| 锻热淬火工艺对工具钢碳化物粒度的影响 |
| |
| 引用本文： | 王晓沛,王登阶.锻热淬火工艺对工具钢碳化物粒度的影响[J].热加工工艺,1996(2):21-23. |
| |
| 作者姓名： | 王晓沛 王登阶 |
| |
| 作者单位： | 湖北汽车工业学院，东风汽车公司 |
| |
| 摘 要： | 研究了锻热淬火工艺对Ｔ１０钢和ＧＣｒ１５钢碳化物技度的影响。结果表明，碳化物粒度随变形量的增大而细化；终锻温度在高于碳化物析出的温度范围内变化，其碳化物粒度都同样细小；终锻温度不宜过低，否则将使碳化物变粗。
|
| 关 键 词： | 锻热淬火，碳化物粒度 |
The Effect of Forge-Quenching Process on the Tool Carbide Size of Steel |
| |
| Wang Xiaopei,Tang Xiaojie, Wang Dengjie.The Effect of Forge-Quenching Process on the Tool Carbide Size of Steel[J].Hot Working Technology,1996(2):21-23. |
| |
| Authors: | Wang Xiaopei Tang Xiaojie Wang Dengjie |
| |
| Affiliation: | Wang Xiaopei;Tang Xiaojie; Wang Dengjie |
| |
| Abstract: | The influences of quenching process with forging heat on the carburet size of steel T10 and GC15 are studied.It is indicated that the size of carburet will be decreased with increased of the formation quantity.If the temperature of foreing finished is higher than tamperature of precipitate carburet,then it can be optional vary,but their carburet is same small in sige,the temperature of foreing completion cannot fall so low that carburet can be precipitated,otherwise the lower temperature will leed to a large size of carburet. |
| |
| Keywords: | frge-quenehing carbide size |
| 本文献已被 CNKI 维普 等数据库收录！ |
