| 形变热处理工艺条件对7075铝合金组织及性能影响 |
| |
| 引用本文： | 张世兴,蔡刚毅,王鹏辉. 形变热处理工艺条件对7075铝合金组织及性能影响[J]. 轻合金加工技术, 2011, 39(6) |
| |
| 作者姓名： | 张世兴 蔡刚毅 王鹏辉 |
| |
| 作者单位： | 河南工业大学,机电工程学院,河南郑州,450001 |
| |
| 基金项目： | 河南省河南工业大学科研基金资助项目(09XGG006) |
| |
| 摘 要： | 研究了7075铝合金棒料的形变热处理工艺条件(形变量和时效制度)变化对其组织和性能的影响。结果表明,固溶处理后进行冷变形,随着形变量的增加,合金的硬度随之增加,当冷形变量达到40%左右时合金的硬度最高,随后随形变量增加合金的硬度略有下降;在相同冷变形量条件下,在120℃时效16 h制品的硬度最高;通过金相组织观察发现,形变热处理后7075铝合金棒料的晶粒细化,且可观察到明显的析出相。综合考虑,7075铝合金棒料形变热处理的最佳工艺制度为固溶(470℃20 min)淬火+变形量40%+时效(120℃16 h)。
|
| 关 键 词： | 7075铝合金 形变热处理 形变量 显微组织 硬度 |
Influence of thermo-mechanical treatment on microstructure and property of 7075 aluminum alloy |
| |
| ZHANG Shi-xing,CAI Gang-yi,WANG Peng-hui. Influence of thermo-mechanical treatment on microstructure and property of 7075 aluminum alloy[J]. Light Alloy Fabrication Technology, 2011, 39(6) |
| |
| Authors: | ZHANG Shi-xing CAI Gang-yi WANG Peng-hui |
| |
| Affiliation: | ZHANG Shi-xing,CAI Gang-yi,WANG Peng-hui(Electric-Mechanical Engineering College,Henan Technology University,Zhengzhou 450001,China) |
| |
| Abstract: | The effect of different thermo-mechanical treatment processes,such as mechanical deformation amount and aging technologies,on microstructure and mechanical properties of 7075 aluminum alloy have been studied.The results show that the hardness of the alloy is increased with the increasing of cold deformation after solution heat treatment;the hardness gets to the highest when the cold deformation reaches to 40%,and then the hardness decreases lightly while the cold deformation higher than 40%;at the condition... |
| |
| Keywords: | 7075 aluminum alloy thermo-mechanical treatment deformation amount microstructure hardness |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
