| Abstract: | This paper deals with the natural circulation flow characteristics of the VVER-440 geometry at reduced coolant inventory. Special emphasis is on the flow rate of the primary circuits during the two-phase flow regime. For studying two-phase natural circulation flow phenomena in a VVER geometry a series of cold leg small break loss-of-coolant accident (SBLOCA) tests was carried out in the PArallel Channel TEst Loop (PACTEL), a 1/305 volumetrically scaled model of a VVER-440 reactor. The tests were conducted with break areas ranging from 0.1 to 1.5 % of the scaled cold leg cross-sectional area of the reference reactor. A partial failure of the high-pressure injection system (HPIS) was assumed. The tests reveal a trend towards an increasing primary circuit mass flow rate with decreasing inventory. This contradicts the findings of earlier tests in multi-loop VVER geometry. With single-loop facilities, increased mass flow rates at reduced inventories have been reported before. The increase of the two-phase flow rate turns out to be a consequence of the combined effect of break size, pressure range and secondary side feed and bleed procedure. The physical phenomena of flow stagnation in the primary circuits, system pressurization, asymmetric loop flows, and loop seal clearing and refilling take place during the natural circulation cooling process from single-phase into two-phase and boiler–condenser modes. In addition, flow reversal in the undermost tubes of the horizontal steam generators (SG) is observed. These phenomena are discussed briefly while a general insight into the course of the tests is presented. |
