Hydrolysis of human horny cells by alkaline protease: Morphological observation of the process

The interaction of highly purified alkaline protease fromBacillus sp. KSM-K16 with the horny cells of human skin contained in skin grime was directly visualized by electron microscopy. It became clear that the protease first penetrates the horny cells and then adsorbs, mainly onto the internal structure of the cells at the initial stage of hydrolysis, and directly hydrolyzes the keratin filaments, though the marginal band surrounding them retains its original shape. Then, hydrolysate produced from the keratin filaments flows out of the cell, and early in the hydrolysis process keratin filaments decrease and then disappear, leaving a marginal band, i.e., the cell turns to a hollow state. As a result, the remaining marginal band loses support from inside the cell, thus promoting cleavage and dispersion. Until this stage in the protease reaction, the remarkable liberation of hydrolysis products as water-soluble protein does not occur.     

Fracture Energies of Tape-Cast Silicon Nitride with β-Si3N4 Seed Addition

The fracture energies of the tape-cast silicon nitride with and without 3 wt% rod-like β-Si₃N₄ seed addition were investigated by a chevron-notched-beam technique. The material was doped with Lu₂O₃–SiO₂ as sintering additives for giving rigid grain boundaries and good heat resistance. The seeded and tape-cast silicon nitride has anisotropic microstructure, where the fibrous grains grown from seeds were preferentially aligned parallel to the casting direction. When a stress was applied parallel to the fibrous grain alignment direction, the strength measured at 1500°C was 738 MPa, which was almost the same as room temperature strength 739 MPa. The fracture energy of the tape-cast Si₃N₄ without seed addition was 109 and 454 J/m² at room temperature and 1500°C, respectively. On the contrary, the fracture energy of the seeded and tape-cast Si₃N₄ was 301 and 781 J/m² at room temperature and 1500°C, respectively, when a stress was applied parallel to the fibrous gain alignment. The large fracture energies were attributable primarily to the unidirectional alignment fibrous Si₃N₄ grains.     

Sintering of Ceria-Doped Tetragonal Zirconia Crystallized in Organic Solvents, Water, and Air

Amorphous CeO₂–ZrO₂ gels were prepared by coprecipitation in ammonia solutions. The onset of crystallization of the gels, from calcining in air, was 420°C, while 200° to 250°C in the presence of water and organic solvents such as methanol and ethanol. The sintering behaviors of CeO₂–ZrO₂ powders were sensitive to the crystallizing conditions, since hard agglomerates formed when the precipitated gels were crystallized by normal calcination in air, whereas soft agglomerates formed when they were crystallized in water or organic solvents. CeO₂–ZrO₂ powders crystallized in methanol and water at 250°C were sintered to full theoretical density at 1150° and 1400°C, respectively, whereas that crystallized by calcination in air at 450°C was sintered to only 95.2% of theoretical density, even at 1500°C.     

In-situ monitoring of the stabilization with hydrogen of free radicals thermally induced from coal using high pressure e.s.r., d.t.a. and p.d.a. equipment

High temperature, high pressure e.s.r. measurements of the hydrogenation reaction of Taiheiyo coal in the presence of catalysts were carried out to understand the stabilization of thermally and/or catalytically induced free radicals. A decrease in free radical concentration with increasing temperature was observed for ZnCl₂ and SnCl₂ · 2H₂O catalysts at 10MPa under hydrogen gas. High pressure modified single-cell d.t.a. and p.d.a. equipment augmented the uniquely designed high temperature, high pressure e.s.r. cell. The hydrogenation reaction was monitored under the same experimental conditions as for e.s.r. From the results of the combination of high temperature, high pressure e.s.r. with high pressure d.t.a. and p.d.a., it was established that H₂ molecules can react efficiently with free radicals from coal molecules created by the presence of ZnCl₂ and SnCl₂ · 2H₂O catalysts.     

Gelation of poly(vinyl alcohol)/phenol/water solutions and gel spinning

The light transmittance of the gels of poly(vinyl alcohol) (PVA)/phenol/water solutions was examined for the entire range of phenol/water content. Excellent transparency was found for the gels with phenol contents of 70–95 vol %. In full consideration of the results for the transparency and melting temperature of the gels and the viscosity and gelation ability of solutions, the PVA solutions of 75 vol % phenol content were selected for the gel spinning. The maximum dynamic moduli of drawn filaments at 25°C (room temperature) were 42 GPa (15x) for atactic PVA and 45 GPa (14x) for syndiotacticity-rich PVA. © 1995 John Wiley & Sons, Inc.     

Effect of perchloric acid on the molecular weight and yield of poly-THF

Polytetramethylene glycol (molecular weight range 1000–8000) was prepared by the polymerization of tetrahydrofuran (THF) using a binary catalyst system of fuming sulfuric acid and perchloric acid. When 28% fuming sulfuric acid alone was used as the catalyst, the average molecular weight of polymer was low, the maximum value being 1000–1100. By the combination of fuming sulfuric acid with a small amount of perchloric acid, the average molecular weight of the polymer was increased to about 8000. Furthermore, the molecular weight was readily controlled in the range of 1000 to 8000 by varying the amount of the binary catalyst.     

