| 基于MATLAB/Simulink的燃烧过程控制系统仿真 |
| |
| 引用本文： | 周俊杰,房全国,王定标.基于MATLAB/Simulink的燃烧过程控制系统仿真[J].郑州大学学报(工学版),2012,33(2):51-54. |
| |
| 作者姓名： | 周俊杰 房全国 王定标 |
| |
| 作者单位： | 郑州大学化工与能源学院,河南郑州,450001 |
| |
| 基金项目： | 河南省重大公益性科研项目(081100910100);河南省自然科学研究计划项目(2011A480004) |
| |
| 摘 要： | 通过仿真软件MATLAB/Simulink利用Ziegler-Nichols整定法确定了燃料控制系统、蒸汽压力控制系统、空气流量控制系统的PID控制器的参数,并建立了燃烧过程控制系统的仿真模型.仿真结果表明,在燃料流量、空气流量受chip信号干扰时,系统控制的蒸汽压力最大超调量为0.36%,响应时间为46.5 s,系统的稳定程度和响应速度都比较好.MATLAB/Simulink仿真软件为燃烧过程控制系统的分析、评估研究提供了有效途径.
|
| 关 键 词： | 燃烧过程控制系统 MATLAB/Simulink 系统仿真 |
Simulation of Combustion Process Control System Based on Matlab/Simulink |
| |
| ZHOU Jun-jie
,
FANG Quan-guo
,
WANG Ding-biao.Simulation of Combustion Process Control System Based on Matlab/Simulink[J].Journal of Zhengzhou University: Eng Sci,2012,33(2):51-54. |
| |
| Authors: | ZHOU Jun-jie FANG Quan-guo WANG Ding-biao |
| |
| Affiliation: | (School of Chemical Engineering & Energy,Zhengzhou University,Zhengzhou 450001,China) |
| |
| Abstract: | Through simulation software Matlab/Simulink,this paper gets the PID controller parameters of fuel flow、steam pressure and air flow control system by using the method of Ziegler-Nichols,establishes the simulation model of combustion process control system.Simulation results show that if the fuel flow and air flow are disturbed by chip signal,steam pressure maximum overshoot is 0.36%,and the response time is 46.5 s,stability and response speed of control system are quite good.MATLAB/Simulink software provides an effective way for the analysis and evaluation study of combustion process control system. |
| |
| Keywords: | combustion process control system Matlab/Simulink system simulation |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
