| 自由曲面轮廓度误差评定 |
| |
| 引用本文： | 蔺小军,王增强,史耀耀. 自由曲面轮廓度误差评定[J]. 计量学报, 2011, 32(6): 495-500. DOI: 10.3969/j.issn.1000-1158.2011.06.04 |
| |
| 作者姓名： | 蔺小军 王增强 史耀耀 |
| |
| 作者单位： | 西北工业大学现代设计与集成制造技术教育部重点实验室, 陕西 西安 710072 |
| |
| 基金项目： | 国家科技支撑计划整体构件高速高效切削与工艺技术 |
| |
| 摘 要： | 在总结面轮廓度误差评定原则的基础上,提出了曲面轮廓度误差最小条件几何判定准则,即“三角形准则”和“交叉准则”。对曲面轮廓度误差最小条件评定算法进行了研究,首先特征点预定位,再用最小二乘原则粗匹配,最后通过最小条件原则精匹配,实现被测曲面与理论曲面之间的自适应调整。实例证明了几何判定准则的正确性和计算方法的可行性。
|
| 关 键 词： | 计量学 自由曲面 三坐标测量机 面轮廓度误差 最小区域几何判定准则 曲面匹配 |
Evaluation of Profile Error for Free-form Surface |
| |
| LIN Xiao-jun,WANG Zeng-qiang,SHI Yao-yao. Evaluation of Profile Error for Free-form Surface[J]. Acta Metrologica Sinica, 2011, 32(6): 495-500. DOI: 10.3969/j.issn.1000-1158.2011.06.04 |
| |
| Authors: | LIN Xiao-jun WANG Zeng-qiang SHI Yao-yao |
| |
| Affiliation: | The Key Laboratory of Contemporary Design and Integrated Manufacturing Technology, Northwest Polytechnical University, Xian, Shaanxi 710072, China |
| |
| Abstract: | On the basis of summarizing the principle of profile error evaluation,the geometrical evaluation rule of the least condition is proposed for the profile error,which are the “triangle principle” and “cross principle”.The algorithm for evaluating the least condition of the profile error is studied.First,the feature points are pre-positioned,followed by rough matching by least square method and self adaptation between the measured subject and the theoretical surface based on the least condition principle.At last an example is validated the correctness of the geometry rule and feasibility of this algorithm. |
| |
| Keywords: | Metrology Free-form surface Coordinate measuring machine（CMM) Profile Error The geometry rule of the minimum zone principle Surface matching |
| 本文献已被 万方数据 等数据库收录！ |
| 点击此处可从《计量学报》浏览原始摘要信息 |
|
点击此处可从《计量学报》下载全文 |
|
