Synchronous toughening and reinforcing of polypropylene with ultrahigh‐molecular‐weight polyethylene via melt blending: Mechanical properties,morphology, and rheology

Blending systems based on polypropylene (PP) and ultrahigh‐molecular‐weight polyethylene (UHMWPE) were prepared via a melt extrusion by the four‐screw and the twin‐screw extruders, respectively. The mechanical evaluation demonstrated that the synchronous toughening and reinforcing effects could be achieved from the combination of the PP and the UHMWPE, in which the toughness and the tensile properties could be improved with increasing the UHMWPE content, and achieved optimal values at a weight ratio of PP/UHMWPE (85/15). EPDM can be used as a compatibilizer to improve the compatibility and the interfacial adhesion between the PP and the UHMWPE. This resulted in more effective toughening and reinforcing effects. In contrast, for the PP/UHMWPE blends prepared by the normal twin‐screw extruder, the poor dispersion capacity for the UHMWPE resulted in a deterioration of all mechanical parameters. Morphological observation revealed that the UHMWPE domain was well distributed as tiny particles in the PP matrix, which was confirmed by the differential scanning calorimetry analysis. The toughening effect was attributed to the energy dissipation caused by these rigid tiny particles that detached from the matrix to initiate the local matrix shear yield and formed the void. Rheological investigation demonstrated that there was an interesting composition dependence of viscosity, for which the melt viscosities of the PP/UHMWPE blends decreased when 5 wt % UHMWPE was added, and then began to increase as the UHMWPE content continued to increase. However, this dependence on composition became weaker because of the compatibilization of the EPDM. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 3498–3509, 2006