激电法找油的原理及应用

激电法是非地震物探手段中的一种，由于油气在向上渗透的过程中会与地层发生一系列的生物。化学反应而形成次生黄铁矿，激电法正是通过发现油气藏上方形成的次生黄铁矿晕来寻找油气的一种间接找油方法。通过详细介绍激电法寻找油气的基本原理。仪器设备等，从实践角度论述了激电法在油田勘探开发中的应用范围及其特点，最后通过兴例说明了其良好的应用效果。     

Observation of atomic steps on CaCO3 crystal surface

By using scanning polarization force microscopy,the deliquescence process and the atomic steps on the cleavage surface of CaCO3 in air were studied in situ.Under an exposure to medium umidity(-57%),the sloiw step movement has been observed.     

可调90°偏振面旋转器

给出一种可调式90°偏振面旋转器。调整复合片快轴的夹角α,便能在可见光范围内使用.     

Characterization of hollow fiber membranes in a permeator using binary gas mixtures

We have studied the CO₂/CH₄ mixed gas permeation through hollow fiber membranes in a permeator. An approach to characterize the true separation performance of hollow fiber membranes for binary gas mixtures was provided based on experiments and simulations. Experiments were carried out to measure the retentate and permeate flow rates and compositions at each outlet. The influences of pressure drop within the hollow fibers, non-ideal gas behavior in the mixture and concentration polarization were taken into consideration in the mathematics model. The calculation results indicate that the net influence of the non-ideal gas behavior, competitive sorption and plasticization yields the calculated CO₂ permeance in a mixed gas permeator close to that obtained in pure gas tests. Whereas the CH₄ permeance is higher in the mixed gas tests than that in the pure gas tests, as the plasticization caused by CO₂ dominates the permeation process. As a result, the CO₂/CH₄ mixed gas selectivity is smaller than those obtained in pure gas tests at equivalent pressures.The calculated membrane performance shows little changes with stage cut if the effect of concentration polarization is accounted for in the calculation. The integration method developed in this study could provide more accurate characterizations of mixed gas permeance of hollow membranes than other estimation methods, as our model considers the roles of non-ideal gas behavior and concentration polarization properly.     

偏振模色散统计特性的研究

利用动态方程研究了偏振模色散矢量的统计特性 ,分别用统计系综和频率系综两种方法进行数值模拟。数值结果表明 ,统计系综和频率系综两种方法的结果一致。在大归一化距离条件下 ,均方根时延的平方随归一化距离线性变化 ;偏振模色散矢量的各个分量服从高斯分布 ,差分群时延服从麦克斯韦分布 ;偏振模色散矢量弥散于整个邦加球     

环境因素对碳钢点蚀临界电势的影响

采用动电势扫描法测定了不同体系中碳钢发生点蚀的临界电势Eb。结果表明 :当Cl- 浓度 <0 .0 1mol/L时 ,随Cl- 浓度增加 ,临界电势负移并与Cl- 浓度成线性关系 ;pH值在 7～ 11之间 ,随pH值增加 ,临界电势正移并与pH值成线性关系 ;随温度增加 ,临界电势负移并与温度成线性关系。     

新型可调剪切差平行分束偏光器设计

本文给出了一种新型可调的切差平行分束偏光器设计。它调节方便,可获得较大平行分束剪切差,并可一镜多用     

汉白玉废料制备球形纳米碳酸钙的研究

将汉白玉废料通过高温煅烧分解得到氧化钙,再用氯化铵循环液溶解氧化钙制得碱性氯化钙溶液,除去其中的Mg、Fe等杂质得到氯化钙精制溶液,利用化学方法合成得到碳酸钙粉体.用X射线衍射(XRD)、扫描电镜(SEM)及激光粒度分析仪、白度仪对碳酸钙产品的晶相组成、形貌、粒度分布、白度及化学组成进行了分析,所得产品为纯度达98.5%以上、白度达97%以上、平均粒度为80nm左右的球形纳米级碳酸钙.并对碳化反应速率及合成球形纳米碳酸钙的影响因素进行了分析.实验中循环使用NH4Cl,氨的排放量小,减少了环境污染.     

Studies on the corrosion behavior of cerium-implanted zircaloy-4 with GAXRD

In order to study the influence of cerium ion implantation on the aqueous corrosion behavior of zircaloy-4, specimens were implanted by cerium ions with a fluence range from 1×10¹⁶ to 1×10¹⁷ ions/cm² at maximum 150°C, using MEVVA source at an extracted voltage of 40 kV. The valence and elements penetration distribution of the surface layer were analyzed by X-ray photoelectron spectroscopy (XPS) and auger electron spectroscopy (AES) respectively. Glancing angle X-ray diffraction (GAXRD) was employed to examine the phase transformation due to the cerium ion implantation in the oxide films. Three-sweep potentiodynamic polarization measurement was employed to value the aqueous corrosion resistance of zircaloy-4 in a 1 N H₂SO₄ solution. It was found that a significant improvement in the aqueous corrosion behavior of zircaloy-4 implanted with cerium ions compared with that of the as-received zircaloy-4. The improvement effect will declined with raising the implantation fluence. The bigger is the fluence, the less is the improvement. Finally, the mechanism of the corrosion behavior of the cerium-implanted zircaloy-4 is discussed.     

Stress Concentration Factors for a Circular Hole in Curved Beams Under Bending Loads

Abstract: As a contribution to the field of stress concentration studies, the case of circular hole in curved bar elements under bending is hereby studied. Trend values of stress concentration factors (SCF) are presented based on selected variables of the problem for two critical hole locations. The results will help to identify an SCF law for practical use by applying the statistical method of regression analysis. Two approximations obtained by means of computational methods are compared with those obtained by photoelastic experimental method.