| 1.8～2.8GHz低噪音放大器的仿真设计 |
| |
| 引用本文： | 李,凯.1.8～2.8GHz低噪音放大器的仿真设计[J].电子设计工程,2014(8):31-33. |
| |
| 作者姓名： | 李 凯 |
| |
| 作者单位： | 电子科技大学物理电子学院,四川成都610054 |
| |
| 摘 要： | 利用pHEMT工艺设计了一个1.8～2.8GHz波段单片低噪声放大器电路.本设计中采用了具有低噪声、较高关联增益、pHEMT技术设计的ATT-58143晶体管,电路采用二级级联放大的结构形式,用微带电路实现输入输出和级间匹配,通过ADS软件提供的功能模块和优化环境对电路增益、噪声系数、驻波比和稳定系数等特性进行了研究.设计出一个增益大于20dB,噪声系数小于1.5dB,输入输出电压驻波比小于1.9,达到设计要求.
|
| 关 键 词： | 低噪音放大器 负反馈网络 ADS仿真 |
Simulation and design of 1.8～2.8GHz low-noise amplifier |
| |
| LI Kai.Simulation and design of 1.8～2.8GHz low-noise amplifier[J].Electronic Design Engineering,2014(8):31-33. |
| |
| Authors: | LI Kai |
| |
| Affiliation: | LI Kai (Institute of Physical Electronics, UESTC , Chengdu 610054, China) |
| |
| Abstract: | Based on the LNA with excellent performance from 1.8GHz to 2.8GHz band purpose, this design uses a low-noise, high associated gain, PHEMT technology designed ATF-58143 transistor, the circuit is presented with two cascade structureform, microstrip circuit is used to complete the input, output and interstage matching, through the functionality modules and optimizing environment provided by ADS software, the circuit gain, noise figure, VSWR, stability factor and other characteristics are studied, ultimately from 1.8 GHz to 2.8GHz band the LNA gain is greater than 20 dB, the noise is less than 1.5 dB, input and output VSWR is less than 1.9, and all factors meet the design requirements. |
| |
| Keywords: | low-noise amplifier negative feedback network pHEMT ADS simulation and optimization |
| 本文献已被 CNKI 维普 等数据库收录！ |
|
