Interface shear behaviour of tunnel backfill materials in a deep-rock nuclear waste repository in Finland

The need for environmental protection and safety in facilities dedicated for the final safe disposal of spent nuclear fuel is paramount. Highly engineered multi-barriers are widely used in such waste containment facilities in order to provide a tight seal for the waste they contain. In Finland, several research studies have been conducted to investigate the feasibility of the final safe disposal of spent nuclear fuel in crystalline bedrock by incorporating the KBS-3V multi-barrier repository concept. As the saturation of the tunnels in a repository progresses, the pre-compressed bentonite buffer may swell and generate very high swelling pressure in the range of 7–15 MPa. Such high swelling pressure can cause the upheaval and the compression of the tunnel backfill that would eventually decrease the density of the buffer. For various reasons, the current KBS-3V design suggests that the saturated density of the buffer should be maintained within a narrow range of 1950–2050 kg/m³ at all times. As the swelling of the buffer directly influences the saturated density of the buffer, it must be controlled by designing a tunnel backfill that possesses an adequate amount of interface shear strength to sustain any additional pressure that is exerted by the swelling of the buffer. This study presents the findings of a series of direct shear box tests conducted on various tunnel backfill interfaces. Additionally, different types of rock profiles were also tested with the selected backfill materials. Based on the results, it was observed that the interface shear behaviour of different backfill-rock interfaces varied significantly with the surface roughness of the rock, while clay blocks resulted in similar shear behaviour with all the backfill materials.