Synthesis,Electronic Properties and WOLED Devices of Planar Phosphorus‐Containing Polycyclic Aromatic Hydrocarbons

We describe the synthesis and the physical properties of polyaromatic hydrocarbons (PAHs) containing a phosphorus atom at the edge. In particular, the impact of the successive addition of aromatic rings on the electronic properties was investigated by experimental (UV/Vis absorption, fluorescence, cyclic voltammetry) and theoretical studies (DFT). The physical properties recorded in solution and in the solid state showed that the P‐containing PAHs exhibit properties expected for an emitter in white organic light‐emitting diodes (WOLEDs).     

Imprint lithography of pyramidal photonic pillars using hydrazine etching

An inexpensive method to produce a pyramidal-type 2D photonic structures in the silicon substrate was proposed. The method is based on the combination of imprint lithography and wet Si1 0 0 etching in water solution of hydrazine, which etches 1 1 1 faces much more slowly than others. Thermally grown SiO₂ mask for the hydrazine etching was used, because single Al mask cannot be well bonded to the substrate and tends to peel during the etching. It was revealed that transmittance in the infrared spectrum region of the patterned silicon decreases by about five times compared with that of flat silicon substrate and this decrease is almost independent of the angle of the incident beam. In the infrared region, decrease of transmittance of the patterned samples is directly proportional to the wave number. The shape of formed pyramids has strong influence on the transmittance. Decrease of the transmittance is much more rapid and larger in the case of sharpless pillars.     

Dark cure studies of cationic photopolymerizations of epoxides: Characterization of kinetic rate constants at high conversions

The effective propagation rate constant (k_p; averaged over all the propagating active centers) was characterized for solvent‐free cationic photopolymerizations of phenyl glycidyl ether over the entire range of conversions, including the high conversion regime in which mass transfer limitations become important. The profile for the k_p as a function of conversion was found to exhibit a constant plateau value at low to intermediate conversions, followed by a monotonic increase above a threshold value of conversion. To explain this trend, it is proposed that at high conversion the diffusional mobility of the photoinitiator counterion is reduced whereas the mobility of the cationic active center remains high because of reactive diffusion. Therefore, with increasing conversion, the average distance between the active centers and counterions may increase, resulting in an increase in the propagation rate constant. The profiles for the k_p values were investigated as a function of the temperature, photoinitiator anion, and photoinitiator concentration. As the photoinitiator concentration was increased, the plateau value of the effective propagation rate constant decreased whereas the threshold conversion increased. All of the experimental trends are consistent with the proposed increase in ion separation at high conversions. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 4409–4416, 2004     

Decay distribution of spontaneous emission from atoms in one-dimensional photonic crystal

Spontaneous emission behavior from atoms (or molecules) in one-dimensional photonic crystal with a defect is investigated. Taken all the TE and TM modes into account, the normalized spontaneous emission rate of the atom is calculated as a function of the position of the atom in the crystal. Results for both nonabsorbing dielectric structure and absorbing dielectric structure are presented. With the increase of the thickness of the defect in which the atoms are embedded, the oscillations of the spontaneous emission rate versus the position of the atom become dense and the lifetime distribution becomes narrow and sharp. The PC effect may lead to the coexistence of both accelerated and inhibited decay processes.     

Laser nanosources based on planar photonic crystals as new platforms for nanophotonic devices

Two-dimensional photonic crystal lasers have been fabricated on III–V semiconductor slabs. Tuning of the spontaneous emission in micro and nanocavities has been achieved by accurate control of the slab thickness. Different structures, some of them of new application to photonic crystal lasers, have been fabricated like the Suzuki-phase or the coupled-cavity ring-like resonators. Laser emission has been obtained by pulsed optical pumping. Optical characterization of the lasing modes have been performed showing one or more laser peaks centred around 1.55 μm. Far field characterization of the emission pattern has been realized showing different patterns depending on the geometrical shape of the structures. These kinds of devices may be used as efficient nanolaser sources for optical communications or optical sensors.     

Comparison of detection efficiencies of negatively charged gold-alkanethiolate-, gold-sulfur- and gold-clusters in ToF-SIMS

In order to improve quantification of high mass ions, the influence of cluster composition on detection efficiencies has been studied using a TOF-SIMS IV with the extended capability of postaccelerating ions up to 20 keV. In this experimental study, we focus on the comparison of detection efficiencies for three types of negatively charged secondary cluster ions: gold-alkanethiolate-clusters (Au_xM_y), gold-sulfur-clusters (Au_xS_y) and gold-clusters (Au_x). The clusters were sputtered from self-assembled monolayers of hexadecanethiols on gold substrates using 10 keV Ar⁺ primary ions. The detection efficiencies were derived on the basis of a function for the secondary electron yield and a fourth-order approximated Poisson probability distribution for electron propagation and amplification within the microchannel plate.In addition to the well-known dependence of detection efficiencies on ion mass and energy, which has already been studied for positively charged ions, we were able to show a similar behaviour for the investigated negatively charged secondary ions. We have observed major variations among the three types of clusters at similar mass and energy as predicted in a theoretical approach. The observed differences are due to the different composition of the investigated clusters which has a major influence on the kinetic ion induced electron emission within the microchannel plate. For the first time it was possible to experimentally verify these predictions for detection efficiencies.     

Interference of circularly polarized light: contrast and application in fabrication of three-dimensional periodic microstructures

The contrast of interference pattern formed by two circularly polarized waves and by a linearly polarized wave and a circularly polarized one is discussed. The results are compared with that by two linear beams. It shows that the use of circular light in holographic fabrication of three-dimensional periodic microstructures may remove the necessity of beam ratio and polarization optimization needed in the interference of three linear noncoplanar beams and improve the uniform contrast of resultant pattern simultaneously.     

Amorphous Fe–Mg alloy thin films: magnetic properties and atomic vibrational dynamics

Amorphous (a-) Fe _x Mg_1?x alloys are interesting materials for the investigation of non-Debye-like low-energy vibrational excitations. We have prepared a-Fe _x Mg_1?x alloy thin films (0.3 ≤ × ≤0.7) by vapour quenching. The amorphous state was confirmed by conversion electron Mössbauer spectroscopy between 4.2–300 K, and the x- and temperature-dependence of the isomer shift and hyperfine magnetic field was measured. For x= 0.6 and 0.7, magnetic ordering occurs below ~150 K. The atomic vibrational density of states, g(E), was determined by nuclear resonant inelastic scattering, providing clear evidence for the non-Debye-like low-energy vibrational excitations.     

Enhancement of Overall Photovoltaic Efficiency by Changing the Position of the Attaching Group -RSO3- on the Hemicyanine Dye Molecules

A new photoresponsive D-π-A dye, mPS, has been designed and synthesized.Compared to the parent dye PS, IPCE values in the region from 400 nm to 560 nm was greatly improved upon changing the attaching group from the p- position to the o- position of the π-conjugation bridge. A solar cell based on mPS generated a remarkably high overall yield η of 5.4% under irradiation of 80.0 mW cm^-2 white light from a Xe lamp, Compared with PS, the overall yield η increased by 64%.     

IPv4/IPv6翻译网关的研究

In this paper, a model of translation gateway is proposed. The communications between IPv4 network and IPv6 network are realized by using the Microsoft intermediate driver technology in environment of Windows 2000.