首页 | 官方网站   微博 | 高级检索  
     

一种基于DSP的GIS局部放电检测仪的实现
引用本文:王自成,田文杰,朱嘉林,李现霞. 一种基于DSP的GIS局部放电检测仪的实现[J]. 现代电力, 2014, 31(4): 84-87
作者姓名:王自成  田文杰  朱嘉林  李现霞
作者单位:1.中国科学院电子学研究所, 北京 100190;
基金项目:国家自然科学基金项目(61172016);北京市自然科学基金项目(4122030)
摘    要:实现了一种基于DSP的GIS局部放电检测仪。采用宽频带的压电薄膜声电传感器将局部放电产生的声信号或超声信号转化为电信号,通过DSP片内高速AD对来自超声传感器的信号进行采样,并对是否抓取到放电信号进行初步智能判断。确认有局部放电发生后,依次显示被抓取的放电信号的波形、幅度和频率。在用户现场测试的结果表明,通过比较多台检测仪的检测结果,可以将局部放电位置定位于GIS设备的两个绝缘环之间。

关 键 词:GIS设备   GIS局部放电   声电传感器   DSP   局部放电检测
收稿时间:2013-10-16

The Realization of Partial Discharge Detector in GIS Based on DSP
Affiliation:1.Institute of Electronics, Chinese Academy of Science, Beijing 100190, China;2.Key Laboratory for Sensor, Beijing Information Science & Technology University, Beijing 100101, China
Abstract:A partial discharge detector in GIS is realized based on DSP. A broad-band piezoelectric thin film acoustic transducer is used to convert the acoustic or ultrasonic signal generated by partial discharge into an electric signal. And the signal from ultransonic transducer is sampled through the on-chip high-speed AD of a DSP, then whether a partial discharge occurs or not can be initially judged. When partial discharge is detected, the wave form, amplitude and frequency of the discharge signal are displayed successively. Field tests show that partial discharge may be located between any two insulation rings of GIS by comparing detecting results of some detectors.
Keywords:
本文献已被 CNKI 等数据库收录!
点击此处可从《现代电力》浏览原始摘要信息
点击此处可从《现代电力》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司    京ICP备09084417号-23

京公网安备 11010802026262号