Bandpass filters using periodically loaded combline resonators

A novel combline filter is proposed for cellular‐radio base stations. The Q‐factor is significantly improved. The eigenvalue equation is expressed with the single‐team approximation in the gap region of the combline resonator. A two‐pole combline filter is designed. The calculation, simulation, and experiment results are presented and are in good agreement. © 2005 Wiley Periodicals, Inc. Int J RF and Microwave CAE, 2006.     

Analysis of the Datagram Congestion Control Protocol’s connection management procedures using the sweep-line method

State space explosion is a key problem in the analysis of finite state systems. The sweep-line method is a state exploration method which uses a notion of progress to allow states to be deleted from memory when they are no longer required. This reduces the peak number of states that need to be stored, while still exploring the full state space. The technique shows promise but has never achieved reductions greater than about a factor of 10 in the number of states stored in memory for industrially relevant examples. This paper discusses sweep-line analysis of the connection management procedures of a new Internet standard, the Datagram Congestion Control Protocol (DCCP). As the intuitive approaches to sweep-line analysis are not effective, we introduce new variables to track progress. This creates further state explosion. However, when used with the sweep-line, the peak number of states is reduced by over two orders of magnitude compared with the original. Importantly, this allows DCCP to be analysed for larger parameter values. Somsak Vanit-Anunchai was partially supported by an Australian Research Council Discovery Grant (DP0559927) and Suranaree University of Technology. Guy Edward Gallasch was supported by an Australian Research Council Discovery Grant (DP0559927).     

对一起氮压机燃爆事故的原因分析

SVK8 3S型氮气压缩机是由沈阳鼓风机厂制造、为义马煤气配套的低压氮气压缩机 ,共两套 ,于 2 0 0 0年 1 2月开始调试。为节约工程基建资金 ,取消原设计两台中压氮气压缩机 ,由杭氧产两台3TYS89+2TYS60型氧气透平压缩机临时压送氮气 ,向外供中压氮 ,来取代中压氮气压缩机 ,流程示意图如图 1所示。图 1　氧、氮压机工艺流程配置图1　事故情况2 0 0 0年 1 2月 2 7日中午 1 1∶3 5 ,接总调度室通知 ,要求中午 1 2∶0 0向长输管线供中压氮气。当时 ,一台氮压机试车完毕正在运行 ,一台氧压机试车完毕压氧正在运行 ,将由氧压机临时压送氮气外供…     

气流式加速度传感器的敏感机理

介绍了在研制气流式加速度传感器过程中，为对气流式加速度传感器进行建模，作者对气流式加速度传感器的工作机理进行了理论性探讨。在分析过程中以流体力学、传热学和惯性理论为基础并结合实验结果，建立了适合于气流式加速度传感器的气体运动方程和能量方程。同时还讨论了热线测量加速度的方法及根据实验分析了输入加速度对腔体内温度及传感器输出电压的影响，从而为进一步研究一系列气流式传感器的工作机理提供了方法。     

长25-29井卡钻事故的处理

长２５－２９井在完井阶段通井过程中发生粘附卡钻事故，在处理卡钻过程中又发生卡套铣筒、井漏、溢流等事故及复杂情况。通过对井下情况的认真分析，采取先堵漏后循环再解卡的处理方案，顺利地解除了该次卡钻事故，大大地减少了经济损失。     

In the theory of blast waves

The behavior of the blast wave from an exploding spherical volume is investigated mathematically over the entire range of blast-wave propagation. The computational method uses analytical results for a similar problem for a point explosion with counter pressure and the theory of an asymptotically equivalent point explosion. The asymptotic solution of the gas-dynamic equations away from the explosion site is matched to the initial conditions of blast-wave formation due to the disintegration of the detonation shock upon its arrival at the boundary of the exploding volume. The spatial distribution of the blast-front pressure is found for combustible gaseous systems and solid explosives. The theoretical results obtained agree quantitatively with available experimental measurements. __________ Translated from Fizika Goreniya i Vzryva, Vol. 42, No. 4, pp. 93–99, July–August, 2006.     

深孔预裂爆破在溢洪道高边坡开挖的应用

高边坡深孔预裂爆破是一项对施工质量、安全要求极高的爆破技术, 必须进行科学的爆破技术设计,确定合理的爆破参数;高度重视爆破钻孔工艺、装药工艺、网络工艺以及边坡稳定性地质分析.在洞巴水电站中不允许采用超欠平衡的开挖方法进行施工,利用设计台阶高度,采用深孔预裂爆破对溢洪道高边坡的稳定及开挖平整度进行有效控制,取得良好效果.     

油库防爆电气设备运行安全管理注意事项

分析了油库防爆电气设备运行中安全管理应注意的几个事项。     

光通信用垂直腔面发射激光器的进展

垂直腔面发射激光器(VCSEL)以其优异的性能有望成为信息时代的新光源.文章介绍了用于光通信的VCSEL的开发现状.     

传输线衰减常数与柱形谐振器Q值的关系

文中严格地讨论了任意截面形状，任意模式的柱形谐振腔Ｑ值与构成该谐振器的传输线衰减常数间的关系，给出了更一般的公式，推广了Ｄａｖｉｄｓｏｎ和Ｓｉｍ－ｍｏｎｄｓ＾［１］、Ｂａｒｌｏｗ和Ｃｕｌｌｅｎ＾［２］以及Ｙｅｈ和Ｓｈｉｍａｂｕｋｕｒｏ＾［３，４］的结果。