蓝莓溃疡病生防链霉菌CX3的抑菌效果及其鉴定

[目的]为了明确从吉林省长白山保护区池西保护站马鞍山云杉人工林林下土壤分离,所获得1株拮抗菌株(编号记为CX3)的生防效果及分类地位。[方法]分别采用平板对峙法和杯碟法测定该菌株活菌及其发酵液的抑菌活性和抑菌谱;并通过形态学、生理生化特征、16S rRNA序列分析等方法研究了其分类地位。[结果]该菌株对13种供试植物病原菌均有抑制作用,抑菌谱广,其中对蓝莓溃疡病菌有极强的抑制作用,抑菌带达25.91 mm,发酵液的抑菌圈直径达31.73 mm;根据其菌株形态、生理生化特性、16S rRNA序列比对,最终鉴定菌株为链霉菌属Streptomyces sp.。[结论]该菌株对蓝莓溃疡病菌有显著的抑制效果,应用开发前景良好,此次是国内首次报道该菌株杀真菌活性。     

基于AMESim的液压马达加载系统研究

液压马达作为液压系统的执行元件在工程机械上广泛应用,针对液压马达加载工况下的输出特性,利用Simulink和AMESim软件对系统进行联合仿真建模,并对系统的运行状态、控制性能、回收性能进行研究,对液压马达加载系统的设计和改进具有重要的参考意义。     

Visible light-activated degradation of microcystin-LR by ultrathin g-C3N4 nanosheets-based heterojunction photocatalyst

Microcystins (MCs) is a harmful toxin generated by blue-green algae in water, which has seriously threatened the ecological safety of water and human body. It is urgent to develop new catalysts and techniques for the degradation of MCs. A feasible electrostatic self-assembly method was carried out to synthesize BiVO₄/g-C₃N₄ heterojunction photocatalyst with highly efficient photocatalytic ability, where BiVO₄ nanoplates with exposed {010} facets anchored to the g-C₃N₄ ultrathin nanosheets. The morphology and microstructure of the heterojunction photocatalysts were identified by XRD, SEM, TEM, XPS, and BET. The g-C₃N₄ nanosheets have huge surface area over 200 m²/g and abundant mesoporous ranging from 2-20 nm, which provides tremendous contact area for BiVO₄ nanoplates. Meanwhile, the introduction of BiVO₄ led to red-shift of the absorption spectrum of photocatalyst, which was characterized by UV-vis diffuse reflection spectroscopy (DRS). Compared with pure BiVO₄ and g-C₃N₄, the BiVO₄/g-C₃N₄ heterojunction shows a drastically enhanced photocatalytic activity in degradation of microcystin-LR (MC-LR) in water. The MC-LR could be removed within 15 minutes under the optimal ratio of BiVO₄/g-C₃N₄. The outstanding performance of the photocatalyst is attributed to synergetic effect of interface Z-scheme heterojunction and high active facets {010} of BiVO₄ nanoplates, which provides an efficient transfer pathway to separate photoinduced carriers meanwhile endows the photocatalysts with strong redox ability.     

铸态Ti-20Zr-20Al钛合金动态压缩力学性能与断裂机制研究

采用X射线衍射仪、金相显微镜、分离式霍普金森杆和扫描电镜等手段研究了Ti-20Zr-20Al钛合金在动态压缩条件下的微观结构、力学性能和断裂机制。结果表明,Ti-20Zr-20Al铸态合金由Zr基体相和TiAl/Ti₃Al针状相组成; 随着应变率增加,合金的抗压强度增加,失效应变显著增加; Ti-20Zr-20Al合金的断裂机制为解理断裂; 随着应变率增加,试验压缩断裂后碎片总数增大,平均粒径减小。采用DID模型模拟的材料碎片尺度与实验结果比较吻合,Grady模型与实验结果的偏差较大。     

析湿工况下翅片管式换热器表面粉尘沉积过程的数值模型

空调器采用翅片管式换热器作为蒸发器，在制冷工况下换热器表面发生析湿及粉尘沉积，导致性能衰减。建立湿翅片表面粉尘颗粒物沉积过程的数学模型，模拟冷凝水捕集颗粒物以及湿积灰层黏附颗粒物的过程。被冷凝水捕集的颗粒物数量等于运动轨迹与水表面轮廓会出现相交的入射颗粒物的数量；后续的入射颗粒物与湿积灰层碰撞时，部分入射颗粒物会发生沉积且部分被碰撞的已沉积湿颗粒物会发生移除，这两部分的颗粒物数量相减即为被湿积灰层黏附的颗粒物数量。模拟与实验结果的对比表明，预测的湿积灰层形状与实验照片的吻合度较好，预测的单位面积颗粒物沉积质量与91%的实验数据之间的误差在±20%之间，平均误差为11.8%。     

