首页 | 官方网站   微博 | 高级检索  
     

赤泥-钛白废酸综合回收中钪的萃取工艺
引用本文:余荣旻. 赤泥-钛白废酸综合回收中钪的萃取工艺[J]. 有色金属科学与工程, 2017, 8(4): 31-35. DOI: 10.13264/j.cnki.ysjskx.2017.04.006
作者姓名:余荣旻
作者单位:湖南稀土金属材料研究院, 长沙 410126
基金项目:国家高技术研究发展计划(863计划)项目2013AA031002湖南省科技计划一般项目2012GK3179
摘    要:针对赤泥-钛白废酸浸出液中钪及主要杂质的特点, 采用先除杂后萃取的工艺对溶液中钪进行萃取分离.首先, 将一定量的活性炭加入赤泥-钛白废酸浸出液中, 吸附去除浸出液中的硅, 硅的去除率可达96.70%, 而钪的去除率仅为1.25%, 这表明活性炭吸附除杂可在保证浸出液中钪含量基本不损失的情况下除去绝大部分的硅.除硅有效控制了浸出液的胶凝现象, 有利于下一步的钪萃取工艺.在萃取工艺过程中, 具体研究了除杂后液的酸度、萃取剂体积分数、相比、萃取时间对钪萃取率的影响.结果表明, 除杂后液酸度以1.81 mol/L为最佳, 既避免了有机相乳化, 又保证了钪的高萃取率; 相比在1/10~1/30之间时, 钪萃取率达到平衡, 但当相比为1/30时, 发生乳化, 难于分离, 因此, 相比1/25为最佳; 萃取时间为15 min时, 钪的萃取率达到平衡; 萃取剂体积分数为15% P204+ 6% TBP时, 钪的萃取率达到最大值.在最佳的萃取工艺条件下, 钪的萃取率达98.80%. 

关 键 词:赤泥   钛白废酸     除杂   萃取
收稿时间:2017-02-21

Technology of extracting scandium in the comprehensive recovery of red mud-titanium white waste acid
Affiliation:Hunan Rare Earth Metal Research Institute, Changsha 410126, China
Abstract:In this paper, the extraction technology of scandiumis studied by the process of extraction after removal of impurities according to the property of the leaching solution of red mud-titanium white waste acid.Firstly, a certain amount of activated carbon was added into the leaching solution to remove silicon dioxide (SiO2). The removal rate of SiO2 was 96.70 % and the removal rate of scandium was 1.25 %. It shows that, most of the SiO2 is removed while the Sc3+ content is almost constant after the addition of activated carbon. The removal of SiO2 caneffectively control the gelatinization of leaching solution and facilitate the subsequent extraction process.The effect of acidity of leach solution, extractant volume fraction, phase ratio and extraction time on scandium extraction rate were examined. The results show that the optimal acidity of leaching solution after purification at 1.81 mol/L which can avoid the emulsification of organic phase and ensure high extraction rate of scandium; the extraction rate of scandium reaches equilibrium when the phase ratio is between 1/10~1/30, and the phase ratio of 1/25 is the optimal because the leaching solution is emulsificated when the phase ratio was at 1/30; the extraction rate of scandium reaches equilibrium when the extraction time is 15 min, and reaches the maximum when the extractant volume fraction is 15 % P204 + 6 % TBP. It's found that the extraction rate of scandium is 98.80 % under the optimum extraction conditions. 
Keywords:
本文献已被 CNKI 等数据库收录!
点击此处可从《有色金属科学与工程》浏览原始摘要信息
点击此处可从《有色金属科学与工程》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司    京ICP备09084417号-23

京公网安备 11010802026262号