HART通信协议在汽油机速度测量和监控方面的应用

首先介绍了HART通信协议及他的优点，然后介绍了HART通信协议在汽油机测速方面的软件实现。该软件主要采用目前流行的VB编程语言。可设计出界面友好、功能强大的测量和监控软件。     

Mass Transfer in a Flat Gas/Liquid Interface using non‐Newtonian Media

Gas/liquid mass transfer has been investigated using a stirred vessel gas/liquid contactor using non‐Newtonian media and carbon dioxide as absorbent and gas phase, respectively. The volumetric mass transfer coefficients at different operational variables have been determined. Non‐Newtonian media (liquid phase) were prepared as aqueous solutions of sodium carboxymethyl cellulose salt. The influence of the rheological properties, polymer concentration, stirring rate, and gas flow rate on mass transfer was studied for these liquid phases. Kinematic viscosity and density experimental data were used to calculate the average molecular weight corresponding to the polymer employed. The Ostwald model has been used to fit the rheological behavior of aqueous solutions of the polymer employed as absorbent phase. Reasonably good agreement was found between the predictions of the proposed models and the experimental data of mass transfer coefficients.     

优化设计 确保干式气柜安全运行

稀油密封干式气柜普遍应用于钢铁企业储存煤气,而用于炼油厂储存瓦斯气也仅仅是近些年出现的现象,由于干式气柜自身特点所限,一些炼油企业在使用过程中出现一些问题,导致气柜不能安全、有效运行,重点介绍克拉玛依石化公司在干式气柜运用方面的一些经验和体会,希望给有关设计和生产单位提供参考。     

小块气藏早期动态特征综合评价

应用试井方法，提出一套比较切合实际的小块气藏动态特征综合评价方法，推导出水驱气藏水侵量的计算公式，编制了天然气高压物性参数计算和气藏稳产年限预测等程序软件。     

新一代厂站计算机监控系统软件的研制

本介绍一种新的基于开放系统环境的计算机监控系统软件的开发研究及其设计目标、实现方法及应用情况。     

A new monitoring system for piping systems in fossil fired power plants

A CEC-funded project has been performed to tackle the problem of producing an advanced Life Monitoring System (LMS) which would calculate the creep and fatigue damage experienced by high temperature pipework components. Four areas were identified where existing Life Monitoring System technology could be improved:

1. 1. the inclusion of creep relaxation

2. 2. the inclusion of external loads on components

3. 3. a more accurate method of calculating thermal stresses due to temperature transients

4. 4. the inclusion of high cycle fatigue terms.

The creep relaxation problem was solved using stress reduction factors in an analytical in-elastic stress calculation. The stress reduction factors were produced for a number of common geometries and materials by means of non-linear finite element analysis. External loads were catered for by producing influence coefficients from in-elastic analysis of the particular piping system and using them to calculate bending moments at critical positions on the pipework from load and displacement measurements made at the convenient points at the pipework. The thermal stress problem was solved by producing a completely new solution based on Green's Function and Fast Fourier transforms. This allowed the thermal stress in a complex component to be calculated from simple non-intrusive thermocouple measurements made on the outside of the component. The high-cycle fatigue problem was dealt with precalculating the fatigue damage associated with standard transients and adding this damage to cumulative total when a transient occurred.

The site testing provided good practical experience and showed up problems which would not otherwise have been detected.     

Water-Quality Monitoring in Anguilla

Anguilla is a UK overseas (non-independent) territory in the Caribbean. It is a small middle-income island with a population of 13 000, and recent statistics indicate that it is more dependent on tourism than any other country or territory in the world. Rapid population growth and development have placed more emphasis on the need for human health and environmental protection. For the first time, a systematic water-quality monitoring programme has been developed, based on the realities of the local situation, e.g. low resource base, limited capabilities, dependence on household rainwater catchment, storage cisterns, and a poor water-supply network. Development of the programme incorporated the key themes of pragmatic, realistic, incremental, responsive, and consultative approaches.     

大坝安全监控专家系统中的知识处理

在介绍产生式规则及其数学模型的基础上，论述了用成熟的关系数据库 技术来表示和存储产生式规则表示的专家知识的方法，较好地解决了知识的存储和管理问题 。同时，利用关系数据库中实体间的关系，很容易将分散存储的规则元素组合成规则供推理 时使用。在分析了大坝安全监控专家系统知识特点的基础上举例说明了用关系数据库表 示产生式规则的具体方法。     

半导体芯片厂有害气体检测器使用经验之探讨

本文除概略介绍气体检测器的种类处，主要对气体检测器的原理和在实际使用中的局限性作一基本归纳叙述。限于篇幅，本文将论述的重点放在气体检测器的选用与设置规划上，提出个人的一点心得与看法，以作为未来设置气体检测器系统时之参考。