| 电弧炉冶炼终点碳的控制 |
| |
| 引用本文： | 傅杰,李晶,徐晓达,周德光,王中丙,李绍康. 电弧炉冶炼终点碳的控制[J]. 钢铁, 2001, 36(6): 18-20,43 |
| |
| 作者姓名： | 傅杰 李晶 徐晓达 周德光 王中丙 李绍康 |
| |
| 作者单位： | 1. 北京科技大学
2. 珠江钢铁有限责任公司 |
| |
| 摘 要： | 对电弧炉冶炼过程熔池[C]-[O]反应进行了理论分析，通过现场试验建立了[C]-[O]关系图，试验条件下[O]=0.0032[C]^-0.9441,[C],[Fe]选择氧化的平衡点为[C]＝0．035％。指出在冶炼低碳钢种时，电弧炉终点碳应控制在0．04％以上。
|
| 关 键 词： | 电弧炉 碳 终点控制 炼钢 |
END CARBON CONTROL FOR EAF STEELMAKING |
| |
| FU Jie LI Jing XU Xiaoda ZHOU Deguang. END CARBON CONTROL FOR EAF STEELMAKING[J]. Iron & Steel, 2001, 36(6): 18-20,43 |
| |
| Authors: | FU Jie LI Jing XU Xiaoda ZHOU Deguang |
| |
| Abstract: | The reaction between carbon and oxygen in molten steel during EAF steelmaking has been studied experimentally and the relation between carbon and oxygen has been set up.Under the experimental conditions,[O]=0 0032[C] -0 9441 and equilibrium point for selective oxidation of [C] and [Fe] is [C]=0 035 %. The end carbon should be controlled higher than 0 04 % for low carbon steel melting. |
| |
| Keywords: | EAF carbon end control |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
