构建媒体网络信息安全体系

通过对广州市电视台综合信息平台网络系统的应用现状及安全风险进行分析,提出基于网络层、系统层、用户层和安全策略管理全方位的网络信息安全体系.     

减压渣油与FCC油浆共炭化的化学组成变化

考察了齐鲁石化胜利炼油厂催化油浆（FCC）和胜利减压渣油（VR）在490℃，0.8MPa下不同混合比的原料和不同反应时间的中间产物的HS、TS、PS、P及其1h中间产物的HS和TS的^1H-NMR。数据结果反映了体系的反应速度。掺入FCC油浆抑制了VR的反应活性，降低了体系的反应速度，增加了基质的溶解度；1h中间产物的组成结构更接近于原料及反应体系的反应性和基质的溶解度；1h中间产物的芳香度越高，取代基越少，侧链越短，基质对VR中的活性反应组分在炭化早期生成的高度缩合物质的溶解度越大。     

吸入短寿命氡子体动物肺组织剂量与体重关系的探讨

本文介绍吸入短寿命氡子体的不同种动物肺组织吸收剂量与体重的关系。实验结果表明,吸收剂量随体重的增加而减小。     

Bright Blue Light—emitting Diodes Based on a Novel Fluorescent Dye Containing Heterocyclic Groups

Novel molecular material ,1-benzothiazoly-3-pheny1-pyrazoline (BTPP) was found to function as bright blue light emitting dye in organic electroluminescent device, and its optical and electric characteristics were investigated. This heterovyclic compound exhibited good characteristics of blue photoluminescence and electroluminescence,which had the emission peak at 450nm .The single layer light-emitting devices using BTPP as light -emitting material dispersed in poly(N-vinylcarbazole)(PVK) and double layer ones using PBD as hole block layer above the light-emitting layer were fabricated using conventional spin-casting and vaccum vapour deposition methods. The introduction of PBD has enhanced electron injection and luminance efficiency, compared with the single layer LEDs.     

Electronic and optical analysis of high-efficiency photovoltaic materials based on a GaN semiconductor

An ab initio study using the local spin density approximation of the electronic and optical properties of materials where Cr transition metal substitutes for N in the GaN host semiconductor with an atomic concentration of 1.56% is presented. This material, characterized by an isolated and partially filled intermediate band, is a candidate for high-efficiency solar cells. The atomic and orbital composition of this band has been analyzed showing that is mainly made up of a t-group orbital of the transition metal. The absorption coefficient theoretical results show a sub-gap absorption with respect to the host semiconductor which could lead to an increase in solar conversion efficiency.     

Epitaxial growth of GaN on (0001) Al<Subscript>2</Subscript>O<Subscript>3</Subscript> via solution-cast seed layer formation process using Ga(mDTC)<Subscript>3</Subscript>

This paper reports an alternative method for the growth of GaN epitaxial layer on (0001) Al₂O₃ substrate by hot-wall vapor phase epitaxy technique. Tris (N,N-dimethyldithiocarbamato)-gallium (III), Ga(mDTC)₃ was introduced as a precursor material for the seed layer formation in the growth of GaN. Optimal growth conditions with seed layers formed by the Ga(mDTC)₃ concentration of 0.047 mol/L were identified: Growth temperature was found to be 850 °C, and optimal distance between the reactant outlet and substrate was determined to be 12.5 cm. Characterization results showed that this growth method produce high-crystallinity GaN epitaxial layers at a relatively lower growth temperature compared to the existing growth techniques and simplify the growth process.     

Pollutant dispersion over two-dimensional hilly terrain

Numerical prediction of the wind flow and pollutant dispersion over two-dimensional hilly terrain is presented. The wind tunnel experiments are conducted to validate the numerical results of the flow field. Measured mean velocity profiles, turbulence characteristics, and surface pressure distributions show good agreement with the numerical predictions. The hypothesis of Reynolds number independency for an atmospheric boundary layer flow over aerodynamically rough terrain is numerically confirmed. The linear theory provides generally good prediction of speed-up characteristics for gently sloped low hills. The effect of two-dimensional double hills on the dispersion of pollutants from continuously or temporally released line source of different emission heights and locations is also investigated. The ground-level concentrations are considerably reduced as emission heights are increased. The variances of ground-level concentration with respect to time from a temporally released source are strongly influenced by the flow separation.     

支持产品协同设计的AD技术与服务层项目人员管理的实现

在产品的协同设计过程中，每个项目都要涉及到众多的工作人员和大量的网络资源。协调好各个人员的工作并且有效、安全地使用网络资源是保证产品设计顺利进行的关键。本文提出并研究了采用活动目录技术来实现协同设计系统的服务层上的项目人员管理需求模式，开发了相应的项目人员管理工具，并且在基于知识的注塑模具和冲压模具设计系统中得到应用。     

硅烷交联型复合半导电塑料

对于硅烷交联型复合半导电塑料的研究表明，合理的选择EVA，炭黑，交联剂，引发剂，催化剂的种类和适宜的用量，仅仅是提高接枝和凝胶质量分散的必要条件，体系环境的酸碱度才是可以交联的充分条件，只有在体系的环境呈现出中性或弱的碱性时，硅烷才可能与PE和EVA充分接枝和交联。