Synthesis of High-Purity Zirconium Fluoride for Fluoride Glass Fibers by Chemical Vapor Deposition

A technique for synthesizing ultra-high-purity ZrF₄ using chemical vapor deposition in a ZrBr₄–HF system is developed and a purification mechanism is clarified. The Fe concentration in ZrF₄ is evaluated at less than 10 ppb based on analysis of the transmission loss spectrum of a fiber prepared using synthesized ZrF₄. Purification is achieved mainly in a sublimation process of ZrBr₄, and purification efficiency is determined by sublimation temperature and activity of impurities in ZrBr₄. The concentration of transition-metal impurities in ZrF₄, synthesized by chemical vapor deposition in the ZrBr₄–HF system, is expected to be less than 1 ppb.     

In Situ Synthesis and Microstructures of Tungsten Carbide-Nanoparticle-Reinforced Silicon Nitride-Matrix Composites

A W₂C-nanoparticle-reinforced Si₃N₄-matrix composite was fabricated by sintering porous Si₃N₄ that had been infiltrated with a tungsten solution. During the sintering procedure, nanometer-sized W₂C particles grew in situ from the reaction between the tungsten and carbon sources considered to originate mainly from residual binder. The W₂C particles resided in the grain-boundary junctions of the Si₃N₄, had an average diameter of ∼60 nm, and were polyhedral in shape. Because the residual carbon, which normally would obstruct sintering, reacted with the tungsten to form W₂C particles in the composite, the sinterability of the Si₃N₄ was improved, and a W₂C–Si₃N₄ composite with almost full density was obtained. The flexural strength of the W₂C–Si₃N₄ composite was 1212 MPa, ∼34% higher than that of standard sintered Si₃N₄.     

Formation and Properties of Ln-Si-O-N Glasses (Ln = Lanthanides or Y)

Homogeneous Y-Si-O-N glasses containing 15 or 20 eq% nitrogen (N) were prepared from compositions with Y/Si ratios in the vicinity of that of the lowest eutectic point on the Y₂O₃–SiO₂ phase diagram. The liquidus on the phase diagram shifted toward lower temperatures by incorporation of N. The density, the elastic moduli, and the glass transition temperature of the Y-Si-O-N glasses increased with incorporation of N. This is due to the closer packing of atoms in the glasses by the substitution of N, which is in three-fold coordination with Si, for O which is in two-fold coordination, and the stronger covalent nature of the Si–N bond compared with the Si–O bond. The coefficient of thermal expansion of the Y-Si-O-N glasses increased with increasing Y content, because the discontinuity of the glass network developed with increasing nonbridging anions by the introduction of Y. In contrast, the glass transition temperature and the elastic moduli increased with Y content due to the high coordination of Y for O, and the relatively high cationic field strength of Y. Furthermore, the effect of cationic field strength on properties of Ln-Si-O-N glasses (Ln = lanthanides or Y) is discussed.     

Antitumor activity of synthetic alkylphospholipids with or without PAF activity

1-O-Octadecyl-2-O-methyl-sn-glycero-3-phosphocholine (ET-18-OMe) has been reported to possess definite antitumor activity in vivo. Twenty-two alkyl lysophospholipid analogs were chemically synthesized, and their antitumor activity against mouse experimental tumors (Sarcoma 180, MM46, P388) was examined. Among them, 1-O-octadecyl-2-O-acetoacetyl-rac-glycerol-3-phosphocholine was found to show antitumor activity similar to ET-18-OMe with less acute toxicity. Intravenous injection of the ET-18-OMe withsn-3 configuration retarded the subcutaneous growth of Sarcoma 180 cells effectively, while the growth inhibition by thesn-1 isomer was much less effective. This stereospecificity was similar to that observed in their activities as platelet-activating factor (PAF) agonists. The acetoacetyl compound, another PAF agonist, showed similar stereospecific antitumor action in vivo. These findings suggest that some alkyl lysophospholipids may activate host cells to a cytostatic stage against tumor cells in vivo through binding to a PAF receptor. Our preliminary results indicated that the responsible cells under these conditions might be primarily immature macrophages present in the bone marrow. No appreciable or even adverse stereospecificity was observed in the different sets of experiments where the activity of ET-18-OMe against MM46 tumor cells in vivo or the direct cytotoxicity against human promyelocytic leukemia HL-60 cells in vitro was examined. Under, some conditions, the antitumor activity of ET-18-OMe in vivo may be revealed through direct cytotoxicity and/or modulation of the host defense system by “nonspecific” mechanisms. Some alkylphospholipids without PAF activity may also show antitumor activity through similar, “nonspecific” mechanisms.