齐大山铁矿南帮含水构造带探测研究

为解决采空区突发涌水给矿山安全生产带来的安全威胁,以齐大山铁矿为研究对象,以高密度电阻率法含水构造带理论模型的正演模拟研究为基础,运用高密度电阻率法对采场南帮含水构造带的异常范围进行了圈定;运用瞬变电磁法进行了二次探测,并对高密度电阻率法所圈定的异常范围进行了验证。研究表明:含水构造带显示为低阻异常特征,在高密度电阻率法探测成果图中显示的两处低阻异常与含水构造带理论模型的正演模拟结果一致;同时,在瞬变电磁法探测成果图中显示的低阻区域均在高密度电阻率法所圈定的低阻异常范围内,二者相互验证,这两处低阻异常均为含水构造带的地球物理异常特征的显示,表明采用高密度电阻率法和瞬变电磁法组合识别技术可实现对隐伏含水构造带的先导性探测。     

湾图沟煤矿高强度采动巷道稳定性评价研究

针对高强度采动巷道围岩控制难题，从实验室岩样尺度和现场巷道尺度研究了湾图沟煤矿13405工作面回风平巷围岩稳定性特征。结合单轴压缩试验和声波测试分析了干燥、自然及饱和状态下3组岩样的力学行为差异特征。利用钻孔成像，分析了高强度采动影响巷道围岩裂隙发育分段特征。结果表明:干燥、自然及饱和状态下岩样的单轴抗压强度和弹性模量依次降低，水分的存在极大地降低了岩石的强度和刚度。实煤体段围岩仅在深度1 m范围内发现少量纵向裂隙。高静压段两帮维护效果较差，煤帮裂隙极为发育，存在高量值的离层。动压段巷道顶板完整性较好，两帮均发现较大离层，且超出了锚杆正常锚固范围，严重影响了巷道锚固结构的稳定性。     

Corrosion resistance of Al–Cr-slag containing chromium–corundum refractories to slags with different basicity

Al–Cr slag is the solid waste generated by the smelting of Cr metal. It presents a range of environmental hazards. This study addressed the corrosion resistance of Al–Cr slag containing chromium–corundum refractories to slags with different basicity. Herein, we provide suggestions for the use of Cr–corundum of different basicity in kilns. Al–Cr slag, brown fused Al₂O₃, and chrome green were used as the raw materials, with pure calcium aluminate cement being used as a binder. The brick samples, prepared using different blends of chrome green and corundum, were fired at 1600?°C, and subsequently subjected to a slag corrosion test. After corrosion by slag of different basicity, the phase composition and microstructure of the sample were analyzed by X-ray diffraction, energy dispersive spectrometer and scanning electron microscopy. There were two major findings. First, Cr–corundum brick made from Al–Cr slag has a better slag corrosion resistance than that made from Cr₂O₃ and brown fused Al₂O₃. Second, Cr–corundum brick made from Al–Cr slag has superior corrosion resistance to slag with a CaO:SiO₂ ratio of 2:1.     

基于振动实测的非均质地层钻头失效分析与对策

四川盆地作为国内页岩气开发的重点区域,通过近几年的不断攻关和实践,机械钻速得到了提高,但由于受地层复杂、可钻性差、非均质性强等地质因素的影响,导致井下钻柱系统不良振动剧烈,容易出现钻头损坏严重、钻速较低等问题,严重影响了钻井时效。为了解决上述难题,以该盆地涪陵工区上二叠统龙潭组—中二叠统茅口组为例,采用井下振动高频测量工具的实测手段,测量了钻头—钻柱系统的动态振动加速度参数,结合地层的岩性和矿物组分分析,研究钻头失效原因与对策,并开展了现场试验。研究结果表明:①在非均质地层中钻进的钻头—钻柱系统产生了大于40 m/s~2的高幅值瞬时冲击振动,高幅值的瞬时冲击是导致钻头先期失效的主要原因;②提出了抑制高幅值的瞬时冲击振动采用"减振+增压"工具组合和避免井下工具共振的钻井参数;③采用钻井新参数的试验井比邻井的高幅值瞬时振动降低了17%,单只钻头进尺增加24%,钻头工作环境得到了较大的改善,钻头使用数量减少。结论认为,该研究成果能够有效地改善钻头—钻柱系统的振动状态,有利于达成延长钻头使用寿命的目标。     

喷雾干燥法制备材料论文的指导方案

喷雾干燥技术的突出特点是将液态物料瞬时干燥成固体粉末或者颗粒。我们课题组在指导本科生毕业论文中采用了喷雾干燥法制备碳包覆铌酸钛材料的实验,在实验过程中我们发现了一些问题,如喷雾干燥机需要适当预热、喷头容易堵赛和收集原料不干等问题。我们就以上问题进提出了相应的对策,这加深了本科生对喷雾干燥实验的体会和认识,培养了学生在独自实验时面对问题解决问题的能力。