首页 | 官方网站   微博 | 高级检索  
     

晶粒尺寸对细晶钛酸钡陶瓷介电、压电和铁电性能的影响
引用本文:黄咏安,路标,邹艺轩,李丹丹,姚英邦,陶涛,梁波,鲁圣国.晶粒尺寸对细晶钛酸钡陶瓷介电、压电和铁电性能的影响[J].无机材料学报,2018,33(7):767-772.
作者姓名:黄咏安  路标  邹艺轩  李丹丹  姚英邦  陶涛  梁波  鲁圣国
作者单位:广东工业大学 材料与能源学院, 广东省智能材料和能量转化器件工程技术研究中心, 广东省功能软凝聚态物质重点实验室, 广州 510006
基金项目:国家自然科学基金委-广东省联合基金(U1501246);国家自然科学基金(51372042);广东省自然科学基金重大基础研究培育项目(2015A030308004);The Guangdong Joint Funds from the National Science Foundation of China (U1501246);National Natural Science Foundation of China (51372042);Guangdong Natural Science Foundation (2015A030308004)
摘    要:以采用水热法制备的BaTiO3粉体作为原料, 利用普通烧结法和两步烧结法制备出晶粒尺寸为0.25~10.15 μm的BaTiO3陶瓷, 研究了晶粒尺寸效应对BaTiO3陶瓷的介电、压电以及铁电性能的影响。结果表明: BaTiO3陶瓷的四方相含量随着陶瓷晶粒尺寸的增大而增加; 当晶粒尺寸在1 μm以上时, 室温相对介电常数(ε° )和压电系数(d33)随着晶粒尺寸的减小而增大, 并在晶粒尺寸为1.12 μm时分别达到最大值5628和279 pC/N, 然后两者随着晶粒尺寸的进一步减小而迅速下降。BaTiO3陶瓷的剩余极化强度Pr随晶粒尺寸的增大而提高, 而矫顽场Ec却呈现出相反的趋势。晶粒尺寸对介电性能和压电性能的影响是由于90°电畴尺寸和晶界数量的变化。晶粒的晶体场和晶粒表面钉扎作用的变化影响了电畴, 进而改变电滞回线。

关 键 词:钛酸钡  晶粒尺寸  两步烧结  介电  压电  铁电  
收稿时间:2017-06-08
修稿时间:2017-11-08

Grain Size Effect on Dielectric,Piezoelectric and Ferroelectric Property of BaTiO3 Ceramics with Fine Grains
HUANG Yong-An,LU Biao,ZOU Yi-Xuan,LI Dan-Dan,YAO Ying-Bang,TAO Tao,LIANG Bo,LU Sheng-Guo.Grain Size Effect on Dielectric,Piezoelectric and Ferroelectric Property of BaTiO3 Ceramics with Fine Grains[J].Journal of Inorganic Materials,2018,33(7):767-772.
Authors:HUANG Yong-An  LU Biao  ZOU Yi-Xuan  LI Dan-Dan  YAO Ying-Bang  TAO Tao  LIANG Bo  LU Sheng-Guo
Affiliation:Guangdong Provincial Key Laboratory of Functional Soft Condensed Matter, Guangdong Provincial Research Center on Smart Materials and Energy Conversion Devices, School of Materials and Energy, Guangdong University of Technology, Guangzhou 510006, China
Abstract:A series of highly dense barium titanate (BaTiO3) ceramics with average grain size ranging from 0.25 μm to 10.15 μm were prepared by either conventional sintering or a two-step sintering method, using ultrafine BaTiO3 powders prepared by hydrothermal approach. The impact of grain size on dielectric, piezoelectric and ferroelectric properties of BaTiO3 ceramics was investigated. Results indicate that the tetragonal phase of BaTiO3 ceramics increases with the increase of grain size. When the averaged grain size is above 1 μm, the relative dielectric constant (ε°) and piezoelectric coefficient (d33) at room temperature increase firstly with the decrease of grain size, with the maximum values of 5628 and 279 pC/N, respectively, at the grain size of 1.12 μm, and then decrease rapidly with further decrease of the grain size. The remanent polarization Pr of BaTiO3 ceramics rises with the increase of grain size, but the coercive field Ec exhibits opposite tendency. The variation of dielectric and piezoelectric properties resulted from the change of grain size is regarded as the impact of 90° domain size and the number of the grain boundaries, while the change of hysteresis loops is due to the change of the crystal field in the grains and the “pinning” effect of the surface layer on the grains.
Keywords:barium titanate  grain size  two-step sintering  dielectricity  piezoelectricity  ferroelectricity  
本文献已被 CNKI 等数据库收录!
点击此处可从《无机材料学报》浏览原始摘要信息
点击此处可从《无机材料学报》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司    京ICP备09084417号-23

京公网安备 11010802026262号