| 双冷嬗变包层第一壁热工水力特性数值模拟研究 |
| |
| 引用本文： | 焦宏,田文喜,秋穗正,苏光辉.双冷嬗变包层第一壁热工水力特性数值模拟研究[J].原子能科学技术,2011,45(4):421-425. |
| |
| 作者姓名： | 焦宏 田文喜 秋穗正 苏光辉 |
| |
| 作者单位： | 西安交通大学 ;动力工程多相流国家重点实验室 ;核科学与技术系，陕西 ;西安 710049 |
| |
| 基金项目： | 科技部ITER计划专项课题资助项目 |
| |
| 摘 要： | 利用CFX程序对聚变驱动次临界堆嬗变包层第一壁在水冷条件下的热工水力特性进行数值模拟和分析。计算选用PWR典型工况下的水，取嬗变包层第一壁的局部模型，考虑了流固热耦合，重点计算分析了在不同壁面热流密度和冷却剂流速条件下冷却剂温度、压降及结构材料最高温度的分布。计算结果显示，当水的入口流速为1～5m/s时，结构材料的最高温度较使用典型工况下的氦气作冷却剂时低16～91K，同时结构材料最大温差降低了12.2%～49.5%。结果表明：水可较好地满足稳态工况下第一壁的换热要求。
|
| 关 键 词： | 次临界堆 双冷嬗变包层 水冷 温度场 压降 |
Numerical Simulation and Analysis of Thermal-Hydraulic Characteristics of the First Wall in Dual-cooled Waste Transmutation Blanket |
| |
| JIAO Hong,TIAN Wen-xi,QIU Sui-zheng,SU Guang-hui.Numerical Simulation and Analysis of Thermal-Hydraulic Characteristics of the First Wall in Dual-cooled Waste Transmutation Blanket[J].Atomic Energy Science and Technology,2011,45(4):421-425. |
| |
| Authors: | JIAO Hong TIAN Wen-xi QIU Sui-zheng SU Guang-hui |
| |
| Affiliation: | Department of Nuclear Science and Technology, State Key Laboratory of Multiphase Flow in Power Engineering, Xi’an Jiaotong University, Xi’an 710049, China |
| |
| Abstract: | The CFX software was used for the simulation and analysis of thermal-hydraulic characteristics of the water-cooled first wall of dual-cooled waste transmutation blanket(DWTB) in fusion driven subcritical system(FDS).Water in the typical operational condition of PWR was used as the coolant in this calculation.The calculation was carried out on a partial model of the first wall,in which coupling of heat transfers between solid and fluid was considered.Focus is placed on the temperature distribution of first w... |
| |
| Keywords: | subcritical system dual-cooled waste transmutation blanket water-cooled temperature distribution pressure drop |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
| 点击此处可从《原子能科学技术》浏览原始摘要信息 |
|
点击此处可从《原子能科学技术》下载全文 |
