| 高温高盐油藏化学堵水技术 |
| |
| 引用本文： | 李海营,梁涛,刘晓平,秦涛,李冀秋. 高温高盐油藏化学堵水技术[J]. 石油钻采工艺, 2002, 24(5): 50-52. DOI: 10.3969/j.issn.1000-7393.2002.05.016 |
| |
| 作者姓名： | 李海营 梁涛 刘晓平 秦涛 李冀秋 |
| |
| 作者单位： | 1.中原油田公司采油工程技术研究院, 河南濮阳 457001 |
| |
| 摘 要： | 论述了高温高盐油藏化学堵水技术的实验室研究和初期现场试验情况。该技术采用一种新型凝胶型堵剂,主剂为改性阳离子聚丙烯酰胺(CPAM),交联剂为分子中含有杂环的有机胺。实验室研究表明,在最高温度140℃、最高矿化度35×104mg/L的特殊条件下,堵剂成胶固化时间为6~24h,并在此范围内可调,封堵强度达耐压20MPa以上,基本满足中原油田高温高盐油藏化学堵水的要求。该技术在初期现场试验中获得成功,效果较好。
|
| 关 键 词： | 油井 堵水 高温 高矿化度 凝胶 研究 |
| 收稿时间： | 2019-05-23 |
| 修稿时间： | 2001-06-07 |
Chemical Water Plugging in High Tenperature and High Salt Reservior |
| |
| by Li Haiying,Liang Tao,Liu Xiaoping,Qin tao. Chemical Water Plugging in High Tenperature and High Salt Reservior[J]. Oil Drilling & Production Technology, 2002, 24(5): 50-52. DOI: 10.3969/j.issn.1000-7393.2002.05.016 |
| |
| Authors: | by Li Haiying Liang Tao Liu Xiaoping Qin tao |
| |
| Affiliation: | 1.Oil Production Engineering Technology Institute, Zhongyuan Oilfield, Puyang, Henan |
| |
| Abstract: | This article demonstrated study on lab and initial test on site about chemical water plugging in high temperature and high salt reservoir.This technique use a new gel type plugging agent, the main agent is modified CPAM, crosslinker is organic amine.Study on lab shows when the highest temperature is 140℃ and the highest salinity is 35×104mg/L, gel forming and curing time for plugging agent is 6~24h and can be adjusted in this scope, strength of plugging is above 20MPa, which basically meet with requirements of chemical water plugging in high temperature and high salt reservoir in Zhongyuan Oilfield.This technique has get good effect in test on site in initial time. |
| |
| Keywords: | oil well high temperature high salinity gel water plugging study |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
| 点击此处可从《石油钻采工艺》浏览原始摘要信息 |
|
点击此处可从《石油钻采工艺》下载全文 |
|
