电测深ρ＿s差值法的应用效果

用电测深研究地电断面、寻找隐伏多金属矿体时，以往采用ρ＿ｓ（或η＿ｓ）等值线断面图进行地质推断解释，因受浅源信号的干扰，效果差。本文提出了采用ρ＿ｓ（或η＿ｓ）差值法，能排除浅源干扰信号，反映出地电断面的相对变化，突出了深部微弱信息，取得了较好的地质解释效果。     

Estimating hydraulic conductivity using grain-size analyses, aquifer tests, and numerical modeling in a riverside alluvial system in South Korea

Hydraulic conductivity (K) for an alluvial system in a riverbank filtration area in Changwon City, South Korea, has been studied using grain-size distribution, pumping and slug tests, and numerical modeling. The alluvial system is composed of layers: upper fine sand, medium sand, lower fine sand, and a highly conductive sand/gravel layer at the base. The geometric mean of K for the sand/gravel layer (9.89?×?10^?4 m s^?1), as determined by grain-size analyses, was 3.33 times greater than the geometric mean obtained from pumping tests (2.97?×?10^?4 m s^?1). The geometric mean of K estimates obtained from slug tests (3.08?×?10^?6 m s^?1) was one to two orders of magnitude lower than that from pumping tests and grain-size analyses. K estimates derived from a numerical model were compared to those derived from the grain-size methods, slug tests and pumping tests in order to determine the degree of deviation from the numerical model. It is considered that the K estimates determined by the slug tests resemble the uppermost part of the alluvial deposit, whereas the K estimates obtained by grain-size analyses and pumping tests are similar to those from the numerical model for the sand/gravel layer of the riverside alluvial system.     

The relationship between zooplankton,conductivity and lake-water ionic composition in 111 lakes from the Interior Plateau of British Columbia,Canada

Zooplankton collected from vertical net tows were related to the environmental variables from 98 lakes from the Interior Plateau of British Columbia. Canonical correspondence analysis showed that both salinity and ionic composition (pH and Mg) of the lake-water made major and significant contributions to the first two ordination axes (=0.42 and 0.11 respectively,P<0.05). BothArtemia franciscana andMoina hutchinsoni had their highest relative abundance in meso-hypersaline waters. However,Artemia franciscana preferred waters that were higher in Mg and Ca, whileMoina hutchinsoni was found in waters that were lower in Mg and Ca. Similarly, at intermediate salinities,Daphnia pulex and the calanoid copepods preferred waters slightly lower in Mg and Ca, whereasCeriodaphnia laticaudata andSimocephalus spp. were relatively more common in waters higher in Mg and Ca. Because the freshest lakes studied varied much less in ionic composition, the zooplankton in these lakes did not show a preference to ionic composition. As expected, multi-generic groups, such as the calanoid copepods, cyclopoid copepods and nauplii, had wider tolerances to conductivity than groups identified to lower taxonomic levels. Significant weighted-averaging regression and calibration models of conductivity were developed based on zooplankton species composition from the study lakes (r ²=0.56,P<0.05). Samples composed largely of multi-generic taxa yielded the worst estimates of salinity in the reconstruction model. This study suggests that zooplankton community composition may be developed into a useful proxy for paleosalinity reconstruction.     

Evaluation of three waterborne polymers as stabilizers for sandy soil

This study reports on waterborne polymer emulsion systems that were used for structural modification of sandy soils. The first emulsion used was a styrene-acrylic, copolymer emulsion; the second and third were vinyl-acrylic, copolymer-based emulsions. Specimens were prepared by adding different polymer emulsions to the sand and water in prescribed amounts. The performance of the different emulsion systems as sand stabilizers was estimated through measurement of the hydraulic conductivity and compressive strength. Measurements of hydraulic conductivity were conducted in a flexible membrane test apparatus. The hydraulic conductivity for the three emulsions decreased at different rates, with an increase in polymer content up to 3 wt. (i.e., % by weight). Additional increase of polymer content did not introduce significant decrease in hydraulic conductivity, and, at 5 wt.%, the three emulsions had essentially the same effect. Measurements made on dry cylindrical specimens disclosed remarkable enhancement in the mechanical behavior of the system. The compressive strength and modulus of elasticity of the examined emulsions increased with a higher concentration of polymer. Scanning electron microscope (SEM) revealed that the reduction in the permeability and the improved mechanical properties can be attributed to three dominant structural changes: the development of interconnecting ties between the sand particles, the development of adhesion between neighboring sand particles in contact, and the covering of the sand particles with a thin polymer film.     

Premelting and calcium mobility in gehlenite (Ca2Al2SiO7) and pseudowollastonite (CaSiO3)

 Premelting effects in gehlenite (Ca₂Al₂SiO₇) have been studied by Raman spectroscopy and calorimetry, and in gehlenite and pseudowollastonite (CaSiO₃) by electrical conductivity. The enthalpy of premelting of gehlenite is 17.3 kJ mol⁻¹ and represents 9% of the reported enthalpy of fusion, which is in the range of the reported fraction of other minerals. The Raman and electrical conductivity experiments at high temperatures, for gehlenite and pseudowollastonite, show that the premelting effects of both compositions are associated with enhanced dynamics of calcium atoms near the melting point. This conclusion agrees with the results obtained for other minerals like diopside, but contrasts with those found for sodium metasilicate in which the weaker bonding of sodium allows the silicate framework to distort near the melting temperature and deform in such a way to prefigure the silicate entities present in the melt. Received: 30 April 2002 / Accepted: 7 August 2002 Acknowledgements We thank Y. Linard for help with DSC measurements and two anonymous reviewers for their constructive comments. This work has been partly supported by the EU Marie-Curie fellowship contract no. HPMF-CT-1999-00329, the CNRS-Carnegie Institution of Washington program PICS no.192, and the NSF grants EAR-9614432 and EAR-9901886 to B.O.M.     

Measuring the k–S–p relations on DNAPLs migration

Migration characteristics of dense non-aqueous phase liquids (DNAPLs) in the subsurface can be expressed as a water–DNAPL two-phase system based on mainly the k–S–p relations, which describe the relations among relative permeability (k), degree of water saturation (S), and capillary pressure head (p). The aims of this research are to develop an experimental system with new type of probes, such as the electrical conductivity probe for measuring the degree of water saturation and the hydrophilic and hydrophobic tensiometer for measuring the pore water and DNAPL pressures, and also to estimate the results obtained from the developed experimental system. From these tests, the excellent k–S–p relations were obtained and the efficiency and validity of this developed experimental system have been confirmed in terms of the concept of the scaling coefficient calculated by interfacial tensions.     

2D stabilised analytic signal method in DC pole-pole potential data interpretation

Using analytic signal method, interpretation of pole-pole secondary electric potentials due to 2D conductive/resistive prisms is presented. The estimated parameters are the location, lateral extent or width and depth to top surface of the prism. Forward modelling is attempted by 2D-Finite Difference method. The proposed stabilised analytic signal algorithm (RES2AS) uses Tikhonov’s regularization scheme and FFT routines. The algorithm is tested on three theoretical examples and field data from the campus of Roorkee University. The stability of RES2AS is also tested on synthetic error prone secondary pole-pole potential data.