| 管板数控钻孔路线优化研究 |
| |
| 引用本文： | 赵福臣,张永军,郭俊芳. 管板数控钻孔路线优化研究[J]. 炼油与化工, 2005, 16(4): 29-31 |
| |
| 作者姓名： | 赵福臣 张永军 郭俊芳 |
| |
| 作者单位： | 1. 大庆石油化工总厂机械厂,黑龙江,大庆,163711
2. 哈尔滨理工大学,机械动力工程学院,黑龙江,哈尔滨,150080 |
| |
| 摘 要： | 换热器管板是典型的二维数控加工多孔零件。实践表明，加工管板不同的走刀路线其长度相差极大。为提高生产效率，在满足生产的前提下应使刀具的走刀路线尽量短。针对同类孔和不同类孔的加工特点提出了几种加工路线的优化方法，并分析了各自的适用场合，指出了安全合理使用数控设备的注意事项。
|
| 关 键 词： | 管板 数控钻孔 加工路线 优化算法 |
| 文章编号： | 1671-4962（2005）04-0029-03 |
| 收稿时间： | 2005-08-26 |
| 修稿时间： | 2005-08-26 |
Research on optimization of digitally controlled hole drilling route of tube sheet |
| |
| Zhao Fuchen,Zhang Yonen,Guo Funfang. Research on optimization of digitally controlled hole drilling route of tube sheet[J]. Refining Chemical Industry, 2005, 16(4): 29-31 |
| |
| Authors: | Zhao Fuchen Zhang Yonen Guo Funfang |
| |
| Abstract: | Tube sheets of the heat exchangers are the typical multi-hole parts machined by two-dimensional digital control. Practice shows that different knife route for machining tube sheet will cause a very big difference of it's length. To increase the production efficiency and in the same time to meet the requirement of production and under the condition of shortest possible knife route, several optimized methods for the machining route are put forward regarding the machining characteristics of the holes of different kinds and same kinds, respective applications are analyzed, and precautions for safe and reasonable use of digital-controlled equipment are pointed out. |
| |
| Keywords: | tube sheet digital-controlled hole drilling machining route optimized algorithm |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
