年   126篇
  2020年   59篇
  2019年   73篇
  2018年   90篇
  2017年   66篇
  2016年   116篇
  2015年   85篇
  2014年   130篇
  2013年   257篇
  2012年   259篇
  2011年   291篇
  2010年   244篇
  2009年   261篇
  2008年   288篇
  2007年   216篇
  2006年   215篇
  2005年   142篇
  2004年   153篇
  2003年   168篇
  2002年   148篇
  2001年   75篇
  2000年   80篇
  1999年   66篇
  1998年   84篇
  1997年   70篇
  1996年   70篇
  1995年   62篇
  1994年   53篇
  1993年   58篇
  1992年   55篇
  1991年   52篇
  1990年   33篇
  1989年   46篇
  1988年   16篇
  1987年   35篇
  1986年   21篇
  1985年   38篇
  1984年   21篇
  1983年   32篇
  1982年   33篇
  1981年   28篇
  1980年   16篇
  1979年   22篇
  1978年   25篇
  1977年   17篇
  1976年   10篇
  1975年   9篇
  1973年   8篇
排序方式: 共有4587条查询结果,搜索用时 46 毫秒
31.
Seiji Nomura  Takashi Arima 《Fuel》2008,87(15-16):3240-3246
In the case of the wet coal charging process in coke oven chamber, it is known that the coking process is uneven and a local carbonization delay occurs. The reason was investigated through a laboratory-scale experiment and a quantitative estimation. A partial carbonization test in a test coke oven replicated the uneven plastic layer and local carbonization delay. It was revealed that most of the gas generated in the uncarbonized coal layer results from the evaporation of condensed water and that steam can break through the plastic layer in a test coke oven. Moreover, the order estimation implied that steam that generates in the uncarbonized coal layer and breaks through the plastic layer has sufficient heat capacity to cool the heating wall and delay the carbonization. It was also shown that the steam pressure peak measured in a commercial coke oven is much lower than the estimated steam pressure in this study assuming steam not breaking through the plastic layer. The above-mentioned results and quantitative investigation strongly support the ‘steam breaking through the plastic layer’ theory proposed by Dr. Rohde that an uneven carbonization process is caused by vaporized coal moisture breaking through the plastic layer at definite, unforeseeable points, which results in cooling of the wall by the steam flow.  相似文献   
32.
A direct ethanol fuel cell (DEFC), which is less prone to ethanol crossover, is reported. The cell consists of PtRu/C catalyst as the anode, Nafion® 117 membrane, and Ni–Co–Fe (NCF) composite catalyst as the cathode. The NCF catalyst was synthesized by mixing Ni, Co, and Fe complexes into a polymer matrix (melamine-formaldehyde resins), followed by heating the mixture at 800 °C under inert atmosphere. TEM and EDX experiments suggest that the NCF catalyst has alloy structures of Ni, Co and Fe. The catalytic activity of the NCF catalyst for the oxygen reduction reaction (ORR) was compared with that of commercially available Pt/C (CAP) catalyst at different ethanol concentrations. The decrease in open circuit voltage (Voc) of the DEFC equipped with the NCF catalysts was less than that of CAP catalyst at higher ethanol concentrations. The NCF catalyst was less prone to ethanol oxidation at cathode even when ethanol crossover occurred through the Nafion®117 film, which prevents voltage drop at the cathode. However, the CAP catalyst did oxidize ethanol at the cathode and caused a decrease in voltage at higher ethanol concentrations.  相似文献   
33.
中国政府率先开始了手机充电器的标准化,其目的是让用户更换手机终端后可继续使用原来的充电器,从而通过削减废弃物达到保护环境的目的。  相似文献   
34.
Anatase-TiO2 cylindrical pellets were microwave sintered and partially transformed to rutile-TiO2.The rutile concentration profile was determined as a function of location within the pellet. The rutile distribution in the microwavesintered pellets was different from that in pellets sintered by conventional fast firing. Temperature profiles within the pellets were estimated using the irreversible nature of the anatase-rutile transformation. The estimated temperature profile within each pellet was not uniform. In the axial direction, maximum temperature occurred in the middle of the pellet. In the radial direction, maximum temperature occurred at 1 mm below the surface of the cylinder wall. Analysis of the temperature profile indicated that, although heat flow occurred in the microwave-sintered pellet, the temperature profile did not change during a microwave exposure of 5–90 min.  相似文献   
35.
