共查询到18条相似文献,搜索用时 328 毫秒
1.
2.
3.
4.
5.
6.
通过讨论炉缸炉底长寿技术的发展历程,总结首钢高炉长寿经验,提出高炉炉缸炉底长寿设计的思想和理念一控制炉缸炉底的象脚状侵蚀,避开炉缸的过度侵蚀,使炉缸炉底侵蚀向锅底状侵蚀的方向发展。本文详细介绍了首钢迁钢1号高炉本体炉缸炉底的设计和设计思想,经过数学物理模型计算,阐明长寿设计理念和理论计算的统一,并在首钢迁钢一号高炉本体设计中得到应用。高炉的长寿设计是内衬结构、冷却体系、检测自动化的结合,长寿设计尤为关键,科学的设计是高炉长寿的基础。 相似文献
7.
8.
9.
10.
我国大型高炉长寿技术发展现状 总被引:5,自引:0,他引:5
论述了我国大型高炉长寿技术的发展现状。在大型高炉设计中,通过优化炉型、采用合理炉缸内衬结构、铜冷却壁、软水密闭循环冷却系统、薄壁内衬等技术为高炉长寿创造条件。通过自动化检测与控制、炉体维护等技术使高炉寿命达到15年以上。对高炉炉缸内衬结构、铜冷却壁、软水密闭循环冷却系统、薄壁内衬的应用进行了评述,对我国大型高炉长寿技术的发展提出了建议。 相似文献
11.
12.
《钢铁冶炼》2013,40(5):350-359
AbstractRefractory wear and skull growth on the hearth walls and the bottom of the blast furnace have been researched. A series of thermocouples were installed in the hearth, and the temperature measurements were recorded in a structured query language every minute. A heat transfer model was used to study the temperature evolution and hearth wear profile using a commercial software package (MATLAB version 5.0) based on computational fluid dynamics. The location of the 1150°C isotherm in the hearth lining has been calculated. An online monitoring tool was used to analyse the temperature distribution in the hearth and offers, to the plant operators, periodic information on the refractory state. Electromotive force (EMF) probes were installed in the hearth to estimate the variations in the liquid level in the hearth and to determine the thermal state (TS) evolution. Good correlation is seen between EMF and TS, and the EMF amplitudes in the different tapholes follow and even precede the local TS. 相似文献
13.
高炉炉缸安全是高炉长寿的主要限制环节,首钢股份公司环保限产期间对2号高炉进行了在不切割炉壳情况下的炉缸保护性清理和浇注修复施工。在此期间对高炉炉缸的破损情况进行了调研,研究了首钢股份公司 2 号高炉风口以下炉缸渣皮、风口区域、出铁口前泥包的状态和炉底陶瓷垫的侵蚀状况,并分析了造成炉缸炭砖侵蚀的原因及炉缸中钛和锌元素的物相。研究发现炉底陶瓷垫未形成锅底状侵蚀,越是靠近炉墙位置,陶瓷垫侵蚀越严重,说明了炉缸活跃度不够。而象脚区炭砖侵蚀主要是受铁、钾和硫等元素的渗透侵蚀;炉底象脚区域发现大量古铜色碳氮化钛沉积物,沉积物呈带状分布;破损炉缸中发现的大量ZnO富集物是黄绿色而非传统的白色。此次破损调研为后期炉缸浇注、高炉操作以及今后的炉缸设计提供现实可靠的依据,其意义重大。 相似文献
14.
Ashish Agrawal Swapnil C. Kor Utpal Nandy Abhik R. Choudhary Vineet R. Tripathi 《钢铁冶炼》2016,43(7):550-558
A stable and efficient blast furnace operation requires proper control of hot metal and slag drainage from the hearth. Many operational problems such as non-dry casts, blow outs, excessive hearth lining wear and low-blast intake arise when the liquid level in the hearth exceeds the critical limit where hearth coke and deadman start to float. Since the direct measurement of the hearth liquid level is practically impossible due to high temperature and pressure inside the furnace, it is therefore important to estimate the liquid level in the hearth and display it to the operators on real-time basis for efficient cast management. This paper presents a system, called hearth liquid level monitoring (LLM), which simulates the liquid level and drainage behaviour of the furnace hearth. It is based on the theoretical hot metal and slag generation rate from the specific oxygen rate and the computed drainage rate from torpedo radar signals and the slag flow measurement system. The system advises the blast furnace operator when to initiate tapping and close the taphole when the liquid level is controlled. It also alerts operators when to use the larger drill bit diameter for opening the next cast. 相似文献
15.
为了研究首钢A高炉炉渣降低MgO的可行性,利用FactSage热力学软件,从理论上解析首钢A高炉炉渣中MgO对固相析出温度和黏度的影响。研究发现,A高炉炉渣固相析出温度在1 400 ℃左右,炉渣在高炉炉缸中全为液相并具有较好的流动性。1 500 ℃下,现有炉渣组分在相图中液相区,若MgO含量降低,炉渣仍处在液相区。MgO质量分数在2.87%~7.37%区间变化时,随MgO含量升高,固相析出温度增加;MgO质量分数升高1%,炉渣固相析出温度升高约3.73 ℃。随MgO含量升高,炉渣黏度降低。1 500 ℃下,MgO质量分数升高1%时,炉渣黏度降低0.014 Pa·s。分析认为,炉缸热状态较好(铁水温度在1 480 ℃以上)时,适当降低MgO质量分数至6%,炉渣黏度不会受较大影响;炉缸热状态较差(铁水温度在1 480 ℃以下)时,不建议降低MgO含量。 相似文献
16.
炉缸的运行状况对高炉长寿起着决定性作用。首钢京唐2号高炉2017年8月开始炉缸侧壁温度急剧上升,对高炉的正常生产和人员安全提出了严峻考验。炉缸侧壁高温点的位置坐标表明,首钢京唐2号高炉炉缸侧壁温度异常升高的直接原因是炉缸内部铁水环流加剧对炉缸内衬的化学侵蚀和物理冲刷。进一步从铁水成分、炉底温度、铁口深度和铁水流速等因素分析,证实了2号高炉炉缸侧壁温度升高的根源在于炉缸活跃性恶化。此外,较高的硫负荷和焦炭灰分、较低的终渣碱度及水箱漏水等因素也在一定程度上促成了炉缸不活的状态。 相似文献
17.
18.
从炉缸结构设计关键要素的分析着手,从侵蚀机制、炉缸传热体系的建立到炉缸的设计理念对炉缸的长寿 进行了全面的论述。指出高炉长寿的关键控制环节为:设计、施工、烘炉、开炉节奏、操作稳定、维护管理。在合适 的炉缸冷却系统和结构配置条件下,有效杜绝和防止气隙是炉缸长寿的关键。设计要有完善的防止气隙的措施; 安装中要严格控制每一个环节;采用热水烘炉提高炉墙温度,促进水分蒸发;控制高炉开炉进程,给予新高炉一个 磨合期,保证炉缸的传热体系可靠、有效,以实现炉缸的无气隙化操作。无论炉缸耐材采用何种配置结构和采用何 种冷却系统,都必须以建立良好的传热体系为前提,只有尽快形成稳定的渣铁壳,才能实现炉缸的长寿。 相似文献