| Abstract: | The technique of linear multiuser detection in DS-CDMA systems is studied in this paper. The purpose is to find a receiver structure with good performance and moderate complexity, so that the receiver can efficiently suppress multiple-access interference(MAI) and multipath interference and has good near-far resistant ability, which may improve the system's capability while reducing the requirement for power control. The main work of the dissertation can be summarized as follows: the performance of MMSE multiuser detector in synchronous/asynchronous DS-CDMA systems over different channels is analyzed in chapter 2 of the dissertation. Using matrix method, we analyze the relation between performance measurement and spreading code correlation matrix, Signal-Interference-Ratio(SIR) and near-far factor, and prove that the performance of MMSE detector is better than that of the decorrelating detector. For fading channel, we analyze the performance of MMSE detector in DS-SS system firstly. Results show that the detector can efficiently suppress multipath interference. Extending to synchronous/asynchronous DS-CDMA systems over fading channels, we propose a simple linear detector structure that accomplishes despreading, detection and combining. Thus, the receiver is easy for implementation. Based on the proposed notion of combined spreading codes, we prove that the synchronous/asynchronous CDMA system is equivalent to the synchronous CDMA system over AWGN channel with double users. Therefore, the MMSE detector can efficiently suppress MAI and multipath interference in steady state, and has good near-far resistant ability. In chapter 3, we study the adaptive algorithm based on MMSE criterion. Firstly, the approach to the blind algorithm based on subspace is analyzed. We improve the algorithm in the part of channel estimation, which decreases the computational complexity while guaranteeing the performance. Meanwhile, we point out that CMOE-RLS algorithm is essentially an algorithm based on subspace approach. Also, it is shown from simulation that PASTd subspace tracking algorithm is not applicable for multiuser detection. Secondly, we propose an adaptive algorithm based on pilot channel, called PCA/PCRA. The algorithm does not require channel estimation, and has a rapid convergence rate. The steady state performance can be achieved by increasing the transmitting power in pilot channel. Computational complexity is only O(N2). Therefore, PCA/PCRA is suitable for the engineering application. The cost is that a pilot channel is needed for each user in the system. In chapter 4, constant algorithms for multiuser detection are studied. Firstly, we analyze the capture performance of CMA, and point out there exist many local stationary points. Initializations to guarantee CMA converges to the desired point are discussed. Results show that the convergence of CMA is decided by constant, step-size, spreading code correlation matrix and near-far factor. Secondly, we propose the constrained constant algorithm (C-CMA) for multiuser detection. It is shown that when the constant is greater than the triple power of the desired user, C-CMA globally converges to the desired point. Simulations illustrate that C-CMA has a rapid convergence rate and the steady state performance is good. However, great step-size can also reult in dispersion for the algorithm. Since C-CMA is a variable step-size CMOE-LMS algorithm, we propose a variable step-size constraint algorithm (VSCA). VSCA has the advantages of both CMOE-LMS and C-CMA such as robust, rapid convergence rate and good steady state performance. Thus, VSCA is suitable for engineering application. But the improper selection of step-size coefficients may degrade performance seriously. The computational complexity of the above constant algorithms is only O(N). In Section 5, the cyclostationarity of spreading signals is analyzed in the first part. We prove that spreading signals are ergodic cyclostationary signals with a cyclic period that is equal to the period of spreading code. Methods for processing cyclostationary signals are then given. It is shown that this method can mitigate the interference from a stationary noise for channel estimation. But the computational complexity for cyclostationary correlation is high, which prevents its application in implementation. In the second part, we discuss the application of oversampling technique in spreading communication systems. Although the oversampling can improve the performance of the linear multiuser detector, the improvement is trivial. On the contrary, oversampling increases the computational complexity of the weight vector greatly, which prevents its application in implementation. Additionally, we prove that FSE plus despreading or despreading pus FSE is equivalent to the linear detector with different lengths of delay line. However, the two kinds of structure have lower computational complexity. |