A side-chain liquid-crystalline polymer (LCP) was synthesized by the addition of the mesogenic monomer to poly(methyl siloxane) in presence of a Pt-catalyst. When an aqueous solution of 10wt% ethanol was permeated through a LCP membrane by pervaporation at various temperatures, the permeation rate increased with increasing temperature and drastically changed at glass-nematic (Tg) and nematic-isotropic (TNI) transition temperatures of the LCP membrane. The LCP membrane exhibited the waterpermselectivity in the glassy and liquid-crystalline states. The ethanol concentration in the permeate increased with increasing permeation temperature and the LCP membrane changed from the waterpermselectivity to the ethanol-permselectivity around TNI. These results suggested that the permselectivity was influenced by the change of the LCP membrane structure, that is, its state transformation. It was found that a balance of the orientation of mesogenic groups and flexibility of siloxane chains is very important for the permeability and selectivity.  相似文献   
36.
37.
Temperature dependences of the soft phonon frequency and the damping constant in Tris-Sarcosine Calcium Chloride (TSCC) single crystal have been investigated between 5K and 100K by using a Fourier-transform far-infrared spectrometer. It has been observed that the soft phonon frequency decreases gradually and the damping constant increases as the transition temperature is approached from below The damping constant varies from 7cm-1 a 90K to less than 0.5cm-1 at 5K. It has been found that the damping constant is approximately proportional to temperature below about 60K.  相似文献   
38.
A computer program system was developed to predict carbohydrate-bindingsites on three-dimensional (3D) protein structures. The programssearch for binding sites by referring to the empirical rulesderived from the known 3D structures of carbohydrate–proteincomplexes. A total of 80 non-redundant carbohydrate–proteincomplex structures were selected from the Protein Data Bankfor the empirical rule construction. The performance of theprediction system was tested on 50 known complex structuresto determine whether the system could detect the known bindingsites. The known monosaccharide-binding sites were detectedamong the best three predictions in 59% of the cases, whichcovered 69% of the polysaccharide-binding sites in the targetproteins, when the performance was evaluated by the overlapbetween residue patches of predicted and known binding sites. Received April 24, 2003; revised June 2, 2003; accepted June 10, 2003.  相似文献   
39.
Recognition of hand drawn shapes is beneficial in drawing packages and automated sketch entry in handheld computers. In this paper, we propose a new approach to on-line geometric shape recognition with incremental training function, which utilizes a heuristic function to reduce noise and a neural network for classification and on-line training. Instead of recognizing segments of a drawing and then performing syntactical analysis to match with a predefined shape, which is weak in terms of generalization and dealing with noise, we examine the shape as a whole. The main concept of the recognition method is derived from the fact that internal angles are very important in the perceived shape of outlines. Our application's aim is to recognize elliptic, rectangular, and triangular shapes in a way similar to human cognition of these shapes. Human beings recognize such basic shapes regardless of the variations in size, noise on the shape border, rotation and in the case of triangles, regardless of the type of the triangle. The key concept is that the neural network learns the relationships between the internal angles of a shape and its classification, therefore only a few training samples which represent the class of the shape are sufficient. Fast meremental training, which is performed on-line, is accomplished by the use of the Binary Synaptic Weights algorithm, a one pass, feedforward neural network training algorithm. Incremental training offers the advantage of adjusting the recognition capability of the system to the user's drawings. the results are very successful, such that the neural network correctly classified shapes that did not have any resemblance to the shapes in the initial training set.  相似文献   
40.
Oxide semiconductors have been examined to develop NOx sensors for exhaust monitoring. Titania doped with trivalent elements, such as Al3+, Sc3+, Ga3+ or In3+, has a good sensitivity and selectivity to NO between 450 and 550 °C, and shows rapid response. A sensor probe for monitoring exhaust NOx has been fabricated. Many kinds of interference gases, such as C3H6, CO and SO2, have been found to have only a slight influence on the sensor response to NO. The influence of O2 and H2O is also negligible, except for the cases of 0% H2O and fuel-rich conditions. In accordance with these results, the sensor probe operates satisfactority in the exhaust gas of various combustion conditions without interference from the various kinds of gas species in the exhaust gases.  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司    京ICP备09084417号-23

京公网安备 11010802026262号