无油分子泵机组的组装

介绍了将ALCATEL公司生产的一台ATPl00涡轮分子泵、一台MDP50ll牵引分子泵及一台VRC公司生产的lBy6型干泵组装成无油分子泵机组的过程。文中给出了泵间配合的计算、机组方案的设计、连接管路、仪器支架的设计及选择。本机组所采取的设计方案使三个泵都最大限度地发挥了优点避免了缺陷，较好地满足了使用要求，为今后选购单泵和组装无油分子泵机组提供了可靠的理论和实验依据。     

提高集聚纺纱效率的可行性研究

本文主要讨论了精梳工序和普梳工序对集聚纺纱线质量和加工效率影响的测试结果。     

控制图在土坝粘土填筑干密度控制中的应用

应用统计控制图法，选用平均值——标准差、平均值——极差控制图法，控制24^#坝粘土填筑干密度值及施工偶然异常波动，早期提出警报，以保证土坝的施工质量。     

Influence of Edible Films upon the Moisture Loss and Microstructure of Dietetic Sucrose-Free Sponge Cakes during Storage

The kinetics of changes in the bound water content in dietetic sucrose-free sponge cakes (DC) during storage was investigated. The effect of edible films of polymyxan, pectin, xanthan, and carboxymethylcellulose upon this kinetics was also investigated. The quantitative changes in both states of water (slightly bound water and strongly bound water) were registered by combined dynamic analysis (thermogravimetry analysis, TGA, and differential thermal analysis, DTA). The moisture changes in DC crumb were analyzed by drying out to constant mass. The rate constants were determined according the equation q = q_oe^-kt. The values of rate constants 'k', in day^-1, concerning the different edible films were as follows: for crumb moisture is (8.00 ≤ k ≤ 12.47) × 10^-3, for bound water is (3.07 ≤ k_w ≤ 6.26) × 10^-2, for slightly bound water is (4.22 ≤ k₁ ≤ 8.49) × 10^-2 and for strongly bound water is (2.02 ≤ k₂ ≤ 5.62) × 10^-2 as compared to 18.53 × 10^-3, 7.16 × 10^-2, 9.04 × 10^-2, and 5.36 × 10^-2 in the uncovered DC, respectively. The best water-retaining effect in respect to crumb moisture during storage was ascertained in the use of polymyxan and xanthan films. The lowest rate constant values for bound water and its two states were measured for DC covered with pectin. The relation between the kinetics of both bound water states during storage and ageing of the crumb of DC covered with different edible films and the crumb microstructure was represented. By means of scanning electron microscope was read the smallest change in crumb microstructure of pectin-covered DC on the sixth day of storage.     

环锭细纱机减少成纱毛羽的对策

通过对环锭细纱机成纱毛羽的成因分析 ,提出减少成纱毛羽的措施。     

轴向进给比对薄壁管滚珠旋压影响的有限元分析

通过有限元数值模拟方法得出滚珠旋压中薄壁管在不同凹模旋转速度条件下轴向进给比的变化规律及工件的成形规律,并对模拟结果的等效应变分布做了分析,并与实验结果进行比较,给出薄壁管滚珠旋压时进给比的选取范围.结果表明,进给比对滚珠旋压中薄壁管直径的胀缩和工件的质量有着显著的影响.另外,从计算的模具所受的三向载荷变化情况分析了模具的使用寿命.     

提高摩托车用干荷电电池综合性能的研究

通过改进铅膏的配方及极板的独特处理工艺 ,提高了干电荷电摩托车电池的低温高率放电性能、充电接受能力和储存性能 ,完全可以满足国内外摩托车主机厂的各种要求。     

不同施钾水平对玉米干物质及产量的影响

生物产量是提高经济产量的基础,而施肥是调控生物产量及其组分动态转化的重要手段。本研究通过不同施钾水平对玉米干物质积累动态变化的影响分析,确定出钾肥合理用量,为玉米高产高效栽培提供理论依据。     

横泉水库旧坝体及黄土台地强夯处理实践

山西省横泉水库在原有遗留工程基础上进行重新建设，以往的4次施工，填兢了长400m、高17m左右的左岸坝体，填土约120万m^3，但坝体填筑质量极差，干客重和渗透系数根本无法满足设计要求。此次重新建设，决定对这部分干客重不迭设计要求且具有湿陷性的左岸旧坝体以及左岸黄土台地进行强夯处理，对坝体进行强夯处理在省内还是首次进行，在国内也比较少见，通过处理，坝体质量达到了设计要求，并且节约了投资，效果明显。