Fatigue Resistance of an Anodized and Hardanodized 6082 Aluminum Alloy Depending on the Coating Thickness in the High Cycle Regime

In this study, the high cycle fatigue behavior of an anodized 6082 aluminum alloy is investigated. Main focus is on the most relevant influencing factors for crack initiation and propagation under cyclic loading and damage mechanisms considering coating type, thickness, and residual stresses. The bare substrate is compared to anodized and hardanodized specimens with three coating thicknesses, for each coating type, in the range from 20 to 70 μm. Coating hardness and microstructure as well as residual stresses are analyzed. Fatigue and fracture behavior under alternating tension–compression loading is determined. Dependent on the coating thickness, the fatigue strength is reduced by 8%–50% after anodizing and by 50%–62% after hardanodizing. As the coating thickness is equal to the initial crack length from a fracture mechanical point of view, stress intensities at the crack tips are higher for thicker coatings respectively longer initial crack lengths. Therefore, propagation of fatigue-induced cracks from the coating into the substrate is promoted for a higher coating thickness resulting in premature failure. A significant correlation between the coating thickness and tensile residual stresses induced by both coatings in the subjacent substrate is not found and residual stress influence on the overall fatigue strength is only minor.